Question is ⇒ If X(z) = 2az-1/(1 - az-1)3 and |a| < |z|, then the initial value x0 is, Options are ⇒ (A) 0, (B) 1, (C) ∞, (D) 2, (E) , Leave your comments or Download question paper.

Question is ⇒ If X(z) = 2az-1/(1 - az-1)3 and |a| < |z|, then the initial value x0 is, Options are ⇒ (A) 0, (B) 1, (C) ∞, (D) 2, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If X(z) = 2az^-1/(1 - az^-1)³ and \|a\| < \|z\|, then the initial value x₀ is
A.	0 [Correct Answer]
B.	1 [Wrong Answer]
C.	∞ [Wrong Answer]
D.	2 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a class B amplifier using a supply of V_CC = 30 V and driving a load of 16 Ω the maximum efficiency will be __________ .
0.724
0.7854
0.624
0.6854

⇒ A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls calculate the phase velocity for dominant mode.
3 x 10⁸ m/sec
5 x 10⁸ m/sec
1.5 x 10⁸ m/sec
9 x 10⁸ m/sec

⇒ In satellite communication, highly directional antennas are used to
direct the spot beam to a particular region of space on Earth
strengthen the beam to overcome the cosmic noise
make corrections in change of polarisation of the beam
select a particular channel in transmission and reception

⇒ The characteristic polynomial of a system is q(s) = 2s⁵ + s⁴ + 4s³ + 2s² + 1. The system is :
stable
marginally stable
unstable
oscillatory

⇒ The density of dynamic RAM is
the same as static RAM
less than that of static RAM
more than that of static RAM
either equal or less than that of static RAM

⇒

Assertion (A): JFET is a voltage controlled device.

Reason (R): The drain current can be controlled by controlling V_GS.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A 1000 kHz carrier wave modulated 40% at 4000 Hz is applied to a resonant circuit tuned to a carrier frequency and having Q = 140. What is the degree of modulation after passing the wave through this circuit?
0.4
0.2
0.27
0.554

⇒ A 2 μF capacitor is shunted by a 1 kΩ maintained at temperature 400 K. The rms noise voltage across the capacitor over the entire frequency band is:
6.25 x 10^-8 V
5.25 x 10^-6 V
6.25 x 10^-6 V
5.25 x 10^-8 V

⇒ System satellites orbit the Earth once in
24 hours
12 hours
1 hours
6 hours

⇒ The resonant frequency of the circuit shown in figure
1/22p Hz
1/2p Hz
1/4p Hz
1/2p Hz

⇒ The resistance of a superconductor is
low
very low
very very low
zero

⇒ The basic storage element in a digital system is
flip flop
counter
multiplexer
encoder

⇒ Yettrium-iron garnet (Y₂Fe₅O₁₂) is a soft magnetic material suitable for applications involving
dc
50 Hz ac
ac of a few K Hz
ac of a few hundred MHz

⇒ In case of surface waves the field strength at a point is directly proportional to
antenna height
wave frequency
current of the antenna
distance of the point from the antenna

⇒ A transmitter radiates a power 20 KW and its base current is 18A. The radiation resistance of the antenna is
1111 Ω
900 Ω
75 Ω
62 Ω

⇒ If f is the frequency of electromagnetic wave, f_c is cutoff frequency, then in a rectangular waveguide
attenuation is low when f > f_c
attenuation is low when f < f_c
attenuation is high when f < f_c
either (b) or (c)

⇒ An atom of a rare gas is placed is an electric field E. Then
the nucleus will be shifted in the direction of E by an amount which is proportional to E.
the nucleus will not be shifted.
the nucleus will be shifted in the direction of E by an amount which is independent of E.
the nucleus will be shifted in a direction opposite to that of E.

⇒ The image frequency of a superheterodyne receiver is
independent of the frequency at which the receiver is tuned
always outside the operating range of the receiver
typical to FM receivers only
not rejected by the IF tuned circuits

⇒ In a J-K flip flop the input J = K = 1 pulse is about
set
reset
no change
toggle

⇒ In a 4 bit full adder how many half adders and OR gates are required
8 and 4
7 and 4
7 and 3
8 and 3

⇒

Match the following:

	List I		List II
A.	TV	1.	1 kHz
B.	Radio	2.	3 kHz
C.	Telephony	3.	9 kHz
D.	Telegraphy	4.	5 MHz

A-4, B-1, C-2
A-4, B-3, C-2
A-2, B-1, C-3
A-1, B-2, C-3

⇒ Z flag is reset if an ALU operation results in 0.
TRUE
FALSE

⇒ As the temperature of semiconductor is increased
the average number of free charge carriers decreases
the average number of free charge carriers increases
the average number of free charge carriers remains the same
the average number of free charge carriers may increase or decrease

⇒ In the circuit of figure the voltage across C at t = 0^{+0 V
20 V
very large
7.5 V}

⇒ The given figure shows a pole zero diagram. The transfer function G(j1
0.5 ∠0
2.7 ∠- 31°
2 ∠45°
2 ∠- 67.4°

⇒ A signal m(t) with bandwidth 500 Hz is first multiplied by a signal g(t) w
δ(t)
m(t)
0
m(t) δ(t)

⇒ In an homogeneous dielectric subjected to an electric field E, the dipole moment per unit volume is ∈₀(∈_r - 1) E.
TRUE
FALSE

⇒ In a colour TV receiver, which of the following incorporates colour saturation control?
Chroma detector
Colour killer circuit
SAW filter
Chroma amplifier

⇒ The output characteristics of a bipolar transistor has three distinct regions. They are known as
saturation region, active region and breakdown region
inactive region, active region and breakdown region
inactive region, saturation region and active region
inactive region, saturation region and breakdown region

⇒ Which of the following microphones is used as a standard for calibration?
Moving coil
Carbon
Condenser
Ribbon