Question is ⇒ If a and b are the width and height of rectangular wave-guide the cut off wavelength λc for TE20 mode is equal to, Options are ⇒ (A) a, (B) a + b, (C) a - b, (D) a2 + b2, (E) , Leave your comments or Download question paper.

Question is ⇒ If a and b are the width and height of rectangular wave-guide the cut off wavelength λc for TE20 mode is equal to, Options are ⇒ (A) a, (B) a + b, (C) a - b, (D) a2 + b2, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If a and b are the width and height of rectangular wave-guide the cut off wavelength λ_c for TE₂₀ mode is equal to
A.	a [Correct Answer]
B.	a + b [Wrong Answer]
C.	a - b [Wrong Answer]
D.	a² + b² [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A heterodyne frequency changer is called a
Modulator
Mixer
Demodulator
Frequency translator

⇒ A network contains only independent current source and resistors. If the values of all resistors are doubled, the value of the node voltage
will become half
will remain unchange
will become one third
cannot be determined unless the circuit configuration and the values of the resistors are known

⇒ A material which is lightly repelled by a magnetic field is known as
diamagnetic material
non-magnetic material
ferromagnetic material
paramagnetic material

⇒

Assertion (A): A higher level language is less efficient that machine language but more efficient than assembly language.

Reason (R): It is easier to learn and use higher level language than machine language.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which of these has degenerate p and n materials?
Zener diode
PIN diode
Tunnel diode
Photo diode

⇒ With regard to a transmission line, which of the following statements is correct?
Any impedance repeats itself every 1/4 on the Smith chart.
The S.W.R. = 2 circle and the magnitude of reflection coefficient = 0.5 circle coincide on the Smith chart.
At any point on a transmission line, the current reflection coefficient is the reciprocal of the voltage reflection coefficient.
Matching eliminates the reflected wave between the source and the matching device location.

⇒ Capacitance hats are installed on low frequency antenna is
increase the electrical length
reduce the electrical length
protect against lightening
protect against corona effects

⇒ The ripple factor from a capacitor filter __________ as the load resistance __________ .
decreases, decreases
decreases, increases
increases, decreases
increases, increases

⇒ Reciprocity theorem is applicable to
circuits with one source
circuits with only one independent source
circuits with any number of sources
circuits with any number of independent sources

⇒ In a self bias circuit for CE amplifier, an increase in emitter resistance R_E results in
increase in emitter voltage
decrease in emitter voltage
increase in emitter current
decrease in emitter current

⇒ A sample of N-type semiconductor has electron density of 6.25 x 10¹⁸/cm³ at 300k. If the intrinsic concentration of carriers in this sample is 2.5 x 10¹³/cm³ at this temperature the hole density works out to be
10⁶/cm³
10⁸/cm³
10¹⁰/cm³
10^l2/cm³

⇒ For the logic circuit shown in figure, the simplified Boolean expression for the output
A + B + C
AB
B
C

⇒

Assertion (A): Boolean expressions can be easily simplified using Karnaugh map.

Reason (R): Karnaugh map can be drawn for minterms as well as max terms.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In which mode of BJT operation are both junctions forward biased?
Active
Saturation
Cut off
Reverse active

⇒ If the energy gap of a semiconductor is 1.1 eV, then it would be.
opaque to the visible light
transparent to the visible light
transparent to the ultraviolet radiation
opaque to the infrared radiation

⇒ In a series operated thyristor configuration, each thyristor should support 100 V. However, the three thyristors only support voltage of 100 V, 90 V and 85 V respectively. Hence, the string efficiency in the case is :
0.9845
0.4584
0.9167
none of these

⇒ A ground wave travels along surface of ground.
TRUE
FALSE

⇒ An 8 bit wide 4 word sequential memory has
Eight 4 bit shift registers
Eight 8 bit shift registers
Four 8 bit shift registers
Foui 4 bit shift registers

⇒ The 2732 is 4096 x 8 EPROM. How many address lines does it have?
12
24
50
100

⇒ In Z_RC(s) has a pole at s = 0, the first element in second Foster realization is
R
C
R and C in series
R and C in parallel

⇒ In a 4 bit ripple counter using flip flops with t_pd = 40 ns, the maximum frequency can be
1.25 MHz
3.25 MHz
6.25 MHz
12.5 MHz

⇒ Electromagnetic waves transport
energy only
momentum only
energy as well as momentum
neither energy nor momentum

⇒ Audio frequency range lies between
20 Hz and 20 kHz
20 kHz and 20 MHz
2 MHz and 20 MHz
20 MHz and 200 MHz

⇒ For the circuit shown in the following figure I₀-I₃ are inputs to the 4:1 multiplexer R(MSB) and S are control
PQ + PQ S + Q R S
P Q + PQ R + P Q S
P Q R + P QR + PQRS + Q R S
PQ R + PQR S + P Q R S + Q R S

⇒ A single phase cycloconverter feeds a resistance heating load. The heating power is provided by
only the fundamental component of output wave
only higher harmonics in the output wave
both fundamental and higher harmonics in the output wave
either (a) or (b)

⇒ Two resistances are : R₁ = 36 Ω ± 1.89 Ω and R₂ = 75 Ω ± 3.75 Ω. The sum R₁ + R₂ along with limiting error is
111 Ω ± 1.8 Ω
111 Ω ± 3.75 Ω
111 Ω ± 5.55 Ω
111 Ω ± 1.95 Ω

⇒ For the collector-feedback amplifier shown below the voltage gain A_v will be _________
-113.07
-103.07
-107.07
-93

⇒ A data signal having frequency components from dc to 50 Hz is to be sent through pulse code modulation using an 8 digit code. The minimum carrier channel bandwidth is
1 kHz
2 kHz
4 kHz
8 kHz

⇒ In asynchronous TDM, for n signal sources, each frame contains m slots, where m is usually
Less than n
2n
n
greater than 2n

⇒

Assertion (A): In direct addressing the address of operand is specified in the instruction.

Reason (R): Direct addressing is also called absolute addressing.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct