Question is ⇒ If the reverse voltage across a p-n junction is increased three times, the junction capacitance, Options are ⇒ (A) will decrease, (B) will increase, (C) will decrease by an approximate factor of about 2, (D) will increase by an approximate factor of about 2, (E) , Leave your comments or Download question paper.

Question is ⇒ If the reverse voltage across a p-n junction is increased three times, the junction capacitance, Options are ⇒ (A) will decrease, (B) will increase, (C) will decrease by an approximate factor of about 2, (D) will increase by an approximate factor of about 2, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If the reverse voltage across a p-n junction is increased three times, the junction capacitance
A.	will decrease [Wrong Answer]
B.	will increase [Wrong Answer]
C.	will decrease by an approximate factor of about 2 [Correct Answer]
D.	will increase by an approximate factor of about 2 [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A 16-megabit dynamic random access memory (DRAM) is an integrated circuit capable of storing __________ characters (bytes).
1048567
16 x 1024 x 10⁶
16 x 10⁶
2.1 x lo⁶

⇒ Transformer oil is
refined vegetable oil
refined mineral oil
mixture of vegetable and mineral oil
none of the above

⇒ Satellites used for international communication are called
cossort
domsat
marisat
intelsat

⇒ In the circuit shown in the given figure, power dissipated in the 5 Ω resisto
zero
80 W
125 W
405 W

⇒ With reference to C programming language, which of the following statements are correct?

An identifier may start with an underscore.
An identifier may end with an underscore.
If is a valid identifier.
The number of significant characters in and identifier is implementation dependent.

Select the correct answer from the codes given below:
1 and 2 only
2 and 3 only
1, 2, 3 and 4
3 and 4 only

⇒ A pre-emphasis circuit provides extra noise immunity by
converting the phase modulation to frequency modulation
pre-amplifying the whole audio band
boosting the base frequencies
amplifying the higher audio frequencies

⇒ In a two phase servomotor the voltages applied to the two stator windings
are equal in magnitude and are in phase
are unequal in magnitude but are in phase
are equal in magnitude but have a phase difference of 90°
are unequal in magnitude and have a phase difference of 90°

⇒ Which capacitor-store higher amount of energy?
Air capacitor
Paper capacitor
Mica capacitor
Plastic film capacitor

⇒ The circuit shown in the figure is best described
bridge rectifier
ring modulator
frequency discriminator
voltage doubler

⇒ Quartz crystal has
very small Q
small Q
very high Q
Q less than 1

⇒ In the FM wave described by equation v = 15 sin (4 x 10⁸ t + 3 sin 1100 t), the maximum frequency deviation is
175 Hz
525 Hz
3 Hz
58.33 Hz

⇒ The maximum power dissipation capacity of a transistor is 50 mW. If the collector emitter voltage is 10 V, what is the safe collector current that can be allowed through the transistor?
5 mA
2.5 mA
10 mA
25 mA

⇒ Which of the following is true?
A silicon wafer heavily doped boron is a p⁺ substrate
A silicon wafer lightly doped boron is a p⁺ substrate
A silicon wafer heavily doped arsenic is a p⁺ substrate
A silicon wafer lightly doped arsenic is a p⁺ substrate

⇒ A bridge rectifier circuit has a dc load current of 10 mA and a filter capacitance of 1000 μF. The peak to peak ripple voltage is
0.01 V
0.05 V
0.1 V
0.5 V

⇒ A compensated wattmeter has its reading corrected for error due to which one of the following parameters?
Frequency
Friction
Power consumed in current coil
Power consumed in pressure coil

⇒ In a second order system with a unit step input, the speed of response is high if system is
overdamped
undamped system
critically damped
underdamped

⇒ The OP-AMP circuit shown above represen
high pass filter
low pass filter
band pass filter
band reject filter

⇒ Armstrong F.M. transmitter performs frequency multiplication in stages
to increase the overall S/N
for convenience
to reduce the bandwidth
to find the desired value of carrier frequency with frequency deviation

⇒ In the circuit shown, the steady state is reached with S open S is closed at t = 0, the current I in the 1 Ω resistor connected is to be determined at t = 0⁺ is give
1
2
3
42828

⇒ A photo diode is
forward biased
reverse biased
either forward or reverse biased
unbiased

⇒ A series RC circuit has fixed R and C and variable f. The current locus will lie in the first quadrant.
TRUE
FALSE

⇒

Assertion (A): Laplace transform can be used to evalute integrals.

Reason (R): Laplace transform can be used to solve differential equations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The closing of switch S₁ and S₂ in figure will ligh
lamp L₁ only
lamps L₁ and L₂
none of them
lamp L₂ only

⇒ If C is spring constant and θ is deflection, controlling torque is
Cθ
C/θ
θ/C
C²θ

⇒ When a superheterodyne receiver is tuned to 455 kHz, its local oscillator provides a mixer with the input at 1010 kHz. The image frequency is
555 kHz
1010 kHz
1465 kHz
1920 kHz

⇒ When a material is in superconducting state and a magnetic field is applied
the superconducting property is not affected
the superconducting property may be affected and resistivity may increase from zero to a low value
the superconducting property may be destroyed
the material may become an insulator

⇒ VSWR can have any value between
0 and 1
- 1 to + 1
0 to ∞
1 to ∞

⇒ Which of the following is not a characteristic of a flip flop?
It is a bistable device
It has two outputs
It has two outputs are complement of each other
It has one input terminal

⇒

Assertion (A): The Fourier series of the wave shown in the figure does not contain even harmao
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Which of the following may result in instability problem?
Large error
High selectivity
High gain
Noise