Question is ⇒ If the absolute value of a number is less than decimal 1, the sign of exponent in floating point representation is, Options are ⇒ (A) zero, (B) negative, (C) zero or negative, (D) positive, (E) , Leave your comments or Download question paper.

Question is ⇒ If the absolute value of a number is less than decimal 1, the sign of exponent in floating point representation is, Options are ⇒ (A) zero, (B) negative, (C) zero or negative, (D) positive, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If the absolute value of a number is less than decimal 1, the sign of exponent in floating point representation is
A.	zero [Wrong Answer]
B.	negative [Wrong Answer]
C.	zero or negative [Correct Answer]
D.	positive [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A copper specimen has resistivity equal to 1.8 x 10^-8 ohm-m at room temperature. At a temperature of 700 K, the resistivity is likely to be
1.6 x 10^-8 Ω-m
2 x 10^-8 Ω-m
3 x 10^-8 Ω-m
6 x 10^-8 Ω-m

⇒ The temperature coefficient of copper is 0.00393 at 20° C. At 50° C the temperature coefficient is
0.0042
0.0035
0.0025
0.0015

⇒ Discrete transistors T₁ and T₂ having maximum collector current rating of 0.75 amp are connected in parallel as shown in the figure, this combination is treated as a single transistor to carry a total current of 1 ampere, when biased with self bias circuit. When the circuit is switched on, T₁ draws 0.55 amps and T₂ draws 0.45 amps. If the supply is kept on continuously, ultimately it is very likely
Both T₁, and T₂ get damaged
Both T₁, and T₂ will be safe.
T₁ Will get damaged and T₂ will be safe
T₂ will get damaged and T₁, will be safe.

⇒ The function of a modulator is to
separate two frequencies
extract information from the carrier
amplify the audio frequency signal
impress the information on to a RF carrier

⇒ For a series RLC circuit bandwidth is ω₂ - ω₁ = R/2L.
TRUE
FALSE

⇒ Calculate cut off frequency for dominant mode in rectangular waveguide if dimensions are a = 2, b = 1 cm.
7.5 GHz
1.5 GHz
15 GHz
150 GHz

⇒ In an SCR, the anode current is controlled by
gate current only
external circuit only
both gate current and external circuit
none of the above

⇒ A silicon wafer has 100 nm of oxide it and is inserted in a furnace at a temperature above 1000°C for further oxidation in dry oxygen. The oxidation rate
is independent of current oxide thickness and temperature
is independent of current oxide thickness but depends on temperature
slows down as the oxide grows
is zero as the existing oxide prevents further oxidation

⇒ Recommended fanout for ECL is
5
10
15
25

⇒ Superheterodyne receiver can be used in
AM
FM
SSB
All of the above

⇒ Radio broadcasts are generally
amplitude modulation
frequency modulation
both amplitude and frequency modulation
neither amplitude nor frequency modulation

⇒ A communication channel with AWGN operating at a signal to noise ratio SNR >> 1 and bandwidth B has capacity C₁. If the SNR is doubled keeping B constant, the resulting capacity C₂ is given by
C₂ ≈ 2C₁
C₂ ≈ C₁ + B
C₂ ≈ C₁ + 2B
C₂ ≈ C₁ + 0.3B

⇒ For a stable system having two or more gain crossover frequencies the phase margin is measured at the highest crossover frequency.
TRUE
FALSE

⇒ Which of the following devices is used at the first stage of an electronic voltmeter?
BJT
SCR
MOSFET
UJT

⇒ When a large number of atoms are brought together to form a crystal
the energy levels of inner shell electrons are affected appreciably by the presence of other neighbouring atoms.
The energy levels of outer shell electrons are affected appreciably by the presence of other neighbouring atoms.
the energy levels of both inner and outer shell electrons are affected appreciably by the presence of other neighbouring atoms.
none of the above.

⇒ Which of the following is not an application software?
MS Word
DBMS
Worksheet
Lisp

⇒ The 2's complement representation of - 17 is
1110
1111
11110
10001

⇒ In commercial electron tubes the current produced by the cathode at 1000 K is about
0.01 A per cm² of cathode surface
0.1 A per cm² of cathode surface
1 A per cm² of cathode surface
5 A per cm² of cathode surface

⇒ A full wave rectifier circuit using centre tapped transformer and a bridge rectifier are fed at 100 V, 50 Hz. The frequencies of outputs in these two rectifiers are
100 Hz each
50 Hz each
100 Hz and 50 Hz
50 Hz and 100 Hz

⇒ An electromagnetic wave is incident normally on a dielectric boundary. It is
totally reflected
partially reflected and partially refracted
totally absorbed
none of the above

⇒ Am equivalent 2's complement representation of the 2's complement number 1101 is
110100
1101
110111
111101

⇒ What is the necessary a.c. input power from the transformer secondary used in a half wave rectifier to deliver 500 W of d.c. power to the load?
1232 W
848 W
616 W
308 W

⇒ Bipolar IC memories are fabricated using
high density versions of the bipolar transistor flip-flop
low density versions of the unipolar transistor flip-flop
high density versions of the MOSFET
low density versions of the MOSFET

⇒ A CT is used to feed current coils of wattmeter, energy meter, power factor meter and an ammeter. Then
all the coils are in series
all coils are in parallel
the coils are in series-parallel
either (a) or (b)

⇒ For a reactance function H(s), the slope dH (jω)/dω is
0
always positive
always negative
either 0 or positive

⇒ Which of the following is unlikely to happen when quantising noise is decreased in PCM?
Increased bandwidth
Increased channel noise
Increased number of standard levels
All of the above

⇒

Match the following:

	List I (type of controller)		List II (Operation)
A.	Pneumatic controller	1.	Flexible operation
B.	Hydraulic controller	2.	High torque high speed operation
C.	Electronic controller	3.	Fire and explosion proof operation

A-1, B-3, C-2
A-1, B-2, C-3
A-3, B-1, C-2
A-3, B-2, C-1

⇒

Match the following:

	List I (Transducer)		List II (Quantity measured)
A.	LVDT	1.	Pressure
B.	Bourden gauge	2.	Temperature
C.	Strain gauge	3.	Displacement
D.	Thermistor	4.	Stress

A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4
A-4, B-1, C-3, D-2
A-3, B-1, C-4, D-2

⇒ Gain of an antenna with a circular aperture of diameter 4 meter at frequency of 10 GHz, with directivity 60
60
100
30
90

⇒ In 8085 microprocessor, how many interrupt control lines are there?
6
8
12
16