Question is ⇒ If a and b are the dimensions of waveguide then, Options are ⇒ (A) a = 3b, (B) a = 2b, (C) a = b, (D) a = b/4, (E) , Leave your comments or Download question paper.

Question is ⇒ If a and b are the dimensions of waveguide then, Options are ⇒ (A) a = 3b, (B) a = 2b, (C) a = b, (D) a = b/4, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If a and b are the dimensions of waveguide then
A.	a = 3b [Wrong Answer]
B.	a = 2b [Correct Answer]
C.	a = b [Wrong Answer]
D.	a = b/4 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Temperature control of the passenger compartment of car uses both feed forward and feedback controls.

Reason (R): Feed forward control gives corrective action before the disturbance affects the output and feedback control applies corrective action after output changes.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Which of the following statement about the photo electric emission is incorrect?
The maximum velocity of emission varies with the frequency of incident light
The maximum velocity of emission varies with the intensity of light
The amount of photoelectric emission is directly proportional to the intensity of light
The quantum yield depends on the frequency and not the intensity of incident light

⇒

Assertion (A): Intrinsic semiconductor is an insulator at 0 K.

Reason (R): Fermi level in intrinsic semiconductor is in the centre of forbidden energy band.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The widely used binary multiplication method is
repeated addition
add and shift
shift and add
any of the above

⇒ Figure given below shows the internal schematic of a TTL AND-OR Invert (AOI) gate, For the input shown in the given figure, the output
0
1
AB
AB

⇒ The network shown in the figure represen
band pass filter
low pass filter
high pass filter
band stop filter

⇒ In a communication system, a process in which statistical averages and time averages are equal is called as,
stationary
ergodic
Gaussian
BIBO stable

⇒ Read the following statements

The circuitry of ripple counter is more complex than that of synchronous counter.
The maximum frequency of operation of ripple counter depends on the modulus of the counter.
The maximum frequency of operation of synchronous counter does not depend on the modulus of the counter.

Which of the above statements are correct?
1 only
1, 2
1, 2, 3
2, 3

⇒ Consider a parallel plate capacitor being charged. Identify the incorrect statements
Energy stored in the capacitor does not enter it through the connecting wires but through the space around the wires and plates uf capacitor
Rate at which energy flows into this volume is equal to the integration of the Poynting vector over the boundary of the volume between the plates.
The Poynting vector points everywhere radially outward of the volume between the plates
The Poynting vector points everywhere radially into the volume between the plates.

⇒ When a p-n junction is reverse biased
holes and electrons move away from the junction
holes and electrons move towards the junction
holes move towards junction and electrons move away from junction
holes move away from junction and electrons move towards junction

⇒

Match the following:

	List I (Characteristic equation)		List II (Degree of damping)
A.	s² + 15s + 56.25	1.	Undamped
B.	s² + 5s + 6	2.	Underdamped
C.	s² + 20.25	3.	Critically damped
D.	s² + 4.55s + 42.25	4.	Overdamped

A-1, B-2, C-3, D-4
A-2, B-3, C-1, D-4
A-3, B-4, C-1, D-2
A-1, B-2, C-4, D-3

⇒ A carrier is phase modulated (PM) with frequency deviation of 10 kHz by a single tone frequency of 1 kHz. If the single tone frequency is increased to 2 kHz, assuming that phase deviation remains unchanged, the bandwidth of the PM signal is
21 kHz
22 kHz
42 kHz
44 kHz

⇒ Ionospheric storm causes an abnormal decrease in the critical frequency.
TRUE
FALSE

⇒ The boundary conditions at the interface between two dielectrics in an electric field are given by
D_normal = 0, E_tangential = 0
D_normal = 0, E_normal = 0
D_tangential = 0, E_tangential = 0
D_tangential = 0, E_normal = 0

⇒ Eddy current loss is
proportional to frequency
independent of frequency
proportional to (frequency)²
proportional to (frequency)³

⇒ Triatics are
small height antenna directly mounted on jeeps, ships, etc.
the towers or masts which are used as radiators
the towers or masts which are not used as radiators
supports for antenna conductors.

⇒

Assertion (A): The main use of Miller integrator is to generate ramp

Reason (R): An inverting amplifier can handle more than one input at the same time.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The power required to produce a gain of 10 dB over 4 W of original power is __________ watt.
80
40
0.4
8

⇒

Assertion (A): RF tuner is called front end of TV receiver

Reason (R): RF tuner receives the TV signal and selects the required channel.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The compensator of the given figure
lag compensator
lead compensator
lag-lead compensator
none of the above

⇒ Which of the following can be used for measuring capacitance?
De sauty bridge
Maxwell's bridge
Anderson bridge
Hay's bridge

⇒ When the ac base voltage in a CE amplifier circuit is too high, the ac emitter current is
zero
constant
alternating
distorted

⇒ A moving coil meter has a resistance of 50 ohms and a full scale deflection current of 20 mA. To convert it into a voltmeter of 0-100 V range, the series resistance should be
5000 Ω
5050 Ω
4950 Ω
505 Ω

⇒ The gain of collinear arrays is maximum when the spacing between the elements is
0.1 λ to 0.3 λ
0.3 λ to 0.9 λ
0.5 λ to 0.7 λ
0.7 λ to 0.9 λ

⇒ The effect of earth's magnetic field on radiowaves is minimum when
the electric field lines of radio waves and flux line of earth's magnetic field are in the same direction
the electric field lines of radio waves and flux lines of earth's magnetic field are at right angles
the electric field lines of radiowaves and flux lines of earth's magnetic field oppose each other
both (b) and (c)

⇒ The probability of recombination of electrons and holes in a semiconductor is proportional to
density of electrons
density of holes
density of electrons and holes
none of the above

⇒ In a cycloconverter it is possible to vary
only output frequency
only output voltage
both output voltage and frequency but not simultaneously
both output voltage and output frequency simultaneously

⇒ CE mode input V-I characteristic can be shown by a plot of
V_BE versus i_B for constant values of V_CE
V_CB versus i_C for constant values of I_E
V_CE versus i_E for constant values of V_EB
V_CE versus i_E for constant values of V_CE

⇒ A fully charged mobile phone with a 12 V battery is good for a 20 minute talktime. Assume that, during the talk time, the battery delivers a constant current of 2 A and its voltage drops linearly from 12 V to 10 V as shown in the figure. How much energy does the battery deliver during this talk t
220 J
12 kJ
13.2 kJ
14.4 kJ

⇒ When an electron rises through a potential of 100 V it will acquired an energy of
100 eV
100 Joules
100 ergs
100 x 10^-6 Newtons