Question is ⇒ If two networks are connected in series of individual Z parameter as Za and Zb then equivalent Z is, Options are ⇒ (A) [Z] = [Za] + [Zb], (B) [Z] = [Za] [Zb], (C) [Z] = [Za]/[Zb], (D) [Z] = [Za] - [Zb], (E) , Leave your comments or Download question paper.

Question is ⇒ If two networks are connected in series of individual Z parameter as Za and Zb then equivalent Z is, Options are ⇒ (A) [Z] = [Za] + [Zb], (B) [Z] = [Za] [Zb], (C) [Z] = [Za]/[Zb], (D) [Z] = [Za] - [Zb], (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If two networks are connected in series of individual Z parameter as Z_a and Z_b then equivalent Z is
A.	[Z] = [Z_a] + [Z_b] [Correct Answer]
B.	[Z] = [Z_a] [Z_b] [Wrong Answer]
C.	[Z] = [Z_a]/[Z_b] [Wrong Answer]
D.	[Z] = [Z_a] - [Z_b] [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Good smoothing factor of a coil depends on
inductance of the coil
terminal voltage
cross-sectional area of the wire of the coil
property of the wire of the coil

⇒ Consider the following program for 8085 decimal 20
decimal 40
decimal 10
none of the above

⇒ (29)₁₃ ÷ (29)₁₂ x (29)_x = (23)₁₆ Find x
11
12
13
16

⇒ In N channel MOSFET with gate reverse biased, the gate current is of the order
10^-3 amp
10^-6 amp
10^-9 amp
10^-12 amp

⇒ If the characteristic equation is (λ + 1) (λ + 2) (λ + 3) = 0, the eigen values are
-1, -2, -3
1, 2, 3
0, 1, 2
0, 2, 3

⇒ If a sample of Ge and a sample of Si have the same impurity density are kept at room temperature
both will have equal value of resistivity
both will have equal - ve of resistivity
resistivity of germanium will be higher than that of silicon
resistivity of silicon will be higher than of Ge

⇒ If word length is 16 bits the decimal equivalent of largest number which can be stored is
32767
32766
16383
16384

⇒ One eV = 1.602 x 10^-19 joules.
TRUE
FALSE

⇒ In elemental dielectrics, the orientation and ionic polarization are absent.
TRUE
FALSE

⇒ Class A and Class B power amplifiers predominate at
audio frequencies
radio frequencies
all frequencies
audio and radio frequency

⇒ If X(z) = (1 - a)z^-1/[(1 - z^-1)(1 - az^-1)] and 1 < |z|, the final value of x_k is
0
1
∞
2

⇒ A sequential multiplexer is connected as shown in figure. Each time the multiplexer receives the clock, it switches to the next channel from 6 to 1. If the input signals a
8 kHz
50 kHz
20 kHz
10 kHz

⇒ For the power amplifier circuit shown below, the maximum power dissipated by both output transisto
9.66 W
30.11 W
31.66 W
33.66 W

⇒ Consider a Binary Symmetric Channel (BSC) with probability of error being p. To transmit a bit, say 1, we transmit a sequence of three 1 s. The receiver will interpret the received sequence to represent 1 if at least two bits are 1. The probability that the transmitted bit will be received in error is
p³ + 3p² (1 - p)
p³
(1 - p)³
p³ + p² (1 -p)

⇒ A certain transistor has a_dc of 0.98 and a collectors leakage current of 5 μA. If I_E = 1 mA, the base current will be
35 μA
25 μA
15 μA
5 μA

⇒ In telephone, the dial tone has a frequency of
5 Hz
15 Hz
33 Hz
233 Hz

⇒ Surge current rating of an SCR is
the maximum repetitive surge current in which the SCR can withstand
the maximum non-repetitive surge current in which the SCR can withstand
the maximum repetitive or non repetitive surge current in which the SCR can withstand
the maximum surge current in which the SCR can withstand if both surge current and steady current exist together

⇒ The system matrix of continuous time system described in state variable for
x < 1/2, y < 1/2
x > 1/2, y > 0
x < 0, y < 0
x < 0, y < 1/2

⇒ In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half of the secondary winding is 30 V. Then PIV is
30 V
60 V
15 V
10 V

⇒ 10's complement of 16₁₀ is
83₁₀
84₁₀
38₁₀
48₁₀

⇒ A balanced modulator is used in the generation of which of the following?
DSB-SC signal
FM signal
PM signal
PAM signal

⇒ CSSB stands for
Compatible Single Sideband
Compressed Single Sideband
Carrier Single Sideband
Coded Single Sideband

⇒ The Laplace transform of a unit step function is
1
1 / s
s
1 / s²

⇒ In an SCR, the anode current consists of
only holes
only electrons
both electrons and holes
either electrons or holes

⇒ In a base driver amplifier the voltage gain is the ratio of
ac collector voltage to ac base voltage
ac emitter voltage to ac base voltage
ac collector voltage to ac emitter voltage
ac base voltage to ac emitter voltage

⇒ In the circuit of figure diode will con
from 90 to 180° in the positive half cycle
from 30° to 180° in the positive half cycle
from 50° to 160° in the positive half cycle
from 30° to 150° in the positive half cycle

⇒ The most suitable method for detecting a modulated signal g(t) = (3 to 6 cos 2pf_mt) cos 2pf_ct is
envelope detector
synchronous detector
ratio detector
both a and b

⇒ Which of the following is a false statement about Armstrong modulation system?
The system is basically phase, not frequency, modulation
AFC is not needed, as a crystal oscillator is used
Equalization is unnecessary
Frequency multiplication must be used

⇒ A loss less line is terminated in a circular lines are E lines
SWR = 0
SWE = 0
SWR is finite
SWR = ∞

⇒ The ratio of active power to apparent power is known as __________ factor.
power
load
form
demand