Question is ⇒ If KMT = 100, LITRES = 5.0, PCOST = 28.0 and OPCOST = 70.0 what will be the result of the following FORTRAN 77 program? <c, Options are ⇒ (A) 2, (B) 2.1, (C) 21, (D) 21, (E) , Leave your comments or Download question paper.

Question is ⇒ If KMT = 100, LITRES = 5.0, PCOST = 28.0 and OPCOST = 70.0 what will be the result of the following FORTRAN 77 program? <c, Options are ⇒ (A) 2, (B) 2.1, (C) 21, (D) 21, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If KMT = 100, LITRES = 5.0, PCOST = 28.0 and OPCOST = 70.0 what will be the result of the following FORTRAN 77 program?
A.	2 [Wrong Answer]
B.	2.1 [Correct Answer]
C.	21 [Wrong Answer]
D.	21 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ SSI is used in flip flops.
TRUE
FALSE

⇒ For a periodic waveform, the power spectral density and correlation function form
a Laplace transform pair
a Fourier transform pair
either (a) or (b)
neither (a) nor (b)

⇒ In a waveguide the dielectric region is generally
air
magnetic material
brass
mica

⇒ Which of the following is/are correct statement(s)?

Bus is a group of wires carrying information.
Bus is needed to achieve reasonable speed of operation.
Bus can carry data or address.
A bus can be shared by more than one device.

Select the correct answer from the codes given below
1 only
1 and 2 only
2, 3 and 4 only
1, 2, 3 and 4

⇒ The ratio of the directivity of an end fire antenna to that of a broadside antenna is
2
3
4
5

⇒ Which of the following circuit does not need a coupling capacitor?
Resistance loaded
Transformer coupled
Impedance coupled
Single tuned

⇒ Which one of the following statement is correct?
Both Laplace's (L) and Poisson's (P) equation are non linear
L is non linear but P is linear
L is linear but P is non linear
L, P both is linear

⇒ In LED the radiation is in
visible region
infrared region
both (a) and (b)
neither (a) nor (b)

⇒ Addition of 0.3 to 3.5% silicon to iron
increases the electrical resistivity of iron
decreases the electrical resistivity of iron
does not change electrical resistivity of iron
silicon can't be added with iron

⇒ In figure we need an ac ground. The proper value of
1000 μF
100 μF
10 μF
1 μF

⇒ A voltage wave is i = 100 sin (ωt). Its average value calculated over one half cycle is
zero
70.72 V
63.70 V
none of the above

⇒

Match the following:

	List I		List II
A.	Resistance	1.	Current noise
B.	Diode	2.	Partition noise
C.	Triode	3.	Shot noise
D.	p-n junction	4.	Atmospheric noise
		5.	Johnson noise

A-5, B-3, C-2, D-1
A-1, B-2, C-3, D-5
A-3, B-5, C-1, D-2
A-3, B-5, C-2, D-1

⇒ Which of the following is active transducer?
Photoelectric
Photovoltaic
Photoconductive
Photoemissive

⇒ In a specimen of ferromagnetic material, as the flux density is increased from zero to 2.5 T, µ_r will
increase
decrease
first decrease then increase
first increase then decrease

⇒ Power gain of antenna equals directive gain in VHF and UHF range if and only if efficiency of the antenna is __________ .
0.25
0.5
0.75
1

⇒ The scale factor for half wave and full wave rectifier is __________ respectively.
1.11, 1.414
1.11, 1.57
1.57, 1.11
1.414, 1.11

⇒ In standard TTL the totem pole stage refers to
multiemitter input stage
phase splitter
output buffer
open collector output stage

⇒

Match the following:

	List I (Electron spin)		List II (Phenomenon)
A.	↑↑↑↑	1.	Antiferromagnetism
B.	↑↓↑↓	2.	Ferrimagnetism
C.	↑↓↑↓	3.	Ferromagnetism

A-1, B-2, C-3
A-3, B-2, C-1
A-2, B-3, C-1
A-3, B-1, C-2

⇒ Binary multiplication can be done by repeated addition.
TRUE
FALSE

⇒ The most common method for biasing a JFET is
reverse bias
self bias
voltage divider bias
none of the above

⇒ The depletion type MOSFET can operate in
depletion mode only
enhancement mode only
depletion or enhancement mode
neither depletion nor enhancement mode

⇒ The point P in the following figure is stock at 1. The output f wil
ABC
A
AB C
A

⇒ To obtain very high I/P and O/P impedances in a feedback amplifier, the topology used is
voltage series
current series
voltage shunt
current shunt

⇒ __________ will have the least value of relative permeability.
Palladium
Silver
Cobalt
Iron

⇒ The constellation diagram of a modem has four states as shown in the figure given below. What is the bit rate of this mod
Two times its band rate
Four times its band rate
Same as band rate
Sufficient information is not given to give the answer

⇒ A woofer should be fed from the input through a
low pass filter
high pass filter
band pass filter
band stop filter

⇒ When an atom of polarizability a is placed in an electric field E, the energy stored in atom is 0.5 a E².
TRUE
FALSE

⇒ The pinch-off voltage is the drain voltage on the shorted gate drain curve above which the drain current becomes
almost negligible
very high
almost constant
highly variable

⇒ Piezoelectricity means the slight change in dimensions of a specimen when an electric field is applied.
TRUE
FALSE

⇒ A moving iron instrument gives correct reading when used at
low frequencies
high frequencies
only one frequency
all frequencies upto a certain value