Question is ⇒ If the poles lie in second quadrant, damping ratio is, Options are ⇒ (A) 1, (B) less than 1, (C) zero, (D) more than 1, (E) , Leave your comments or Download question paper.

Question is ⇒ If the poles lie in second quadrant, damping ratio is, Options are ⇒ (A) 1, (B) less than 1, (C) zero, (D) more than 1, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If the poles lie in second quadrant, damping ratio is
A.	1 [Wrong Answer]
B.	less than 1 [Correct Answer]
C.	zero [Wrong Answer]
D.	more than 1 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The series element in band pass filter is
capacitive
inductive
parallel combination of inductance and capacitance
series combination of inductance and capacitance

⇒

Assertion (A): In AM, use of SSB reduces the power and bandwidth requirement

Reason (R): A balanced modulator produces AM with carrier suppressed

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In PCM, if the number of quantization levels is increased from 4 to 64, then the bandwidth requirement will approximately be increased __________ times.
8
16
3
32

⇒ Semiconductors have
aero temperature coefficient of resistance
positive temperature coefficient of resistance
negative temperature coefficient of resistance
none of the above

⇒

Assertion (A): An op-amp has high voltage gain, high input impedance and low output impedance

Reason (R): Negative feedback increases output impedance

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In the given circuit, the switch has been in position 1 for quite a long time. At t = 0 the switch is moved to position 2. At this position what is the time const
0.1 s
1 s
0.11 s
1.11 s

⇒ In C the range of real constants expressed in exponential form is
-2.3 e 37 to + 2.3 e 37
-3.4 e 38 to + 3.4 e 38
-3.4 e 37 to + 3.4 e 37
-2.3 e 38 to + 2.3 e 38

⇒ An ammeter of 0-25 A range has a guaranteed accuracy of 1% of full scale reading. The current measured is 5 A. The limiting error is
0.02
0.025
0.04
0.05

⇒ The total power radiated from an antenna system is determined by imagining that the antenna is at the centre of a very large
sphere
rectangle
square
ellipse

⇒ Figure represen
Varactor
LED
Zener diode
Temperature dependent diode

⇒

Assertion (A): When a photoconductive device is exposed to light, its bulk resistance increases.

Reason (R): When exposed to light, electron hole pairs are generated in the photoconductive device.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In the circuit shown below, the outputs Y₁ and Y₂ for the given initial condition Y₁ = Y₂ = 1 and after four input pulses wil
Y₁ = 1, Y₂ = 0
Y₁ = 0, Y₂ = 0
Y₁ = 0, Y₂ = 1
Y₁ = 1, Y₂ = 1

⇒ Moving iron instrument can be used for ac only.
TRUE
FALSE

⇒

Assertion (A): A VMOS can handle much larger current than other field effect transistors.

Reason (R): In a VMOS the conducting channel is very narrow.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Figure shows the self bias circuit for CE amplifier and its equivalent circuit. V_BB and R_B respectively
10 V and 4 k ohm
5 V and 4 k ohm
2 V and 4 k ohm
2 V and 10 k ohm

⇒

Assertion (A): Manufacturer's quote h parameters of transistor

Reason (R): h parameters of a transistor are easiest to measure

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The input impedance of short-circuited line of length l where λ/4 < l < λ/2, is
resistive
inductive
capacitive
none of the above

⇒ In a radio detector
stabilization against signal strength variation is provided
linearity is worse than in a phase discriminator
the circuit is the same as in discriminator except that diodes are reversed
output is twice that obtainable from a similar phase discriminator

⇒ The recently-introduces CD-ROM PC by Head Start Technologies Co. of New York enables users to view or play __________ .
vast amounts of text
graphics
music
all of the above

⇒ If a line having Z₀ = 300 ∠ 0 W is short circuited at far end, VSWR is
0
1
∞
2

⇒ Which amplifier will be preferred for highest gain?
Darlington's pair
Single stage amplifier
Cascade amplifier
Depends on the circuitry

⇒ In a television camera tube, scanning of a picture is done
line by line from left to right
line by line from right to left
line by line from top to bottom
line by line from bottom to top

⇒ What would be the rms value of a sine wave having the same peak value as that of the above mentioned periodic wave?
42.2 V
19 V
38.2 V
none

⇒ The polar plot for positive frequencies is shown below. The gain margi
- 8.02 dB
6.02 dB
5 dB
none of these

⇒ An antenna is considered to be in free space where its height above the ground is
λ
2λ
less than 3λ
more than 5λ

⇒ In a TWT the phase velocity of the axial component of the field on the slow wave structure is kept
equal to velocity of electron
slightly less than velocity of electron
slightly more than velocity of electron
equal to velocity of light in free space

⇒ In case of probability of the message is 1 to 16 then the information will be
16 bits
8 bits
4 bits
2 bits

⇒ V MOS have the advantage of
faster switching
no thermal run away
both (a) and (b)
none of the above

⇒ A 10 bit ADC with a full scale output voltage of 10.24 V is to be designed to have ± LSB/2 accuracy. If ADC is calibrated at 25°C, the maximum net temperature coefficient of ADC should not exceed
± 200 μV/°C
± 400 μV/°C
± 600 μV/°C
± 800 μV/°C

⇒ Speeds of sound and radio waves are equal.
TRUE
FALSE