Question is ⇒ If there is no impervious boundary at the bottom of a hydraulic structure, stream lines tend to follow :, Options are ⇒ (A) a straight line, (B) a parabola, (C) a semi-ellipse, (D) a semi-circle., (E) , Leave your comments or Download question paper.

Question is ⇒ If there is no impervious boundary at the bottom of a hydraulic structure, stream lines tend to follow :, Options are ⇒ (A) a straight line, (B) a parabola, (C) a semi-ellipse, (D) a semi-circle., (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If there is no impervious boundary at the bottom of a hydraulic structure, stream lines tend to follow :
A.	a straight line [Wrong Answer]
B.	a parabola [Wrong Answer]
C.	a semi-ellipse [Correct Answer]
D.	a semi-circle. [Wrong Answer]
View Answer 31 -4 Explanation:- Answer : C Discuss it below : Kishor das Said on 2020-06-24 21:28:28 The maximum pressure which soil can carry with out shear failure is called !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The height of capillary rise is maximum
Fine gravel
Colloids
Silt
Fine sand

⇒ The bulk density of the soil sample stated in Q. No. 11.243, is.
1.4 g/cc
1.6 g/cc
1.8 g/cc
2.0 g/cc

⇒ Pick up the in-correct statement from the following: The soils which contain montmorillonite minerals.
swell more when wet
shrink more when dry
possess high plasticity
possess high coefficient of internal coefficient

⇒ Clay layer A with single drainage and coefficient of consolidation Cv takes 6 months to achieve 50% consolidation. The time taken by clay layer B of the same thickness with double drainage and coefficient of consolidation Cv/2 to achieve the same degree of consolidation is
3 months
6 months
12 months
24 months

⇒ The specific yield of soil depends upon.
compaction of stratum
distribution of pores
shape and size of particles
all the above.

⇒ If voids ratio is 0.67, water content is 0.188 and specific gravity is 2.68, the degree of saturation of the soil, is.
25%
40%
40%
75%

⇒ Pick up the correct statement from the following:
Coefficient of compressibility is the decrease in void ratio per unit increase of pressure
The percent settlement at any time is called degree of consolidation
The initial curve on either side of the point of unloading and reloading is called 'virgin curve'
All the above.

⇒ The shape of precast concrete pile is generally
Square
Round
Square or octagonal
Square or circular

⇒ When a soil has coefficient of permeability as 1 mm/sec, then the soil should be
Clay
Silt
Sand
Gravel

⇒ Pick up the incorrect statement from the following:
The smaller the size of the pores, the higher the water can rise above the water table.
Below the water table, the pore water may be static.
The hydrostatic pressure depends on the depth below the water level.
None of these.

⇒ The angle of internal friction is maximum for.
angular-grained loose sand
angular-grained dense sand
round-grained dense sand
round-grained loose sand

⇒ The clay mineral with the largest swelling and shrinkage characteristics is
kaolinite
illite
montmorillonite
none of the above

⇒ The ratio of e_max and e_min of silty sand, is.
2.0
5
3.0
3.5

⇒ Pick up the correct statement from the following:
In hydrometer method, weight Wd per ml of suspension is found directly
In pipette analysis, weight Wd per ml of suspension is found indirectly
In pipette analysis, weight Wd per ml of suspension is found directly
None of these.

⇒ Sieve analysis of a soil sample is done if the particle do not pass through square openings of
0.075 mm
0.150 mm
4.75 mm
0.300 mm

⇒ Plate loading test is of
Short duration
Long duration
Medium duration
Very long duration

⇒ The maximum possible value nf dry density is referred to as.
dry density
zero air voids
saturation dry density
all the above.

⇒ The critical exist gradient of seepage water in soils, increases with.
an increase in specific gravity
a decrease in specific gravity
a decrease in void ratio
both (a) and (c)

⇒ The slip at critical angle, is generally known.
Î´ 1-line
rupture plane
slip plane
all the above.

⇒ Pile foundations are generally preferred to for.
bridge foundations
sky scrapper buildings
residential buildings
runways.

⇒ The void ratio of a soil sample decreases from 1.50 to 1.25 when the pressure is increased from 25 tonnes/m² to 50 tonnes/m², the coefficient of compressibility is.
0.01
0.02
0.05
0.001

⇒ The seepage force in a soil, is.
perpendicular to the equipotential lines
proportional to the exit graident
proportional to the head loss
all the above.

⇒ The ratio of volume of air voids to the volume of total voids, is known as.
air content
percentage air voids
percentage voids
porosity.

⇒ A grillage foundation.
is provided for heavily loaded isolated columns
is treated as spread foundation
consists of two sets of perpendicularly placed steel beams
all the above.

⇒ The ratio of the undrained strength in the undrained state to the undrained strength, at the same water content, in the remoulded state, is called the sensivity of the clay. Its value for quick clays is.
4
8
16
20

⇒ Piers in pier foundation are built by
Excavat ion
Hammer blows
Vibro-equipments
Hydro-forces

⇒ Direct measurement of permeability of the specimen at any stage of loading can be made
only in fixed ring type consolido-meter
only in floating ring type consolido-meter
both (a) and (b)
none of the above

⇒ Pick up the correct statement from the following:
The rise of the ground surface due to frost action is called frost heave.
The freezing of water is accompained by a volume increase of 9%.
The magnitude of frost heave decreases as the degree of saturation of soil decreases
All the above.

⇒ The specific gravity of quartz, is.
2.65
2.72
2.85
2.90

⇒ The maximum pressure which a soil can carry without shear failure, is called.
safe bearing capacity
net safe bearing capacity
net ultimate bearing capacity
ultimate bearing capacity.