Question is ⇒ If X(z) = (1 - az-1)-1 and |a| < |z|, the initial value x0 = 0, Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ If X(z) = (1 - az-1)-1 and |a| < |z|, the initial value x0 = 0, Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If X(z) = (1 - az^-1)^-1 and \|a\| < \|z\|, the initial value x₀ = 0
A.	TRUE [Wrong Answer]
B.	FALSE [Correct Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ What will be conversion time of a successive approximation A/D converter which uses 2 MHz clock and 5 bit binary ladder containing 8 V reference.?
2.5 μ sec
25 μ sec
3 μ sec
4 μ sec

⇒ In a 100% amplitude modulated signal, the power in the upper sideband when carrier power is to be 100 W and modulation system SSBSC, is
100 W
66 W
50 W
25 W

⇒ A Ge diode operated at a junction temperature of 27°C. For a forward current of 10 mA, V_D is found to be 0.3 V. If V_D = 0.4 V then forward current will be
400 mA
475 mA
477 mA
480 mA

⇒ Which of the following is not a proper FORTRAN expression?
B + A / C - D
(A + C) / (B + D)
B + * A / C
A ** (B + 2)

⇒ Which of the following statements in FORTRAN 77 is non executable?
GO TO
RETURN
STOP
PARAMETER

⇒

Assertion (A): CMOS devices have very low power consumption

Reason (R): CMOS devices have high noise margin.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The dual of quantity charge is
current
Voltage
flux
dΦ/dt

⇒ If Z(s) has a pole at origin, the realization leads to
a resistance in series
an inductance in series
a capacitance in series
a resistance or capacitance in series

⇒ System bus is the communication channel between microprocessor and peripherals.
TRUE
FALSE

⇒

Assertion (A): The polynomial s³ + 6s² + 12s + 8 is Hurwitz.

Reason (R): In a Hurwitz polynomial all coefficients are non-negative.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following is correct in FORTRAN 77?
PARAMETER PMOS = 9.8, NMOS = X
PARAMETER (PMOS = 9.8, NMOS = X)
PARAMETER PMOS = 9.8, NMOS = X
PARAMETER PMOS, NMOS = 9.8, X

⇒ In following figure find V_GG by assuming gate current is negligible for the p-channel JFET. (if I_DQ = - 6 mA, R_S = 0, V_DD = -18 V, R_D = 2 kΩ, I_DSS = - 10 mA, I_PO = - 3 V)
0.67 V
6.7 V
7 V
0.3 V

⇒ An audio signal is to be transmitted digitally. Which is the system best suited for good fidelity?
8 bit PCM
13 bit PCM
32 bit PCM
PCM system with non-uniform quantizer

⇒ In FM modulation pre-emphasis is done for
high frequency components
low frequency components
middle frequency components
both (a) and (b)

⇒ Assume that op-amp in figure is ideal. If input V_i is triangular, the output V₀ wil
square wave
sine wave
triangular wave
parabolic wave

⇒ A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls calculate the phase velocity for dominant mode.
3 x 10⁸ m/sec
5 x 10⁸ m/sec
1.5 x 10⁸ m/sec
9 x 10⁸ m/sec

⇒ In a positive-edge-triggered JK flip-flop, a low J and a low K produce __________ state. A high __________ on the rising edge of the clock.
inactive, reset
active, reset
active, toggle
inactive, toggle

⇒ In PAL system weighting of R - Y and B - Y signals is done to
prevent over modulation on saturated colours
prevent under modulation of saturated colours
allow over modulation of saturated colours
allow under modulation on saturated colours

⇒ A first order system will never be able to give a __________ response

band stop
band pass
all pass

Choose the correct option
1, 2, 3 true
1 and 3 true, 2 false
1, 2 are true 3 is false
1, 2 are false, 3 is true

⇒ In a 5.6 ohms, ± 10% carbon composition resistor, the colour of the third strip from extreme left is
golden
silver
green
black

⇒ The signumm function written as [sgn(t)] is defined as
sgn(t) = - 1 for t < 0, = 0 for t = 0 and = 1 for t > 0
sgn(t) = 1 for t < 0, = 0 for t = 0 and = - 1 for t > 0
sgn(t) = 0 for t < 0, = 1 for t = 0 and = 0 for t > 0
sgn(t) = 0 for t < 0, = 1 for t³ 0

⇒ The decimal equivalent of binary 1101.11 is
9.75
13.75
11.5
11.75

⇒ Household taperecorders generally use
crystal microphone
moving coil microphone
condenser microphone
cardioid microphone

⇒ In dc tacho generators used for measurement of speed of shaft, frequent calibration is necessary because
contacts wear off
strength of permanent magnet decreases with age
armature current produces heating effect
there is back emf

⇒ Which of the following are universal gates?

NAND
NOR
XOR

Select the correct answer from the codes given below:
1 and 2 only
1 and 3 only
2 and 3 only
1, 2 and 3

⇒ An RL impedance function can also be realized as
RC impedance function
RC admittance function
LC impedance function
LC admittance function

⇒ The refractive index of E layer at frequency of 81 N
0
∞
1
0.5

⇒ Magnetic effect of current is used in
ammeters
voltmeters
wattmeters
ammeters, voltmeters, wattmeters and energy meters

⇒

Assertion (A): A presettable counter can be preset to any desired starting point

Reason (R): The maximum frequency of a ripple counter depends on the modulus.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In 8085, which instructions are useful for writing and using subroutines?
CALL
RET
CALL and RET
none of the above