Question is ⇒ If input ac is 10 V<sub>rms</sub>, then maximum voltage that will appear across the diode of a half wave rectifier with a capacitor I/P filter will be, Options are ⇒ (A) 10 V, (B) 14 V, (C) 20 V, (D) 28 V, (E) , Leave your comments or Download question paper.

Question is ⇒ If input ac is 10 V<sub>rms</sub>, then maximum voltage that will appear across the diode of a half wave rectifier with a capacitor I/P filter will be, Options are ⇒ (A) 10 V, (B) 14 V, (C) 20 V, (D) 28 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If input ac is 10 V_rms, then maximum voltage that will appear across the diode of a half wave rectifier with a capacitor I/P filter will be
A.	10 V [Wrong Answer]
B.	14 V [Correct Answer]
C.	20 V [Wrong Answer]
D.	28 V [Wrong Answer]
View Answer 9 -10 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Both sodium and ferrous are ferromagnetic.

Reason (R): Both sodium and ferrous have body centred cubic structure.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒

Match the following:

	List I (Transducer)		List II (Operation)
A.	Bourden tube	1.	Fluid flow to resistance change
B.	Hot wire ammeter	2.	Velocity to pressure
C.	Hydrometer	3.	Pressure to displacement
D.	Pitot tube	4.	Specific gravity to displacement

A-1, B-3, C-2, D-4
A-3, B-1, C-2, D-4
A-3, B-1, C-4, D-2
A-4, B-2, C-3, D-1

⇒ AB + AB =
B
A
1
0

⇒ A digital voltmeter can count from 0 to 9999. If full scale reading is 9.999 V, the resolution of full scale reading is
0.001
1000
2 digit
1 mV

⇒ In a megger the controlling torque is provided by
spring
gravity
coil
eddy current

⇒ Two ammeters A and B are connected in parallel in a circuit carrying 100 A. Their resistances are 0.8 mΩ. Their readings will be.
55.56 and 44.44 A respectively
44.44 A and 55.56 A respectively
60 A and 40 A respectively
40 A and 60 A respectively

⇒ When a coil consisting of single turn rotates at a uniform speed in a magnetic field, the induced e.m.f. is
changing
reversing
steady
alternating

⇒ In a normally biased N-P-N transistor the main current crossing the collector junction is
a drift current
a hole current
a diffusion current
same as the base current

⇒ The voltage gain of an amplifier without and with feedback are 100 and 20. The negative feedback is
0.04
0.05
0.2
0.8

⇒ End fire array is called a linear resonant dipole array.
TRUE
FALSE

⇒ In the given figure the input frequency is such that R << X_c,
v₀ lags v_i by 90°
v₀ leads v_i by 90°
v₀ and v_i are in phase
either (b) or (c)

⇒ "Micro-program" is
the name of the source program in microcomputer
the set of instructions indicating the primitive operations in 1 system
the general name of 'MACRO's' in assembly language programming
the name of programs of very small size

⇒ For BJT transistor. The maximum power dissipation is specified as 350 mW if ambient temperature is 25°C. If ambient temperature is 60°C the maximum power dissipation should be limited to about
100 mW
250 mW
450 mW
600 mW

⇒ A (75 - j 50) Ω load is connected to a coaxial line of Z₀ = 75 Ω at 10 GHz. The best method of matching consists of using
a capacitance at some specific distance from load
a short circuited stub at some specific distance from load
an inductance at load
a short circuited stub at load

⇒ Dolby system of noise reduction divides the total audio spectrum into
8 frequency bands
4 frequency bands
2 frequency bands
none of the above

⇒ BCD numbers are useful whenever
binary to hexadecimal conversion is desired
binary to BCD conversion is desired
decimal information is transferred into or out of a digital system
none of the above

⇒ Four messages band limited to W, W, 2W and 3W respectively are to be multiplex using Time Division Multiplexing (TDM). The minimum bandwidth required for transmission of this TDM signal is
W
3W
6W
7W

⇒ The wave applied to X plates, for ohtaining trace of voltage wave, is
sawtooth wave
sinusoidal wave
rectangular wave
either (a) or (c)

⇒ At present, the radio-frequency band mainly used by most satellites is
EHF
UHF
VHF
SHF

⇒ In a P-N-P transistor, with normal bias, the emitter junction
is always reverse biased
offers very high resistance
offers a low resistance
remains open

⇒ In the above case the total power in the modulated wave double sideband, suppressed carrier AM will be
112 W
400 W
415 W
512 W

⇒ The stator of phase shifting transformer for use in conjunction with an ac potentiometer has a
single phase winding
two phase winding
3 phase winding
either (a) or (c)

⇒ For the wave shown in figure, the average and rms values
50 A and 57.73 A
57.73 A and 50 A
25 A and 57.73 A
57.73 A and 70.7 A

⇒ IC 74181 has two select lines.
TRUE
FALSE

⇒ For type 1 system the velocity lag error is
inversely proportional to bandwidth of system
directly proportional to gain constant
inversely proportional to gain constant
independent of gain constant

⇒ In the context of error detection in satellite transmission, ARQ stands for
Automatic Repeat Request
Automatic Relay Request
Accelerated Recovery Request
Automatic Radiation Quenching

⇒ Which of the following instructions in 8085 does not belong to data transfer group?
LDA addr
STA addr
XCHG
SUB r

⇒ A class C amplifier has input frequency of 200 kHz. If width of collector pulses is 0.1 μs, duty cycle is
0.01
0.02
0.1
0.2

⇒ When ω_m is the modulation frequency in frequency modulation, the modulation index is proportional to
ω_m
ω²_m
1/ω_m
1/ω²_m

⇒ Which of the following does not cause losses in optical fibre cables?
Impurities
Microbending
Attenuation in glass
Stepped index operation