Question is ⇒ If the p and T circuits in figure are equivalent, then R1, R2, R3 respectively, Options are ⇒ (A) 9 Ω, 6 Ω, 6 Ω, (B) 6 Ω, 6 Ω, 9 Ω, (C) 9 Ω, 6 Ω, 9 Ω, (D) 6 Ω, 9 Ω, 6 Ω, (E) , Leave your comments or Download question paper.

Question is ⇒ If the p and T circuits in figure are equivalent, then R1, R2, R3 respectively, Options are ⇒ (A) 9 Ω, 6 Ω, 6 Ω, (B) 6 Ω, 6 Ω, 9 Ω, (C) 9 Ω, 6 Ω, 9 Ω, (D) 6 Ω, 9 Ω, 6 Ω, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If the p and T circuits in figure are equivalent, then R₁, R₂, R₃ respectively
A.	9 Ω, 6 Ω, 6 Ω [Wrong Answer]
B.	6 Ω, 6 Ω, 9 Ω [Correct Answer]
C.	9 Ω, 6 Ω, 9 Ω [Wrong Answer]
D.	6 Ω, 9 Ω, 6 Ω [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A 300 MHz plane EM wave is propagating in free space. The wave is incident normally on an infinite copper slap. The antenuation constant for the wave is (σ_copper = 5.8 x 10⁷ mho/ m)
262 x 10³
254 x 10³
352 x 10³
354 x 10³

⇒ In asynchronous TDM, for n signal sources, each frame contains m slots, where m is usually
Less than n
2n
n
greater than 2n

⇒ In a sine wave, maximum rate of change of voltage occurs at
ascent of the waveform
+ ve maximum
- ve maximum
between maximum and minimum

⇒ In Z_RC(s) has a pole at s = 0, the first element in first Foster realization is
a capacitor
a resistor
R-C in series
either a capacitor or resistor

⇒ The dielectrics having only one kind of atoms are known as elemental dielectrics.
TRUE
FALSE

⇒ The sensitivity of electromagnetic digital flow meter can be increased by increasing
circumferential width of rotor teeth
radial depth of rotor teeth
thickness of rotor teeth
number of teeth

⇒ In an RC series circuit excited by dc voltage E, the current at t = 0 is
E/R
E/C
zero
infinity

⇒

Assertion (A): In FM the frequency of the carrier is varied by the modulating voltage

Reason (R): FM and PM are two forms of angle modulation.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): There are no convergence issues with the discrete-time Fourier series in general.

Reason (R): A discrete-time signal is always obtained by sampling a continuous-time signal.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The hexadecimal number given below represent decimal numbers which are multiples of DC, C8, BE, 46, IE
2
6
7
10

⇒ In a 3 input NAND gate, the number of states in which output is 1 equals
8
1
6
5

⇒ An RC snubber circuit is used to protect a thyristor against :
false triggering
failure to turn on
switching transients
failure to commutate

⇒ Logic hardware is available only in NAND and NOR.
TRUE
FALSE

⇒ Logarithmic amplifiers are used in
adders
dividers
multipliers
all of the above

⇒ Which amplifier has a voltage gain of less than 1?
Common emitter
Common collector
Common base
Both CB and CC

⇒ The important postulate arising out of Maxwell's modification of Ampere's law is
a changing magnetic field produces an electric field
a changing electric field produces a magnetic field
a motional e.m.f. is produced by a coil moving in a magnetic field
a steady current produce a magnetic field

⇒ An increase in ambient temperature means that maximum power rating of transistor
will increase
will decrease
may increase or decrease
may increase or remain the same

⇒ If V_dc1 is the dc output voltage in half wave controlled rectifier circuit feeding resistive load and V_dc2 is the dc output voltage in full wave controlled rectifier circuit (M - 2 connection) feeding resistive load, then
V_dc1 = 0.5 V_dc2 for all values of firing angle
V_dc1 = V_dc2 for all values of firing angle
V_dc1 ≤ 0.5 V_dc2 for all values of firing angle
V_dc1 ≥ 0.5 V_dc2 for all values of firing angle

⇒ Which of the following values represents the open loop gain of typical op-amp?
100
10000
100000
1000000

⇒ For a series R-L-C circuit, the characteristic equation is given
critically damped
underdamped
undamped
overdamped

⇒ A cavity resonator is
a hollow metallic enclosure
a hollow enclosure having magnetic material as its walls
a hollow enclosure having dielectric material as its walls
either (b) or (c)

⇒ The device 'one shot' has
two stable states
one stable state
either 1 or 2 stable states
no stable state

⇒ A VF display operates on the principle of a vacuum diode.
TRUE
FALSE

⇒ (22)₄ + (101)₃ - (20)₅ = (x)₄ + (4)_x+1 where x > 4. The value of x is
6
4
12
8

⇒ Binary number 1101101101 is equal to decimal number
3289
2289
1289
289

⇒ For a second order system, damping ratio ζ is such that 0 < ζ <. Then the roots of characteristic equation are
real but not equal
real and equal
complex conjugate
imaginary

⇒ For any transfer function, the constant phase angle loci are
a family of circles
a family of straight lines
either (a) or (b)
neither (a) nor (b)

⇒

Assertion (A): In a differential amplifier the current through common emitter resistor is called tail current

Reason (R): CMRR of an op-amp indicates how a differential signal amplified

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In the two ports network shown in the figure, Z₁₂ and Z₂₁ are, respecti
r_e and βr₀
0 and - βr₀
0 and βr₀
r_e and - βr₀

⇒

Match the following:

	List I (Symbol in java)		List II (Meaning)
A.	&	1.	Logical AND
B.	ˆ	2.	AND
C.	\| \|	3.	XOR
D.	& &	4.	Logical OR

A-1, B-2, C-3, D-4
A-2, B-3, C-1, D-4
A-4, B-2, C-3, D-1
A-2, B-3, C-4, D-1