Question is ⇒ If e = 10 sin(108 t + 3 sin 104 t) then the deviation is, Options are ⇒ (A) 4.77 kHz, (B) 47.7 kHz, (C) 477 kHz, (D) 4770 kHz, (E) , Leave your comments or Download question paper.

Question is ⇒ If e = 10 sin(108 t + 3 sin 104 t) then the deviation is, Options are ⇒ (A) 4.77 kHz, (B) 47.7 kHz, (C) 477 kHz, (D) 4770 kHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If e = 10 sin(10⁸ t + 3 sin 10⁴ t) then the deviation is
A.	4.77 kHz [Wrong Answer]
B.	47.7 kHz [Correct Answer]
C.	477 kHz [Wrong Answer]
D.	4770 kHz [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A carry look ahead adder is frequently used for addition because
it costs less
it is faster
it is more accurate
is uses fewer gates

⇒ In a superheterodyne receiver, the IF stage has better selectivity than RF stage because
of higher frequency
of lower frequency
of high L/C ratio
of constant passband

⇒

Match the following:

	List I (Operator)		List II (Description)
A.	? :	1.	Modulus
B.	[ ]	2.	Array expression
C.	%	3.	Conditional

A-3, B-2, C-1
A-1, B-2, C-3
A-1, B-3, C-2
A-2, B-3, C-1

⇒ Noise generated in a resistor is also known as
partition noise
white noise
thermal noise
shot noise

⇒ The area of an impulse is
1
0
∞
any finite value

⇒ In a TWT the axial component of electric field advances along the tube
at a velocity that is almost equal to speed of light
at a velocity that is a small fraction of speed of light
at a velocity that is about 50% of speed of light
at a velocity that may be even more than speed of light

⇒ In a computer the instructions, data, intermediate and final results during processing are held in ALU.
TRUE
FALSE

⇒ The following components are used to measure power output of a 2 kW TWT amplifier

TWT
Low pass/High pass filter
Low power 20 dB attenuator
40 dB directional coupler with matched load
Power meter.

The correct sequence of connections of these components is:
1, 4, 2, 3, 5
1, 3, 4, 2, 5
1, 2, 4, 3, 5
1, 4, 3, 2, 5

⇒ The leakage current in CB configuration may be around
few micro amperes
few hundred micro amperes
few milliamperes
few hundred milliamperes

⇒ Two messages m₁, and m₂ have a probability of 0.5 each. The entropy is
0.25
0.5
0.75
1

⇒ The circuit of the given figure
full adder
full subtractor
shift register
decade counter

⇒ Consider a random noise voltage which has a uniform density function as shown in the figure and is known to be wh
2 bits/reading
5 bits/reading
10 bits/reading
none of these

⇒ Automobile ignition systems use the principle of
resistance
self inductance
mutual inductance
capacitance

⇒ In figure the phase
will be 90° at ω = 0 and 0° at ω = ∞
will be 0° at ω = 0 and 90° at ω = ∞
will be 45° at ω = 0 and 0° at ω = ∞
will be 45° at ω = 0 and 90° at ω = ∞

⇒ In the case of the circuit shown in the figure V_io = 10 mV dc maximum, the maximum possible output offset voltage V_oo caused by the input offset voltage V_io with respect to groun
60 mV dc
110 mV dc
130 mV dc
150 mV dc

⇒ The shot circuit admittance matrix of a two port network is
non-reciprocal and passive
non-reciprocal and active
reciprocal and passive
reciprocal and active

⇒ Hari (H), Gita (G), Irfan (I) and Saira (S) are sibiligs (i.e. brothers and sisters). All were born on 1st January. The age difference between any two successive siblings (that is born one after another) is less than 3 years. Given the following fa
HSIG
SGHI
IGSH
IHSG

⇒ The static characteristic of an adequately forward biased p-n junction is a straight line if the plot is of
log I vs log V
log I vs V
I vs log V
I vs V

⇒ Which of the following is not considered as a useful quantity in comparing noise performance of receivers?
Noise temperature
Noise figure
Noise resistance
Input noise voltage

⇒ The number of valence electrons in silicon atom is
4
2
1
zero

⇒ In N channel MOSFET with gate reverse biased, the gate current is of the order
10^-3 amp
10^-6 amp
10^-9 amp
10^-12 amp

⇒

Match the following:

	List I		List II
A.	Fourier transform of a Gaussian function	1.	Gaussian function
B.	Convolution of a rectangular pulse with itself	2.	Rectangular pulse
C.	Current through inductor for step input voltage	3.	Triangular pulse
		4.	Ramp function
		5.	Zero

A-1, B-2, C-3
A-2, B-4, C-5
A-1, B-3, C-4
A-2, B-3, C-5

⇒ A function of one of more variables which conveys information on the nature of physical phenomenon is called
Noise
Interference
System
Signal

⇒ The Nyquist plot of a stable, transfer function G(s) is shown in the figure. We are interested in the stability of the closed loop system in the feedback configuration sh
6 dB and 180°
3 dB and 180°
6 dB and 90°
3 dB and 90°

⇒ The PIV of a bridge rectifier is less than that of full wave rectifier with centre tapped transformer.
TRUE
FALSE

⇒ Which of the following is not a special purpose peripheral?
Programmable DMA controller
Programmable Floppy disc controller
Programmable Hard disc controller
Programmable CRT controller

⇒ A FET is a better clapper than a BJT because it has
lower off-set voltage
higher series ON resistance
lower input current
higher input impedance

⇒

Assertion (A): The part of root locus on the real axis is not dependent on the poles and zeros which are not on the real axis.

Reason (R): Poles and zeros which are not on the real axis occur in conjugate pairs

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The transconductance curve of a JFET is
a straight line
parabolic
hyperbolic
inverted V-type

⇒ The braking torque in single phase energy meter is proportional to speed of disc.
TRUE
FALSE