Question is ⇒ If Z(<i>s</i>) has a pole at origin, the realization leads to, Options are ⇒ (A) a resistance in series, (B) an inductance in series, (C) a capacitance in series, (D) a resistance or capacitance in series, (E) , Leave your comments or Download question paper.

Question is ⇒ If Z(<i>s</i>) has a pole at origin, the realization leads to, Options are ⇒ (A) a resistance in series, (B) an inductance in series, (C) a capacitance in series, (D) a resistance or capacitance in series, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If Z(s) has a pole at origin, the realization leads to
A.	a resistance in series [Wrong Answer]
B.	an inductance in series [Wrong Answer]
C.	a capacitance in series [Correct Answer]
D.	a resistance or capacitance in series [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following has the highest input impedance?
CE
CB
CC
Push pull

⇒ Consider the following statements Timer 555 can be used as

monostable multivibrator
bistable multivibrator
astable multivibrator

Which of the above statements are correct?
1 and 2
1 and 3
2 and 3
1, 2, 3

⇒ In TV system in India IF video and IF audio frequencies are
33.4 and 28.4 MHz respectively
38.9 and 33.4 MHz respectively
43.8 and 38.9 MHz respectively
33.4 and 38.9 MHz respectively

⇒ For a 50 Ω resistor for 3 GHz application, the stray capacitance should be less than
1 μF
1 nF
1 pF
0.1 pF

⇒ MS Access is a DBMS software.
TRUE
FALSE

⇒ With regard to a transmission line, which of the following statements is correct?
Any impedance repeats itself every 1/4 on the Smith chart.
The S.W.R. = 2 circle and the magnitude of reflection coefficient = 0.5 circle coincide on the Smith chart.
At any point on a transmission line, the current reflection coefficient is the reciprocal of the voltage reflection coefficient.
Matching eliminates the reflected wave between the source and the matching device location.

⇒ The properties of JFET resemble those of
thermionic values
N-P-N transistors
P-N-P transistors
unijunction transistor

⇒ High cut off frequency can be expected in case of
common-base
common-emitter
common-collector
all of the above

⇒ The intermediate frequencies in VCR are
video 38.9 MHz and audio 33.4 MHz
38.9 MHz for both video and audio
33.4 MHz for both video and audio
33.4 MHz for video and 38.9 MHz for audio

⇒ In Bode analysis the correction at corner frequency is 3 dB.
TRUE
FALSE

⇒ Fleming's left hand rule is used to find
direction of force on a current carrying conductor
direction of flux in solenoid
direction of magnetic field due to a current carrying conductor
direction of induced emf

⇒ A current increasing at the rate of 1 A/s is passed through 1 F capacitor. At t = 0, i = 0. The charge stored after 1 second is
0.5 C
1 C
2 C
4 C

⇒ In the basic series inverter circuit, the source current has
low harmonic content
high harmonic content
low or high harmonic content depending on firing angle
zero harmonic content

⇒ The critical frequency of 'F' layer is greater than 30 MHz.
TRUE
FALSE

⇒ Impedance inversion may be obtained with
half wave line
a short circuited stub
complex impedance Z connected in series with line
quarter wave line

⇒ In a stop-and-wait ARQ system, the transmitting terminal
waits for positive or negative acknowled-gement from the receiving terminal after sending a block
sends another block if positive acknowledge is received through ACK character
resends the previous block if negative acknowledgement is received through a NAK character
does not wait for acknowledgement after sending a block

⇒ In n channel JFET
I_D and V_DS are positive but V_GS is negative
I_D and V_GS are positive but V_DS is negative
V_DS and V_GS are positive but I_D is negative
I_D, V_DS and V_GS are all positive

⇒ In 8086 the flag which enables or disables external interrupts is
IF
DF
TF
CF

⇒ If A = 629 ± 8 and B = 131 ± 3, A - B with range of doubt is
498 ± 8
498 ± 4
498 ± 11
498 ± 13

⇒ The transistor of following figure in Si diode with a base current of 40 μA and I_CBO = 0, if V_BB = 6V, R_E = 2 kΩ and β = 90, I_BQ = 20 μA then R_{B200 kΩ
265 kΩ
150 kΩ
100 kΩ}

⇒ The organisatioion of Intel memory chip 127256 is
32 K x 8
16 K x 8
32 K x 4
16 K x 4

⇒ An impulse function consist of
pure dc
pure a.c
entire frequency range with constant phase
infinite bandwidth with linear phase vaariations

⇒ TE₀₁ mode of propagation of electromagnetic energy
is merely the TE₁₀ mode rotated 90°
is merely the TE₁₀ mode rotated 180°
is the same as TE₁₀ mode
either (b) or (c)

⇒ The seven segment display used in watches and clocks generally uses
LED
LCD
Photodiode
FET

⇒ In single phase half wave regulator, the average current over one full cycle
is always positive
may be positive or negative
may be negative
is always negative

⇒ In disc mounting of SCR
SCR is clamped on one side of disc shaped heat sink
SCR is clamped between two disc shaped heat sinks
The SCR has low current rating
None of the above

⇒

Assertion (A): A high density IC has more diodes, transistors and resistors per unit surface area.

Reason (R): A high density IC can handle high voltages.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A λ/4 long high frequency transmission line is terminated into one impedance Z_R. If Z₀ be the characteristic impedance of the line, then input impedance Z_in is
Z_oZ_R
Z²_R/Z_o
Z²₀/Z_R
Infinity

⇒ If all the LEDs in a seven segment display are turned on, the number displayed is
1
3
0
8

⇒ A phasor is
a line representing the magnitude and direction of an alternating quantity
a line which represents the magnitude and phase of an alternating quantity
an instrument used for measuring phases of an unbalanced 3-phase load
a coloured tag or band for distinguishing between different phases of a 3-phase supply