Question is ⇒ If f(t) ↔ F(jω), f(- t) ↔, Options are ⇒ (A) - F(jω), (B) F(- jω), (C) F(jω), (D) 0.5 F(jω), (E) , Leave your comments or Download question paper.

Question is ⇒ If f(t) ↔ F(jω), f(- t) ↔, Options are ⇒ (A) - F(jω), (B) F(- jω), (C) F(jω), (D) 0.5 F(jω), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If f(t) ↔ F(jω), f(- t) ↔
A.	- F(jω) [Wrong Answer]
B.	F(- jω) [Correct Answer]
C.	F(jω) [Wrong Answer]
D.	0.5 F(jω) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Helium, Argon and Neon are gaseous at room temperature.

Reason (R): The atoms in Helium, Argon and Neon are chemically extremely inactive.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Symbol shown in figure represen
P-channel DEMOSFET
N-channel DEMOSFET
UJT with N-type base
UJT with P-type base

⇒ Which of the following analog modulation scheme requires the minimum transmitted power and minimum channel bandwidth?
VSB
DSB-SC
SSB
AM

⇒ Resistivity of electrical conductors is most affected by
Pressure
temperature
composition
ageing

⇒ The rms value of wave in figur
about 95 V
about 80 V
about 50 V
about 25 V

⇒ MICR stands for
Magnetic Ink Chart Receipt
Magnetic Ink Character Recognition
Magnetic Ink Chart Recognition
Magnetic Ink Character Receipt

⇒ The maximum effective aperture of a microwave antenna which has a directivity of 900, will be
71.619 λ²
716.19 λ²
7161.9 λ²
71619 λ²

⇒ DMA stands for
Direct Memory Address
Distributed Memory Address
Direct Memory Accumulator
Decimal Machine Address

⇒ If the current in a capacitor leads the voltage by 80°, the loss angle of capacitor is
80°
10°
100°
170°

⇒

Assertion (A): A large negative feedback is deliberately introduced in an amplifier to make its gain independent of variation is in parameters of active device and other components.

Reason (R): A large negative feedback results in a high value of return difference compared to unity which makes the feedback gain inversely proportional to feedback factor.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ An ideal power supply has
zero internal resistance
very high internal resistance
high output resistance
both (b) and (c)

⇒ When we use RRC instruction once in 8085, the number is
multiplied by 2
divided by 2
multiplied by 4
divided by 4

⇒ The circuit show
voltage series feedback amplifier
transconductance amplifier
transresistance amplifier with open circuit mutual resistance R_F
transresistance amplifier with short circuit mutual resistance R_F

⇒ c(t) and m(t) are used to generate an AM signal. The modulation index of the generated AM signal is 0.5 then the quant
42737
42739
42738
42743

⇒ The modulation index of an FM is changed from 0 to 1. How does the transmitted power change?
Gets halved
Gets doubled
Gets increased by 50 percent
Remains unchanged

⇒ Two thyristor of same rating and same specifications
will have equal turn on and turn off periods
will have equal turn on but unequal turn off periods
may have equal or unequal turn on and turn off periods
will have unequal turn on and turn off periods

⇒ The receiver of a pulsed RADAR can detect signal power in the order of
1 W
0.1 W
10^-5 W
10^-12 W

⇒ A full adder is to be implemented using half adders and OR gates. A 4 bit parallel adder without any initial carry requires
8 half adders and 4 OR gates
8 half adders and 3 OR gates
7 half adders and 3 OR gates
7 half adders and 4 OR gates

⇒ Damping ratio =
actual resistance/critical resistance
critical resistance/actual resistance
critical resistance
none of the above

⇒ Which of the following amplifiers is used for impedance matching?
CE
CC
CB
Push pull

⇒ A 12 bit ADC is operating with 1 μs clock period. Total conversion time is 14 μs. ADC is
flash type
counting type
integrating type
successive approximation type

⇒ Two voltmeters are each 0-300 V range. Their internal resistances are 10 kΩ and 20 kΩ They are connected is series and a voltage of 400 V is applied. Their readings respectively will be
266.6 and 133.3 V
133.3 and 266.6 V
200 V each
100 and 300 V

⇒ An engineer designs an amplifier to have a voltage gain of 60, but when constructed it only had a gain of 50. What percentage of feedback will cause oscillations?
0.001
0.005
0.01
0.02

⇒ Which of the following terms are equivalent?

A ⊕ B ⊕ C
A ⊕ B ⊙ C
A ⊙ B ⊕ C
A ⊙ B ⊙ C

1 and 4; 2 and 3
1 and 3
2 and 3
1, 2 and 4

⇒ The bandwidth of an amplifier can be reduced by
miller effect compensation
pole zero compensation
dominant pole compensation
lead compensation

⇒ The function shown in figure, can represent a probability density function for A _______
A = 1/4
A = 1/6
A = 1/9
A = 1/2

⇒ In oscillator circuits the energy feedback to its input terminal from output is
always in phase with the input signal
90° out of phase with the input signal
180° out of phase with the input signal
270° out of phase with the input signal

⇒ For a P-N diode, the number of minority carriers crossing the junction depends on
forward bias voltage
potential barrier
rate of thermal generation of electron hole pairs
none of the above

⇒ For formation of state equations, the inductors and current sources
should be in tree
should be in cotree
may be in tree or cotree
should be in both tree and cotree

⇒ For dielectrics in alternating field, polarizability a_e is a complex quantity. The imaginary part of a_e is zero for
ω = 0
ω → ∞
ω = 0 and ω → ∞
ω = natural frequency ω₀