Question is ⇒ If Laplace transform of f(t) is F(s), then £ f(t - a) u (t - a)= 0, Options are ⇒ (A) eas F(s), (B) e-as F(s), (C) - eas F(s), (D) - e -as F(s), (E) , Leave your comments or Download question paper.

Question is ⇒ If Laplace transform of f(t) is F(s), then £ f(t - a) u (t - a)= 0, Options are ⇒ (A) eas F(s), (B) e-as F(s), (C) - eas F(s), (D) - e -as F(s), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If Laplace transform of f(t) is F(s), then £ f(t - a) u (t - a)= 0
A.	e^as F(s) [Wrong Answer]
B.	e^-as F(s) [Correct Answer]
C.	- e^as F(s) [Wrong Answer]
D.	- e ^-as F(s) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Match the following:

	List I		List II
A.	Tunnel diode	1.	is also known as hot carrier diode
B.	PIN diode	2.	used with reverse bias
C.	Zener diode	3.	has an intrinsic layer
D.	Schottky diode	4.	v-i curve has shape of N

A-2, B-3, C-1, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-4, D-1
A-1, B-2, C-3, D-4

⇒ In figure the dc emitter current of each transistor is a
4 mA
2 mA
3 mA
1 mA

⇒ 74 HC series can sink upto 4 mA. The 74 LS series has I_IL(max) - 0.4 mA. How many 74 LS inputs be driven by 74 HC output?
100
none
8
10

⇒ An antenna having an effective temperature of 27°K is fed into a microwave amplifier that has an effective noise temperature of 30 K. Calculate the available noise power per unit bandwidth
30 K
57 K
27 K
3K, K is Boltzmann constant

⇒ In a line with finite attenuation
power transmission is least efficient when there are no standing waves on the line
power transmission is most efficient when there are no standing waves on line
Load power depends on phase constant
standing waves will always exist on the line

⇒ In a dynamometer 3 phase power factor meter, the planes of the two moving coils are at
60°
0°
120°
90°

⇒ A surface charge density of 8 nc/m² is present on a plane x = z. A line charge density of 30 nC/m is present on line x = 1, y = 2 Find V_AB for points A(3, 4, 0) and B(4, 0, 1)
583.38 V
58.338 V
583.38 mV
58.338 mV

⇒ High speed counter
ring counter
ripple counter
synchronous counter
asynchronous counter

⇒ Bode magnitude plot is drawn between
magnitude of network function and ω
dB magnitude and log ω
dB magnitude and ω
log_e (magnitude) and log ω

⇒ Good frequency stability can be available
crystal oscillators
Hartley oscillators
colpitts oscillators
none of the above

⇒ A direct current can be measured
directly by dc potentiometer
by dc potentiometer in conjunction with a standard resistance
by dc potentiometer in conjunction with volt ratio box
none of the above

⇒ Mc Murray full bridge inverter uses
4 thyristors and 2 diodes
4 thyristors and 4 diodes
8 thyristors and 4 diodes
8 thyristors and 8 diodes

⇒

Match the following:

	List I (Operator)		List II (Description)
A.	! =	1.	Left shift
B.	= =	2.	Right Shift
C.	< <	3.	Equal to
D.	> >	4.	Not equal to

A-1, B-2, C-3, D-4
A-2, B-3, C-4, D-1
A-4, B-1, C-3, D-2
A-4, B-3, C-1, D-2

⇒ In following circuit, R_B will be if V_CC = 10 V, V_S = 2 V, R_C = 5 kΩ, R_S = 90 kΩ, β = 50, I_CE = 0, V_CEsat = 0
230 K
235 K
240 K
250 K

⇒ In the given figure, of potentiometer V₀ = V_i (R₀/R_i) only
R_L = 0
R_L = ∞
R_L is neither low nor high
R_L is low but not zero

⇒ The memory hierarchy in microprocessor based system is
register, cache, primary, mass, off line back up
cache, register, primary, mass, off line back up
cache, register, mass, primary, off line back up
register, cache, mass, primary, off line back up

⇒ Which of the following operations will give the result 2 in C?
42857
4.0 / 2
4.0 / 2.0
4 / 2.0

⇒ Maximum effective aperture (A_e)max of short dipole antenna is
1.119 λ²
0.119 λ²
1.19 λ²
1.919 λ²

⇒ In commercial electron tubes the current produced by the cathode at 1000 K is about
0.01 A per cm² of cathode surface
0.1 A per cm² of cathode surface
1 A per cm² of cathode surface
5 A per cm² of cathode surface

⇒ x = AX + Bu is a state equation.
TRUE
FALSE

⇒ The logic operations of the two circuits given below
complementary
identical
entirely different
none of these

⇒ An RL series circuit has an impedance of 20 Ω when frequency is 25 Hz. At f= 50 Hz, the impedance will be
40 Ω
20 Ω
less than 40 W but more than 20 Ω
less than 20 W but more than 10 Ω

⇒ As the magnitude of reverse bias is increased, the capacitance of varactor diode
increases
decreases
first increase, then decreases
first decreases then increases

⇒ Consider the following statements as regards noise

If Gaussian noise is applied at input of a rectifier, the output is not gaussian
The noise encountered on a telephone line consists of short, pulse type disturbances whose amplitude distribution is not Gaussian
Shot noise results from random emission of electrons from a cathode
Shot noise results from phenomenon associated with the flow of current across semi conductor junctions

Which of the above are correct?
1, 2, 3, only
1, 2, 4 only
1, 2, 3, 4
2, 3 only

⇒ A JFET operates in ohmic region when
V_GS = 0
V_GS is less than pinch off voltage
V_GS = is Positive
V_GS = V_DS

⇒ In a two terminals network the O.C. voltage measured at the given terminals is 100 V and s.c., currents at the same terminals 5 A. If a load of 80 Ω resistance is connected at the terminals, load current is
0.0416666666666667
1.25 A
0.25
6.25 A

⇒

Assertion (A): In simplifying block diagram the product of transfer functions in feed forward direction must remain the same.

Reason (R): In simplifying block diagram the product of transfer functions around a closed loop must remain the same.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ One can format a disc using window explorer.
TRUE
FALSE

⇒

Assertion (A): A transducer needs an output measuring or display device for measuring a non electrical quantity.

Reason (R): In some transducers the output voltage is too small and needs amplification before it can be measured.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒

Assertion (A): Charge is dual of flux.

Reason (R): Short circuit is dual of open circuit.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true