Question is ⇒ If other parameter are constant, transmission loss at 5 GHz as compared to that at 0.5 GHz is, Options are ⇒ (A) 20 dB more, (B) 20 dB less, (C) 700 dB more, (D) 100 dB less, (E) , Leave your comments or Download question paper.

Question is ⇒ If other parameter are constant, transmission loss at 5 GHz as compared to that at 0.5 GHz is, Options are ⇒ (A) 20 dB more, (B) 20 dB less, (C) 700 dB more, (D) 100 dB less, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If other parameter are constant, transmission loss at 5 GHz as compared to that at 0.5 GHz is
A.	20 dB more [Correct Answer]
B.	20 dB less [Wrong Answer]
C.	700 dB more [Wrong Answer]
D.	100 dB less [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Peak to peak value of a sinusoidal wave is 2.828 times the rms value.

Reason (R): Peak factor of a sinusoidal wave is 1.414.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): For same drain current rating N-channel MOSFET occupies more area than p-channel MOSFET.

Reason (R): Electron mobility is much higher than hole mobility.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Sampling frequency
100 Hz
200 Hz
400 Hz
none of these

⇒ The disadvantage of direct coupled amplifiers is
drift
large size of transistor
low voltage gain
both (b) and (c)

⇒ Which of the following meters requires an external power source for its operation?
P.M.M.C. meter
Hot wire ammeter
Electronic voltmeter
Electrodynamometer

⇒ If B_max is the maximum flux density, eddy current loss is proportional to
B_max
B^1.6_max
B²_max
B³_max

⇒ The addressing mode depicted in the given figur
direct
register
register indirect
immediate

⇒ The P-type substrate in a conventional pn Junction isolated integrated circuits should be connected to
any where
a dc ground potential
the most positive potential available in the circuit
the most negative potential available in the circuit

⇒ A boot strap generally incorporates
CB configuration
CE configuration
emitter follower
none of the above

⇒ An AC source or RMS voltage 20V with internal impedance Z_s = (1 + 2j) Ω feeds a load of impedance Z_L = (7 + 4j) Ω in the figure below. The reactive power consumed by the loa
8 VAR
16 VAR
28 VAR
32 VAR

⇒ For free space propagation
γ = a + jβ
γ = jβ
γ = a
a = β = 0

⇒

Assertion (A): Hall effect is used to find the type of semiconductor.

Reason (R): When a specimen of semiconductor carrying current I lies in a magnetic field the force on electrons and holes is in opposite directions.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a series RLC circuit the dB level of currents at half power frequencies as compared to current at resonance is
3
-3
0.5
-0.5

⇒ Consider the following in C

Arithmetic operations can be performed on ints.
Arithmetic operations can be performed on floats.
Arithmetic operation can be performed on chars

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ The bandwidth of FM for Commercial Purpose is
88 - 108 MHz
85 - 110 MHz
90 - 110 MHz
infinite Range

⇒ Decimal -90 equals __________ in 8 bit 2s complement
1000 1000
1010 0110
1100 1100
0101 0101

⇒

Assertion (A): When an electron is revolving in its orbit and magnetic field is also present, the angular frequency of electron will be affected by the magnetic field.

Reason (R): In the case of electron revolving in its orbit in the presence of magnetic field, the orbital magnetic dipole moment is not affected by the presence of magnetic field.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A transmission line has primary constants R, L, G and C and secondary constant z₀ and γ = (a + Jβ). If the line is loss less, then
R = 0, G ≠ 0, and a = 0
R = 0, G = a, 0 and β = |r|
G = 0, a = β
R = 0, G = 0, a = 0, β = |r|

⇒ The total area under the probability distribution curve is
1
0
depend upon curve equation
∞

⇒ An RLC series circuit is excited by a step voltage E. The circuit current at t = 0 is
E/R
E/LC
zero
infinity

⇒ At any point on the v-i characteristics of a semiconductor diode, the slope of v-i characteristics is called
resistance of diode
conductance of diode
incremental resistance of diode
incremental conductance of diode

⇒ In the given figure, the number of individual loop
2
4
5
6

⇒

Assertion (A): In totem pole output the output impedance is low.

Reason (R): TTL gate with active pull up should not be used in wired AND connection.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ If the carrier modulated by a digital bit stream has one of the possible phases of 0°, 90°, 180° and 270°. Then the modulation is called
BPSK
QPSK
QAM
MSK

⇒ The address to which a software or hardware restart branches is known as
Vector location
SID
SOD
TRAP

⇒ Two transistors have same value of a but different gain (G) bandwidth (B) product. The transistors have similar geometry. However one of them is germanium and the other is silicon. The transistor with lower GB product
is germanium
is silicon
may be either of two
cannot be identified on the basis of above data

⇒ In which material do conduction and valence bands overlap
insulators
conductors
both conductor and semiconductor
semiconductors

⇒ In a low level AM system, the amplifier which follows the modulated stage must be the
linear device
harmonic device
class C amplifier
non-linear device

⇒ Semiconductor ROM's are sometimes preferred to semiconductor RAM's because
ROM's are cheaper than RAMs
ROMs are faster
ROMs do not require power supply for their operations
Programs stored in ROMs cannot be altered either by the power failure or by the user

⇒ Electrical contact materials used in switches, brushes and relays must possess
high thermal conductivity and high melting point
low thermal conductivity and low melting point
high thermal conductivity and low melting point
low thermal conductivity and high melting point