Question is ⇒ If quadratic equation x2 - 1000x + 25 = 0 is solved using floating point arithmetic with 4 digit mantissa, the roots are, Options are ⇒ (A) .1000 E 4 and .1000 E 4 respectively, (B) .0000 E 4 and .0000 E 4 respectively, (C) .1000 E 4 and .0000 E 4 respectively, (D) None of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ If quadratic equation x2 - 1000x + 25 = 0 is solved using floating point arithmetic with 4 digit mantissa, the roots are, Options are ⇒ (A) .1000 E 4 and .1000 E 4 respectively, (B) .0000 E 4 and .0000 E 4 respectively, (C) .1000 E 4 and .0000 E 4 respectively, (D) None of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If quadratic equation x² - 1000x + 25 = 0 is solved using floating point arithmetic with 4 digit mantissa, the roots are
A.	.1000 E 4 and .1000 E 4 respectively [Wrong Answer]
B.	.0000 E 4 and .0000 E 4 respectively [Wrong Answer]
C.	.1000 E 4 and .0000 E 4 respectively [Correct Answer]
D.	None of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The total number of input words for 4 input OR gate is
20
16
12
8

⇒ When the light falling on a photodiode increases, the reverse minority current
increases
increases or decreases
decreases
remains the same

⇒ In a synchronous counter all flip flops are clocked together.
TRUE
FALSE

⇒ In the network of the figure is the maximum power is delivered to RL if its valu
16 Ω
40/3 Ω
60 Ω
20 Ω

⇒ If D is diagonal and F is focal length, lens angle θ is
θ = tan^-1 (D/F)
θ = 2 tan^-1 (D/F)
θ = tan^-1 (D/2F)
θ = 2 tan^-1 (D/2F)

⇒ SSB can be generated by
filter method
phase cancellation method
good attenuation characteristics
all of the above

⇒ The v-i characteristics of a diode may be linear or non linear.
TRUE
FALSE

⇒ A ramp input applied to a unity feedback system results in 5% steady state error. The type number and zero frequency gain of the system are respectively.
1 and 20
0 and 20
0 and 1/20
1 and 1/20

⇒ Which of the following is open loop system?
Wind screen wiper
Aqualing
Respiratory system of animal
System for controlling antirocket missiles

⇒ In 8085 microprocessor, the interrupt enable flip-flop is reset by
DI instruction only
system RESET only
interrupt acknowledgment only
all of the above

⇒ 2N 2430 could be a
semi-conductor diode
dual gate MOSFET
BJT
UJT

⇒ For low impedance SAW filter the most suitable material for substrate of SAW filter is
PZT ceramics
ZnO
Lithium titanate
Lithium neobate

⇒ The phase difference (jω - p₁) means
phasor drawn from p₁ to jω
phasor drawn from origin to p₁
phasor directed from origin to jω point
phasor directed from jω to p₁

⇒ The circuit in the given figur
low pass filter
high pass filter
band Pass filter
band reject filter

⇒ The code which provides for parity check is
Baudot
ASCII
EBCDIC
Excess-3

⇒ The chemical effect of current is used in
dc ampere hour meter
dc ammeter
ac energy meter
all of the above

⇒ Consider the voltage transfer characteristic of a standard CMOS inve
NMOS and PMOS triode
Both are saturation
NMOS saturated PMOS linear
None of these

⇒

Assertion (A): Microprocesspr 8085 has six 8 bit registers B, C, D, E, H L.

Reason (R): B - C, D - E, H - L may be combined to form register pairs to hold 16 bits data.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In a current transformers
the number of turns in primary and secondary windings are nearly equal
the number of primary turns is very small as compared to number of secondary turns.
the number of secondary turns is very small as compared to the number of primary turns
either (a) or (c).

⇒ Which of the following is basically a voltage controlled capacitance?
Zener diode
Diode
Varactor diode
LED

⇒

Assertion (A): L[e^-at f(t)] = F(s + a)

Reason (R): In use of Laplace transform method, initial conditions may be neglected.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The unit for mmf is
A
Wb
T
V

⇒ A buffer is a device that isolates other devices. Typically a buffer has
a high input impedance and a low output impedance
a high input impedance as well as output impedance
a low input impedance and a high output impedance
a low input impedance as well as output impedance

⇒ A 400 W carrier is modulated to a depth of 75 percent. The total power in modulated wave will be
38.5 W
400 W
512.5 W
615.5 W

⇒ The given figure shows dB magnitude plots for type 0, type 1 and type 2 systems. Out of t
curves 1, 2, 3 are for type 0, 1, 2 systems respectively
curves 1, 2, 3 are for type 2, 1, 0 systems respectively
curves 1, 2, 3 are for type 1, 0, 2 systems respectively
curves 1, 2, 3 are for type 1, 2, 0 systems respectively

⇒ Which of the following addressing modes is used in the instruction PUSH B?
Direct
Register
Register Indirect
Immediate

⇒ A transponder is a satellite equipment which
receives a signal from Earth station and amplifies
changes the frequency of the received signal
retransmits the received signal
does all of the above-mentioned functions

⇒ The capacitors C₁, C₃, C₄ and C₅ have a capacitance of 4 μF each and the capacitor C₂ has a capacitance of 10 μF. The effective capacitance (in μF) between the points X and Y will
4 μF
6 μF
3 μF
8 μF

⇒ X and Y are two random variable and Z = X + Y. Let σ_x², σ_y² and σ_z² be variance of X, Y and Z. Then
σ_z² = σ_x² + σ_y²
σ_z² ≤ σ_x² + σ_y²
σ_z² < σ_x² + σ_y²
σ_z² > σ_x² + σ_y²

⇒ The transfer function G₁₂ (s) for a two port is
V₂/V₁
V₂ (s)/V₁ (s)
V₂ (s)/I₁ (s)
I₂ (s)/I₁ (s)