Question is ⇒ If the repeller voltage in a klystron oscillator is increased the transit time of electron, Options are ⇒ (A) will be increased, (B) will be decreased, (C) will remain the same, (D) either (a) or (b), (E) , Leave your comments or Download question paper.

Question is ⇒ If the repeller voltage in a klystron oscillator is increased the transit time of electron, Options are ⇒ (A) will be increased, (B) will be decreased, (C) will remain the same, (D) either (a) or (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If the repeller voltage in a klystron oscillator is increased the transit time of electron
A.	will be increased [Wrong Answer]
B.	will be decreased [Wrong Answer]
C.	will remain the same [Correct Answer]
D.	either (a) or (b) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Household tape recorders use
separate motor for each operation
only one motor for all operations
one motor for capstan and another for take up reel
a total of 3 motors

⇒ The use of microprocessor control in automobiles results in
improved fuel economy
improved car control
advanced information system for driver
all of the above

⇒ Typical switching time for ECL is
5 nano seconds
5 micro seconds
5 milli seconds
5 seconds

⇒ The function of shunt in an ammeter is to
by pass the current
increase sensitivity of meter
increase resistance of meter
all of the above

⇒ In the graph shown in the figure, for the tree with branches b, d and f the fundamental loops would inclu
abf, def, bdea
bdc, def, fba
abde, def, cdb
cea, bdea, abbf

⇒ If A = B = 1, the outputs P and Q in the given figure
P = Q = 0
P = 0, Q = 1
P = 1, Q = 0
P = Q = 1

⇒ In fi
Wave A is lagging wave B by ∠θ
Wave A is leading wave B by ∠θ
Wave A is lagging wave B by ∠θ and the two waves have same rms values
Wave A is lagging wave B by ∠θ and the two waves have different rms values

⇒ In sound recording the degree of pre-emphasis is about 6 dB/ octave.
TRUE
FALSE

⇒ Voltage 1 + 2 sin ωt is applied to the circuit shown be
0 volt
2 volts
-2 volts
-3 volts

⇒ Power gain of antenna equals directive gain in VHF and UHF range if and only if efficiency of the antenna is __________ .
0.25
0.5
0.75
1

⇒ In an Anderson bridge the unknown inductance is measured in terms of
known inductance and resistance
known inductance
known capacitance and resistance
known capacitance

⇒ Two resistors R₁ = 36 Ω ± 5% and R₂ = 75 Ω ± 5% are connected in series. The total resistance is
111 ± 0 Ω
111 ± 2.778 Ω
111 ± 5.55 Ω
111 ± 7.23 Ω

⇒ For the current wave i = 10 + 10 sin θ, the rms value is
0.416666666666667
12.247 A
20 A
14.14 A

⇒ An ideal op-amp has
infinite input and output resistance
low input and output resistance
low input and high output resistance
infinite input resistance and zero output resistance

⇒ RF amplifiers are used in radio receivers for
improved image frequency rejection
improved rejection of adjacent unwanted signals
prevention of re-radiation of the local oscillator through the antenna of the receiver
all of the above

⇒ What is the correct sequence of the following step in the fabrication of a monolithic, Bipolar junction transistor?

Emitter diffusion
Base diffusion
Buried layer formation
E pi-layer formation

Select the correct answer using the codes given below:
3, 4, 1, 2
4, 3, 1, 2
3, 4, 2, 1
4, 3, 2, 1

⇒ A 2 bit binary multiplier can be implemented using
2 I/P only
2 I/P XOR_s and 4 I/P and gates only
two 2 I/P_s NOR and one XNOR gate
XOR gates and shift Register

⇒ Which of the following are the memory performance parameters?

Access time and latency
Block size and Block access time
Cycle time and Bandwidth

Select the correct answer from the codes given below:
1 only
1 and 2 only
2 and 3 only
1, 2 and 3

⇒ The input to ALU are the contents of accumulator and temporary register.
TRUE
FALSE

⇒ In a microwave resistor the wall thickness is made as small as possible to
have high value of R
have low value of R
minimize capacitive effect
reduce inductance

⇒ CC circuit is suitable for impedance matching.
TRUE
FALSE

⇒ Wave A starts its positive half cycle at ωt = 30° and wave B starts its positive half cycle at ωt = 75° then wave B is leading wave A by 45°.
TRUE
FALSE

⇒ Maxwell's curl equation for the static electric field E can be expressed as
Δ x E = 0
Δ x E = constant
Δ - E = constant
Δ . E = 0

⇒ Study the circuit of figure and examine the following statem
1, 2 and 3
1 and 2
1 and 3
2 and 3

⇒ The value of VSWR is taken as ∞ when the line is
short-circuited
open-circuited
terminated with full load
terminated with load equal to the characteristic impedance of the load

⇒ The equivalent T circuit of this coupled network is shown in figure. Find the values of Z_A, Z_B and Z_{C-j, 6j, 2j
-j, 2j, 6j
j, 2j, - 6j
j, 2j, 6j}

⇒ For demodulating PCM; it is first converted into
PDM
PPM
PWM
PAM

⇒ BCD input 1000 is fed to a 7 segment display through a BCD to 7 segment decoder/driver. The segments which will lit up are
a, b, d
a, b, c
all
a, b, g, c, d

⇒ Which one of the following theorem can be conveniently used to calculate the power consumed by the 10 Ω resistor in the network shown in the above fig
Thevenin's theorem
Maximum power transfer theorem
Millman's theorem
Superposition theorem

⇒ In the circuit of figure the current through 5 Ω resistance at t = &infin
0
0.416666666666667
6.67 A
5.1 A