Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | If f_{1} and f_{2} and half-power frequency and f_{0} be resonant frequency, the selectivity of R-L-C series circuit is given by |

A. | (f_{2} - f_{1})/2f_{0} [Wrong Answer] |

B. | (f_{2} - f_{1})/f_{0} [Correct Answer] |

C. | (f_{2} - f_{0})/(f_{1} - f_{0}) [Wrong Answer] |

D. | (f_{2} - f_{1})/(f_{1} - f_{0}) [Wrong Answer] |

View Answer
Explanation:-
Answer : BDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ An AND gate has two inputs A and B and one inhibit input S. Out of total 8 input states, output is 1 in

1 state

2 states

3 states

4 states

⇒ For a level input sequential circuit

output in a level only

output is in the pulse form

output may be a pulse or a level form

none of these

⇒ Which of the following is invariably found in SSB?

Tuned modulator

Class B, RF amplifier

Class C, audio amplifier

All of the above

⇒ The relation between plate current and plate voltage of a vacuum diode is called

Richardson Dushman equation

Langmuir Child law

Ohm's law

Boltzmann's law

⇒ Giga watt is equal to

10

^{12}W

10

^{9}W

10

^{6}W

10

^{3}W

⇒ In the op-amp circuit of figure, V

_{0Vi3 Vi5 Vi0.5 Vi}

⇒

Match the following:

List I | List II | ||
---|---|---|---|

A. | 200 MHz | 1. | SHF |

B. | 20 GHz | 2. | UHF |

C. | 500 kHz | 3. | VHF |

D. | 500 MHz | 4. | MF |

A-3, B-1, C-4, D-2

A-3, B-2, C-4, D-1

A-3, B-4, C-1, D-2

A-3, B-4, C-2, D-1

⇒ In a klystron amplifier dc electron velocity is

*v*

_{0}and dc electron charge density is r

_{0}the dc beam current is

r

_{0}

*v*

_{0}

r

_{0}

^{/}

*v*

_{0}

*v*

_{0}

^{/}r

_{0}

(

*v*

_{0}

^{/}r

_{0})

^{2}

⇒ The force in a magnetic field is given by F =

*qv*B

F and

*q*are perpendicular and

*v*and B are perpendicular

F and

*q*only are perpendicular to each other

F and

*v*, F and B are mutually perpendicular to each other and

*v*and B at any angle between them

All the four components are perpendicular to each other

⇒ The voltage induced in a loop of wire rotating in a strong and steady magnetic field is

pulsating dc

dc

rectified ac

ac

⇒ It is required to study transients during switching process. Which CRO should be preferred?

Ordinary CRO

Dual beam CRO

Dual trace CRO

Storage oscilloscope

⇒ Measurement of an unknown voltage with a dc potentiometer loses its advantage of open circuit measurement when

the primary circuit battery is changed

standardization has to be done again to compensate for drifts

voltage is larger than range of the potentiometer

range reduction by a factor of 10 is employed

⇒ A carrier is phase modulated (PM) with frequency deviation of 10 kHz by a single tone frequency of 1 kHz. If the single tone frequency is increased to 2 kHz, assuming that phase deviation remains unchanged, the bandwidth of the PM signal is

21 kHz

22 kHz

42 kHz

44 kHz

⇒ In which frequency range is the noise figure in a transistor minimum

intermediate frequencies

low frequencies

high frequencies

very high frequencies

⇒ In a 100% amplitude modulated signal, the power in the upper sideband when carrier power is to be 100 W and modulation system SSBSC, is

100 W

66 W

50 W

25 W

⇒ An op-amp uses

RC coupling

direct coupling

transformer coupling

either (b) or (c)

⇒ The reactance of coupling capacitor for AC signals in an amplifier, should be

as low as possible

as high as possible

neither low nor high

either low or high

⇒ The main advantage of hexadecimal numbers is

ease of conversion from hexadecimal to binary and vice-versa

ease of conversion from hexadecimal to decimal and vice-versa

ease of conversion from gray code to binary and vice-versa

the use of numbers and alphabets

⇒ In a 7 segment display the segments

*a, c, d, f, g*are lit. The decimal number displayed will be

9

5

4

2

⇒ In the wave mechanical theory, the maximum of the charge distribution in the ground state occurs for a distance from the nucleus equal to

first Bohr radius

second Bohr radius

third Bohr radius

either first or second Bohr radius

⇒ A full wave bridge rectifier is supplied voltage at 50 Hz. The lowest ripple frequency will be

400 Hz

200 Hz

100 Hz

50 Hz

⇒ In TV transmitter some possible advantages of IF modulation are

- The modulator section and visual exciter can be solid state devices
- VSB filter can be introduced at low power level
- The subsequent stages following VSB filter can be tuned permanently for wideband linear operation
- It is economical

1 and 2

1, 2 and 3

2, 3 and 4

1, 2, 3 and 4

⇒ The input impedance for folded dipole antenna (two half dipole) is

73

*n*

^{2}

377

*n*

^{2}

73

*n*

377

*n*

⇒ The semiconductor diode which can be used in switching circuit in microwave range is

PIN diode

Varactor diode

Tunnel diode

Gunn diode

⇒ A line is excited by a 100 V dc source. If reflection coefficients at both ends are 1 each then

there will be no oscillations on line

there will be only 1 or 2 oscillations on line

there will be a finite number of oscillations on line

the oscillations will continue indefinitely

⇒ In the given circuit, viewed from AB, the circuit can be reduced to an equivalent circui

5 volts source in series with 10 Ω resistor

7 volts source in series with 2.4 Ω resistor

15 volts source in series with 2.4 Ω resistor

1 volt source in series with 10 Ω resistor

⇒ In an amplifier with a gain of - 1000 and feedback factor β = - 0.1, the change in gain is 20% due to temperature. The change in gain for feedback amplifier will be

0.1

0.05

0.002

0.0001

⇒ In single tone AM modulation, the transmission efficiency for

*m*= 1 is

0.333

0.5

1

0.1665

⇒ A 4 bit transistor register has output voltage of high-low-high-low. The binary number stored and its decimal equivalent are

0101 and 5

0101 and 10

1010 and 5

1010 and 10

⇒ Of the four INSAT-I satellites planned by India so for, only __________ has proved to be successful.

INSAT-IA

INSAT-IB

INSAT-IC

INSAT-ID