Question is ⇒ If the height of transmission tower is increased, which of the following; parameters is likely to change ?, Options are ⇒ (A) Capacitance, (B) Inductance, (C) Resistance, (D) All of the above, (E) None of the above, Leave your comments or Download question paper.

Question is ⇒ If the height of transmission tower is increased, which of the following; parameters is likely to change ?, Options are ⇒ (A) Capacitance, (B) Inductance, (C) Resistance, (D) All of the above, (E) None of the above, Leave your comments or Download question paper. Previous question Next question


Q1.	If the height of transmission tower is increased, which of the following; parameters is likely to change ?
A.	Capacitance [Correct Answer]
B.	Inductance [Wrong Answer]
C.	Resistance [Wrong Answer]
D.	All of the above [Wrong Answer]
E.	None of the above [Wrong Answer]
View Answer 19 -7 Explanation:- Answer : A Discuss it below : Merja Sagar Said on 2019-09-11 20:20:07 Not see ans !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The voltage of the single phase supply to residential consumers is
110 V
210 V
230 V
400 V

⇒ Impedance relay is used on ____ transmission lines
short
medium
long
all

⇒ Multicore cables generally use
square conductors
circular conductors
rectangular conductors
sector-shaped conductors

⇒ The surge resistance of cables is
20 ohms
50 ohms
200 ohms
300 ohms

⇒ If variable part of a.nnual cost on account of interest and depreciation on the capital outlay is equal to the annual cost of electrical energy wasted in the conductors, the total annual cost will be minimum and the corresponding size of conductor will be most economical. This statement is known as
Kelvin's law
Ohm's law
Kirchhoffs law
Faraday's law

⇒ High voltages for transmitting power is economically available from
d.c. currents
a.c. currents
carrier currents
none of the above

⇒ Steepness of the travelling waves is alternated by ____ of the line
capacitance
inductance
resistance
all of the above

⇒ In aluminium conductors, steel core is provided to
compensate for skin effect
neutralise proximity effect
reduce line inductance
increase the tensile strength

⇒ Which of the following D.C. distribution system is the simplest and lowest in first cost, ?
Radial system
Ring system
Inter-connected system
None of the above

⇒ In which of the following cases shunt capacitance is negligible ?
Short transmission lines
Medium transmission lines
Long transmission lines
All transmission lines

⇒ The material commonly used for insulation in high voltage cables is
lead
paper
rubber
none of the above

⇒ The usual spans with R.C.C. poles are
40-50 metres
60-100 metres
80-100 metres
300-500 metres

⇒ Which of the following equipment should be installed by the consumers having low power factor ?
Synchronous condensers
Capacitor bank
Tap changing transformer
Any of the above

⇒ In context of corona, if the conductors are polished and smooth, which of the following statements is correct ?
Hissing sound will be more intense
Power loss will be least
Corona glow will be uniform along the length of the conductor
Corona glow will not occur

⇒ The voltage regulation in magnetic amplifier type voltage regulator is effected by
electromagnetic induction
varying the resistance
varying the reactance
variable transformer

⇒ The area of cross-section of the neutral in a 3-wire D.C. system is generally ____ the area of cross-section of main conductor
same as
one-fourth
one half
double

⇒ Transmission line insulators are made of
glass
porcelain
iron
P.V.C.

⇒ The current drawn by the line due to corona losses is
non-sinusoidal
sinusoidal
triangular
square

⇒ The effect of wind pressure is more predominant on
supporting towers
neutral wires
transmission lines
insulators

⇒ System grounding is done so that
inductive interference between power and communication circuits can be controlled
the floating potential on the lower voltage winding for a transformer is brought down to an insignificant value
the arcing faults to earth would not set up dangerously high voltage on healthy phases
for all above reasons

⇒ The underground system cannot be operated above
440 V
11 kV
33 kV
66 kV

⇒ Which of the following faults is most likely to occur in cables ?
Cross or short-circuit fault
Open circuit fault
Breakdown of cable insulation
All of the above

⇒ The frequency of voltage generated, in case of generators, can be increased by
using reactors
increasing the load
adjusting the governor
reducing the terminal voltage

⇒ In medium transmission lines the shunt capacitance is taken into account in
T-method
π-method
steinmetz method
all of the above

⇒ Which of the following materials is not used for transmission and distribution of electrical power ?
Copper
Aluminium
Steel
Tungsten

⇒ Constant voltage transmission entails the following disadvantage
large conductor area is required for same power transmission
short-circuit current of the system is increased
either of the above
none of the above

⇒ By which of the following a bus-bar is rated ?
Current only
Current and voltage
Current, voltage and frequency
Current, voltage, frequency and short time current

⇒ The loads on distributors systems are generally
balanced
unbalanced
either of the above
none of the above

⇒ Overhead system can be designed for operation upto
11 kV
33 kV
66 kV
400 kV

⇒ The power transmitted will be maximum when
corona losses are minimum
reactance is high
sending end voltage is more
receiving end voltage is more