Question is ⇒ If we need a device to shut off a few ampere current in a few nano seconds, the proper devices is, Options are ⇒ (A) VMOS, (B) CMOS, (C) BJT, (D) UJT, (E) , Leave your comments or Download question paper.

Question is ⇒ If we need a device to shut off a few ampere current in a few nano seconds, the proper devices is, Options are ⇒ (A) VMOS, (B) CMOS, (C) BJT, (D) UJT, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If we need a device to shut off a few ampere current in a few nano seconds, the proper devices is
A.	VMOS [Correct Answer]
B.	CMOS [Wrong Answer]
C.	BJT [Wrong Answer]
D.	UJT [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A discrete time linear shift-invariant system has an impulse response h[n] with h[0] = 1, h[1] = - 1, h[2] - 2, and zero otherwise. The system is given an input sequence x[n] with x[0] - x[2] - 1, and zero otherwise. The number of nonzero samples in the output sequence y[n], and the value of y[2] are, respectively
5, 2
6, 2
6, 1
5, 3

⇒ A wire has a resistance R ohm. If another wire of the same material and same weight has double the diameter (as compared to the first wire), the resistance of the second wire will be
0.5 R
0.25 R
0.125 R
R/16

⇒ A pulse stretcher is same as a
free running multivibrator
bistable multivibrator
monostable multivibrator
latch

⇒ The circuit in figur
rectifier
voltage to frequency converter
frequency to voltage converter
logarithmic amplifier

⇒ In 8085 microprocessor with memory mapped I/O which of the following is true?
I/O devices have 16 bit addresses
I/O devices are accessed during IN and OUT instructions
There can be a maximum of 256 input and 256 output devices
Logic operations can not be performed

⇒ The coding system generally used in digital telemetry is
PPM (Pulse position modulation)
PAM (Pulse amplitude modulation)
PCM (Pulse code modulation)
PDM (Pulse duration modulation)

⇒ What is the purpose of using ALE signal high?
To latch low order address from bus to separate A₀ - A₇ lines
To latch data D₀ - D₇ from bus to separate data bus
To disable data bus latch
All of the above

⇒ A CT is used to feed current coils of wattmeter, energy meter, power factor meter and an ammeter. Then
all the coils are in series
all coils are in parallel
the coils are in series-parallel
either (a) or (b)

⇒ For a MOS capacitor fabricated on a P-type semiconductor, strong inversion occurs when
surface potential is equal to Fermi potential
surface Potential is greater than Fermi potential
surface potential is - ve and equal to Fermi potential in magnitude
surface potential is + ve and equal to twice the Fermi potential

⇒ A single phase half wave converter is used to charge a battery of 50 V. The thyristor is continuously fired by dc signal. Input voltage is v = V_m sin ωt. The thyristor will conduct
from 0 to 180°
when v > 50 V
from 0 to 90°
When v < 50 V

⇒ The Boolean expression for the circuit of the given fi
A {F + (B + C) (D + E)}
A [F + (B + C) (DE)]
A + F + (B + C) (D + E)]
A [F + (BC) (DE)]

⇒ A waveguide connected to a circularly polarized antenna must be able to efficiently propagate both vertically and horizontally polarised waves.
TRUE
FALSE

⇒ In commercial FM Broadcasting, A radio station transmitting the signal at 98.3 MHz, it is
carrier frequency
modulation frequency
message frequency
channel frequency

⇒ Two sinusoidal voltage sources v₁ = 50 sin (100t) and v₁ = 50 sin (100t + p) are connected in parallel and fed an inductance X_L = 2Ω. The cuirent through X_L is
25 A
about 17.5 A
zero
50 A

⇒

Assertion (A): Derivative control action is also called rate control and has an anticipatory character.

Reason (R): Derivative control amplifies noise signals.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Ferrimagnetic materials have anti-parallel orientation of equal moments of permanent dipoles.
TRUE
FALSE

⇒ Capacitance hats are installed on low frequency antenna is
increase the electrical length
reduce the electrical length
protect against lightening
protect against corona effects

⇒ In a material, the Fermi level is located between the centre of the forbidden band and the conduction band. Then what is that material?
A p-type semiconductor
An n-type semiconductor
An intrinsic semiconductor
An insulator

⇒ A Darlington pair has β = 300. If R_E = 1 kΩ and R_L = 100 Ω, the input impedance at the base is approximately
300 k ohm
3 k ohm
100 k ohm
30 k ohm

⇒ A series resonant circuit is fed by a voltage having rms value V. At resonance, the voltage across inductance V_L and voltage across capacitance V_C are related as
V_L > V_C
V_L < V_C
V_L = V_C
V_L = 0.5 V_C

⇒ If a sheet of a mica is inserted between the plates of an air capacitor, the capacitance
will increase
will return the same
will decrease
may increase or decrease

⇒ A 400 W carrier is amplitude modulated with m = 0.75. If single side band suppressed carrier is used the total power in modulated wave is
400 W
512 W
112 W
56 W

⇒ A wave trap is a
series tuned circuit
a parallel tuned circuit
either a series tuned circuit or parallel tuned circuit
none of the above

⇒

Assertion (A): A demultiplexer can be used as a decoder.

Reason (R): A demultiplexer can be built by using AND gates only.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ What is meant by "continuous collector current" in BJT?
Maximum collector current
Current at Quiescent condition
Leakage current
Junction Capacitance charging and discharging current

⇒ The induced magnetic dipole moment has a direction opposite to the applied magnetic field.
TRUE
FALSE

⇒ In equally tampered musical scale, an octave is divided into
12 intervals
10 intervals
7 intervals
5 intervals

⇒ In intrinsic semiconductor at 300 K, the magnitude of free electron concentration in silicon is about
15 x 10⁴ per cm³
5 x 10¹² per cm³
1.45 x 10¹⁰ per cm³
1.45 x 10⁶ per cm³

⇒ Manganin, an alloy of copper and manganese, is used in
Soldering material
Heating elements
Ballast resistors
Standard resistances

⇒ In FM and AM the ratio of signal to noise ratio at the detector output least depends upon
bandwidth
transmission
carrier frequency
modulating frequency