Question is ⇒ If input frequency is 50 Hz, the frequency of output wave in a half wave diode rectifier circuit is, Options are ⇒ (A) 25 Hz, (B) 50 Hz, (C) 100 Hz, (D) 200 Hz, (E) , Leave your comments or Download question paper.

Question is ⇒ If input frequency is 50 Hz, the frequency of output wave in a half wave diode rectifier circuit is, Options are ⇒ (A) 25 Hz, (B) 50 Hz, (C) 100 Hz, (D) 200 Hz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If input frequency is 50 Hz, the frequency of output wave in a half wave diode rectifier circuit is
A.	25 Hz [Wrong Answer]
B.	50 Hz [Correct Answer]
C.	100 Hz [Wrong Answer]
D.	200 Hz [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Above a certain temperature, the specific heat of a metal becomes constant. This temperature is called
Debye temperature
Curie temperature
Neel temperature
Transition temperature

⇒ Out of SAM and RAM
access time in both does not depend on address location
in SAM access time depends on address location but not in RAM
in RAM access time depends on address location but not in SAM
in both the access time depends on storage location

⇒ In a superheterodyne broadcast receiver, the frequency of local oscillator is __________ the incoming signal frequency.
higher than
lower than
equal to
not comparable to

⇒ One volt equals
one joule
one joule/coulomb
one coulomb/joule
none of the above

⇒ The circuit I in figur
1 mA
4 mA
8 mA
10 mA

⇒ For a high pass filter attenuation = 0 at f = 0.
TRUE
FALSE

⇒ 'WRITE' is a
Word processor
Line editor
Text editor
Column editor

⇒ The initial state of MOD-16 down counter is 011. After 37 clock pulses, the state of the counter will be
1011
110
101
1

⇒ If the energy is supplied from a source, whose resistance is 1 ohm, to a load of 100 ohms the source will be
a voltage source
a current source
both of the above
none of the above

⇒ The reverse saturation current of a diode does not depend on temperature.
TRUE
FALSE

⇒ The length of half-wave antenna is at 30 MHz
2.5 meter
5 meter
10 meter
100 meter

⇒ Consider the following ON GO TO statement in Ba
10, 20, 30, 20 respectively
10, 20, 20, 30 respectively
20, 30, 20, 10 respectively
10, 30, 20, 20 respectively

⇒ Which of the following element has four valence electrons?
Silicon
Germanium
Both (a) and (b) above
None of the above

⇒ In colour TV receiver, varactor diode is used for
detection
rectification
tuning
both (a) and (b)

⇒ The cut in voltages for germanium and silicon diodes respectively as
0.3 V and 0.7 V
0.7 V and 0.3 V
0.6 V and 0.9 V
0.5 V and 0.7 V

⇒ When a current flows through a conductor,
an electric field exists at all points within the conductor
electric field exists only at all points on the surface of the conductor
electric field exists only at ends of the conductor
any of the above depending on magnitude of current

⇒ In FM modulation pre-emphasis is done for
high frequency components
low frequency components
middle frequency components
both (a) and (b)

⇒ A moving iron instrument gives correct reading when used at
low frequencies
high frequencies
only one frequency
all frequencies upto a certain value

⇒ An insulator will conduct when the
voltage applied is more than the breakdown voltage
temperature is raised to very high level
either (a) or (b) above
none of the above

⇒ The number of spectral component of impulse wave is
1
0
2
∞

⇒ If the Q of a single-stage single-tuned amplifier is doubled, then its bandwidth will
remain same
become half
become doubled
become four times

⇒ The slope of log magnitude curve near the cut off frequency is called cut off rate.
TRUE
FALSE

⇒ If a class C power amplifier has an input signal with frequency of 200 kHz and the width of collector current pulses of 0.1 ms, then the duty cycle of the amplifier will be
0.01
0.02
0.1
0.2

⇒ Programmable logic array uses
RAM matrices
ROMs matrices
PROM matrices
Silo memory

⇒

Assertion (A): In TV scanning is done from left to right and top to bottom.

Reason (R): Interlaced scanning is useful in eliminating flicker

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The output of a full adder is
SUM
CARRY
SUM and CARRY
none of the above

⇒ Which of these has a magnetic brake?
Thermocouple ammeter
Energy meter
Dynamometer wattmeter
Frequency meter

⇒ In 8086 microprocessor, if the segment register contains 1 FAB and IP register contains 10AI, the effective memory address is
20B51
304C
FBC0
FDB5

⇒ Gray code is used in devices which convert analog quantities to digital signal because it is
more error free
much simpler than binary code
superior to Excess-3 code
absolutely error free

⇒ In a JFET V_DS exceeds the rated value. Then it operates in
active region
ohmic region
cut off region
either cut off or active region