Question is ⇒ If X = - 285.56 and the Pascal write statement used is <code>WRITE (X : 8).</code> Then the print out will appear as, Options are ⇒ (A) -285.56, (B) -2.85 E + 02, (C) -2.85560 E + 02, (D) -2.8 E + 02, (E) , Leave your comments or Download question paper.

Question is ⇒ If X = - 285.56 and the Pascal write statement used is <code>WRITE (X : 8).</code> Then the print out will appear as, Options are ⇒ (A) -285.56, (B) -2.85 E + 02, (C) -2.85560 E + 02, (D) -2.8 E + 02, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If X = - 285.56 and the Pascal write statement used is `WRITE (X : 8).` Then the print out will appear as
A.	-285.56 [Wrong Answer]
B.	-2.85 E + 02 [Wrong Answer]
C.	-2.85560 E + 02 [Wrong Answer]
D.	-2.8 E + 02 [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In communication satellites, the up-link normally operates at a higher frequency than the down-link because it
gives a narrow beam shining into space
results in lesser signal attenuation
gives better beam-shaping
is easier to polarize a high frequency beam

⇒ The frequency tolerance for the RF carrier in the standard AM radio broadcast band is
zero
+20 Hz
+1000 Hz
+25 Hz

⇒ Figure sho
JFET
n-channel MOSFET
p-channel MOSFET
none of the above

⇒ Figure shows four D type FFs are connected as a shift register using an XOR gate. The initial state and 3 subsequent states for 3 clock pulses are also g
0
1111
1001
1000

⇒ The feedback resistance r_d in small signal model of MOSFET is of the order of
1000 MΩ
1 MΩ
1 KΩ
100 Ω

⇒ The dielectric losses do not depend on frequency.
TRUE
FALSE

⇒ Satellite launch sites are invariably located on Eastern seaboards to ensure that
launch takes place eastward
expenditure of propulsion fuel is reduced during plane changing
the satellite achieves circular orbit quickly
spent rocket motor and other launcher debris falls into the sea

⇒ In a 4 input OR gate, the total number of High outputs for the 16 input states are
16
15
14
13

⇒ In intrinsic semiconductor magnitude of free electron and hole concentrations are equal.
TRUE
FALSE

⇒ For the port shown, the short circuit network function at port 2 is give
s + 1/4
s + 4
4s + 1
s + 16

⇒ Consider the following statement : If a network has an impedance of (1 - j) as a specific frequency, the circuit would consist of series

R and C
R and L
R, L and C

Which of the statement are correct?
1 and 2
1 and 3
1, 2 and 3
2 and 3

⇒ Consider the following stateme
1 and 2 only
3 and 4 only
1, 2 and 3
2, 3 and 4

⇒ TRAP is __________ whereas RST 7.5, RST 6.5, RST 5.5 are __________ .
maskable, non-maskable
maskable, maskable
non-maskable, non-maskable
non-maskable, maskable

⇒ In the following transistor circuit V_BE = 0. 7 V, r_c = 25mV/I_E, and β and the capacitance are very l
1 mA
2 mA
5 mA
10 mA

⇒ A wire has a resistance R ohm. If another wire of the same material and same weight has double the diameter (as compared to the first wire), the resistance of the second wire will be
0.5 R
0.25 R
0.125 R
R/16

⇒

Match the following:

	List I (Characteristics)		List II (Decrease)
A.	Paramagnetic	1.	All dipoles are aligned is one preferred direction
B.	Ferromagnetic	2.	Half the dipoles are aligned in opposite direction and have equal magnitude
C.	Antiferromagnetic	3.	Half the dipoles (with equal magnitudes) are aligned in opposite direction to the other half having equal but lower magnitude
D.	Ferrimagnetic	4.	All dipoles have equal magnitude but are randomly oriented

A-4, B-3, C-2, D-1
A-4, B-1, C-2, D-3
A-2, B-1, C-4, D-3
A-2, B-3, C-4, D-1

⇒ Consider a system whose input x and output y are related by the equa
Causal, LP
BIBO, LTI
BIBO, Causal, LTI
LP, LTI

⇒ According to maximum power transfer theorem, if the load is inductive, the source should be
inductive
capacitive
resistive
any of the above

⇒ Slotted line can be used for measurement of high frequencies
TRUE
FALSE

⇒ In a hi-fi system the frequency response over the audio frequency range should be within
± 10 dB
5 dB
2 dB
1 dB

⇒ A resistance wire strain gauge has gauge factor 2. If stress is 100 mega newton/m² and Young's modulus is 200 giga newton/ m², the percentage change in gauge resistance due to stress is
0.1
0.2
0.4
0.5

⇒ Which display device resembles vacuum tube?
LED
LCD
VF
None of these

⇒ In a D latch
a high D sets the latch and low D resets it
a low D sets the latch and high D resets it
race can occur
none of the above

⇒ In figure, the switch is initially open. At t = 0 switch is closed. v_c (0⁺) and i_L (0⁺)
60 V and - 0.3 A
150 V and zero
zero and 0.3 A
90 V and - 0.3 A

⇒ Consider the following galvanometers

D'Arsonval
Ballistic
Vibration

Which of these are permanent magnet moving coil instruments?
1 and 2 only
1, 2 and 3
2 and 3 only
1 and 3 only

⇒ In the given figure, the curves 1, 2, 3 are respectively
all pass, minimum phase and non-minimum phase functions
minimum phase, all pass and non-minimum phase functions
non-minimum phase, all pass and minimum phase functions
minimum phase, non-minimum phase and all pass functions

⇒ The symbol ! in Java means
logical NOT
logical OR
AND
logical XOR

⇒ The design of wave filter is based on characteristic impedance which is
pure resistance
pure reactance
pure resistance in pass band and pure reactance in attenuation band
pure reactance in pass band and pure resistance in attenuation band

⇒ A short vertical grounded antenna is required to radiate at 1 MHz. The effective height of the antenna is 302 m. The calculated value of radiation resistance is
1.58 Ω
158 Ω
15.8 Ω
none

⇒ Two similar coupled coils are connected in series. The total inductance in series aiding connection is 100 mH. If currents is 3 A, the energy stored in magnetic field is
0.9 J
0.45 J
0.225 J
1.8 J