Question is ⇒ IF VCC = 15 V, VCEQ = 5 V and ICQ = 50 mA, the efficiency in class A operation is, Options are ⇒ (A) 1, (B) 0.5, (C) 0.25, (D) 0.167, (E) , Leave your comments or Download question paper.

Question is ⇒ IF VCC = 15 V, VCEQ = 5 V and ICQ = 50 mA, the efficiency in class A operation is, Options are ⇒ (A) 1, (B) 0.5, (C) 0.25, (D) 0.167, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	IF V_CC = 15 V, V_CEQ = 5 V and I_CQ = 50 mA, the efficiency in class A operation is
A.	1 [Wrong Answer]
B.	0.5 [Wrong Answer]
C.	0.25 [Wrong Answer]
D.	0.167 [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The advantage of Weinbridge oscillator over the phase shift oscillator is that oscillator the frequency may be varied over a range of
0.0430555555555556
0.04375
0.0451388888888889
0.0486111111111111

⇒ Simplify : A + B + A B + (A + B)AB + C(B + AB)
B + A
C
C
1

⇒ Examine the following truth table. The product of sum from this truth tabl
(X + Y) (X + Y)
(X + Y) (X + Y)
(X + Y) (X + Y)
(X + Y) (X + Y)

⇒ For the output F to be 1 in the logic circuit shown, the input combination shoul
A = 1, B = 1, C = 0
A = 1, B = 0, C = 0
A = 0, B = 1, C = 0
A = 0, B = 0, C = 1

⇒ In a modified series inverter
the maximum output frequency is less than frequency of damped oscillations
the output frequency can be even higher than the frequency of damped oscillations
the output frequency cannot exceed the frequency of damped oscillations
any of the above

⇒ The voltage gains of an amplifier without feedback and with negative feedback respectively are 100 and 20. The percentage of negative feedback (β) would be
0.4
0.05
0.2
0.8

⇒ In mode filter of the given figure which of the following modes is unaffe
TE₀₁
TE₁₀
TE₁₁
all TM

⇒ The capacitor filter provides poor voltage regulation because
the increase in ripple with load current causes a decrease in average voltage
the increase in ripple with load current causes a increase in average voltage
filter promotes ripple at peak voltage
none of the above

⇒ Antenna used for direction finding is
long dipole
parabolic
rhombic
helical

⇒

Assertion (A): When a high reverse voltage is applied to a p-n junction the diode breaks down.

Reason (R): High reverse voltage causes Avalanche effect.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Selectivity varies with receiving frequency, frequency is raised.
Somewhat better when the receiving frequency is raised
Somewhat better at intermediate frequency
Somewhat worse when the receiving frequency is lowered
Somewhat worse when the receiving frequency is raised

⇒ In the above case the hexadecimal notation for the last memory location is
0
FFFF
3FFF
5FFF

⇒ In the circuit of figure, the current through battery E_{34 A charging
4 A discharging
4 A charging or discharging depending on value of E₃
4 A charging or discharging depending on values of E₁, E₂, E₃}

⇒ For measurement of surface temperature of solids the elements of RTD is usually in the shape of
bar
coil
flat grid
either (a) or (b)

⇒ Insulation resistance of a cable is directly proportional to its length.
TRUE
FALSE

⇒

Match the following:

	List I (Comm.services)		List II (Bandwidth)
A.	AM broadcast	1.	10 kHz
B.	Telephone	2.	4 kHz
C.	wide-band FM	3.	200 kHz
D.	TV	4.	7 MHz

A-1, B-2, C-3, D-4
A-3, B-4, C-1, D-2
A-1, B-4, C-3, D-2
A-3, B-2, C-1, D-4

⇒ A transmission line has characteristics impedance of (75 + j 0.01) Ω and is terminated in a load impedance of (70 + j 50) Ω. The transmission coefficient will be
1.70 - j 2.97
0.08 + j 0.32
1.32 + j 1.38
1.08 + j 0.32

⇒

Assertion (A): In register indirect addressing mode of 8085, the address of operand is in the specified register.

Reason (R): An example of register indirect addressing mode is MOV, A, M..

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ A lag compensator provides attenuation in
very low frequency range
low frequency range
high frequency range
none of the above

⇒ When a ferromagnetic substance is magnetised, small changes in dimensions occur. Such a phenomenon is known as
magnetic hystresis
magnetic expansion
magneto striction
magneto calorisation

⇒

Assertion (A): At room temperature the fermi level in p type semiconductor lies nearer to the valence band and in n type semiconductor it lies nearer to the conduction band.

Reason (R): At room temperature, the p type semiconductor is rich in holes and n type semiconductor is rich in electrons.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ An input voltage V(t) = 10 2 cos (t + 10°) + 10 3 cos (2t + 10°)V is applied to a series combination of resistance R = 1 kΩ inductance L = 1H. The resulting steady-state current i(t) in ampere is
10 cos (t + 55°) + 10 cos (2t + 10° tan^-12)
10 cos (t + 55°) + 103/2 cos (2t + 55°)
10 cos (t - 35) + 10 cos (2t + 10° - tan^-12)
10 cos (t - 35) + 103/2 cos (2t + 35°)

⇒ K maps can be drawn
only for 2 variables
only for 3 variables
only for 4 variables
for any number of variables

⇒ In the following non-planar graph no.of independent loop equations
8
12
7
5

⇒ An amplifier signal is made up of just two frequencies 1000 Hz. The output signal consists of 500 Hz and 25000 Hz frequencies. This may be attributed to
harmonic distortion
intermodulation distortion
both (a) and (b)
none of the above

⇒ A multivibrator generates
sinusoidal waveforms
non-sinusoidal waveforms
both (a) and (b)
none of the above

⇒ The Fourier transform of f(t) = cos ω₀t is
p[δω₀ + δ(- ω₀)]
p[δ(ω - ω₀) + δ(ω + ω₀)]
p[δω₀ - δ(- ω₀)]
p[δ(ω - ω₀) - δ(ω + ω₀)]

⇒ On modulating a carrier of frequency f_c by an audio signal f_s, the following components has result
Amplitude modulation (DSB)
Single sideband modulation
Frequency modulation only
Amplitude modulation or frequency modulation

⇒ For an P-channel enhancement type MOSFET determine the drain current if K = 0.278 x 10^-3A/V², V_GS = -4V, V_T = -2V, Voltage equivalent at 27°C = 26 mV.
10 mA
1.11 mA
0.751 mA
46.98 mA

⇒ A step voltage E is applied to a series R-L circuit. The rate of change of current is maximum at t =
zero
infinity
L/R
R/L