Question is ⇒ If e = 10 sin(108 t + 3 sin 104 t) then the modulation index is, Options are ⇒ (A) 1, (B) 2, (C) 3, (D) 4, (E) , Leave your comments or Download question paper.

Question is ⇒ If e = 10 sin(108 t + 3 sin 104 t) then the modulation index is, Options are ⇒ (A) 1, (B) 2, (C) 3, (D) 4, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If e = 10 sin(10⁸ t + 3 sin 10⁴ t) then the modulation index is
A.	1 [Wrong Answer]
B.	2 [Wrong Answer]
C.	3 [Correct Answer]
D.	4 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The multivibrator circuit that has a typical application of converting sinusoidal input into a square wave output is
emitter coupled binary
Schmitt trigger
monoshot multivibrator
free-running multivibrator

⇒ In a NOT gate the output is always the opposite of the input.
TRUE
FALSE

⇒ Fill in the suitable word in the blanks is the following questions. The electron in the outermost orbit is called __________ electron.
valence
covalent
acceptor
donor

⇒ In Java 31% gives an answer
3
4
42798
42828

⇒ Industrial heating furnaces such as arc and induction furnaces operate on __________ power factor
low leading
low lagging
high leading
very low lagging

⇒ If h₁[n] = 3δ[n] + δ[n - 1], h₂[n] = 2δ[n] + δ[n
{6, 18, 7, 4, 0, - 6, 9}
{9, 0, - 6, 21, 7, 6, 1}
{7, - 1, 3, 1, 7, 0, 6}
{9, - 6, 0, 1, 21, 7, 18, 6}

⇒ When a transistor is connected in common emitter mode, it with have
negligible input resistance and high output resistance
high input resistance and low output resistance
medium input resistance and high output resistance
low input resistance as well as output resistance

⇒ The maximum number of characters for variable names in C is
4
8
12
16

⇒ The real part of complex dielectric constant and tanδ for a dielectric are 2.1 and 5 x 10^-4 at 100 Hz respectively. The imaginary part of dielectric constant at 100 Hz is
1.05 x 10^-3
2.1 x 10^-3
5 x 10^-3
1.05 x 10^-2

⇒ Which are the pending interrupts?
5.5
6.5
7.5
None

⇒

Assertion (A): A dynamic RAM chip has much smaller cell than a static RAM chip.

Reason (R): In dynamic RAM one bit of information is stored as the charge on a capacitor.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The system of the given fi
is unstable for all values of K
is stable for all values of K
can be stable for some values of K
data is insufficient to determine stability

⇒ In the op-amp circuit of figure, V_{0V_i
3 V_i
5 V_i
0.5 V_i}

⇒ A short-circuit is that which is
used short pieces of wire
goes only a short distance
is used for dimming light
offer very low resistance path for current to flow

⇒ Thevenin's impedance of an ac network is in general
resistance
R and L in series
R and C in series
Either R and L or R and C in series

⇒ Ripple factor RF and form factor FF are related as
RF = FF² - 1
RF = (FF² - 1)^0.5
RF = FF - 1
RF = (FF - 1)^0.5

⇒ Which of the following is used to provide tracking between RF amplifier and local oscillator stages of receiver?
Variable tuning inductor
Ganged tuning inductor
Variable capacitor
Variable preset

⇒ Which of the following statements about the matched filter in a communication receiver are correct?

Its impulse response depends on the signed shape
It maximizes the SNR at the detection shape.
It produces ISI.
It may produce phase error if synchronization is improper.

Select the correct answer from the codes given below:
1 and 4 only
1 and 2 only
2, 3 and 4
1, 2 and 4

⇒ Two capacitors of 1 μF and 2 μF capacitance are connected in parallel across a 30 V dc battery. After the capacitors have been charged, the charges across the two capacitors will be
30 μC each
60 μC each
30 μC and 60 μC respectively
60 μC and 30 μC respectively

⇒ If e = 10 sin(10⁸ t + 3 sin 10⁴ t) then the modulation index is
1
2
3
4

⇒ When R and C are connected in parallel, phase angle of Y is positive.
TRUE
FALSE

⇒ The number of key words in C is
4
8
16
32

⇒ The spectral range of a band pass signal extends from 10 MHz to 10.4 MHz. What is the minimum sampling frequency required for reconstruction?
20 MHz
20.8 MHz
20.4 MHz
0.8 MHz

⇒ For a Hertz dipole antenna, the Half Power Beam Width (HPBW) in the E-plane is
360°
180°
90°
45°

⇒ In figure, i(t) is a unit step current. The steady state value of v(t
2 V
3 V
6 V
9 V

⇒ The frame of electric motor is connected to three plates having earthing resistance of 10 Ω, 20 Ω and 30 Ω respectively. The materials of the three plates are copper, aluminium and iron respectively. The percentage of energy dissipated by 10 Ω earthing plate
is more than 50% of total energy
is less than 50% of total energy
depends on the materials of the three plates
may be more or less than 50% of total energy

⇒ A thyristor has a turn on time of 6 μs. If the anode circuit is inductive, the turn on time will be
6 μs
less than 6μs
more than 6 μs
either 6 μs or less

⇒ In a zener diode
forward voltage rating is high
negative resistance characteristics exists
sharp breakdown occurs at low reverse voltage
none of the above

⇒ When a current source I is suddenly connected across a two terminal relaxed RC circuit at time t = 0, the voltage across the current source is shown in figure. The RC circui
a series combination of R and C
a parallel combination of R and C
a series combination of R and parallel combination of R and C
a pure capacitor

⇒ In the full adder, denoting Sum by S and carry by C
S = 1 when two or more inputs are unity
C = 1 when two or more inputs are unity
C = 1 when all the inputs are unity
S = 1 when all the inputs are unity