Question is ⇒ If γ = (S0/N0)/(Si/Nm) where S0 and S1 are signal power output and signal power input and N0 and Nm are noise power output and noise power input, the value of γ for SSB-SC and DSB-SC amplitude modulated system respectively are, Options are ⇒ (A) 1 and 1, (B) 1 and 2, (C) 2 and 1, (D) 0.5 and 0.5, (E) , Leave your comments or Download question paper.

Question is ⇒ If γ = (S0/N0)/(Si/Nm) where S0 and S1 are signal power output and signal power input and N0 and Nm are noise power output and noise power input, the value of γ for SSB-SC and DSB-SC amplitude modulated system respectively are, Options are ⇒ (A) 1 and 1, (B) 1 and 2, (C) 2 and 1, (D) 0.5 and 0.5, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If γ = (S₀/N₀)/(S_i/N_m) where S₀ and S₁ are signal power output and signal power input and N₀ and N_m are noise power output and noise power input, the value of γ for SSB-SC and DSB-SC amplitude modulated system respectively are
A.	1 and 1 [Correct Answer]
B.	1 and 2 [Wrong Answer]
C.	2 and 1 [Wrong Answer]
D.	0.5 and 0.5 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In PCM the amplitude levels are transmitted in a 7 unit code. Sampling frequency is 10 kHz. The bandwidth should be
5 kHz
35 kHz
70 kHz
5 MHz

⇒ Consider the following: Energy storage capability of basic passive elements is due to the fact that

resistance dissipates energy
capacitance stores energy
inductance dissipates energy

Which of the above is/are correct?
1, 2, and 3
1 and 3
3 only
1 and 2

⇒ A parallel connection of circuit is at below resonance circuit behave as
RC circuit
RL
RLC
resistive only

⇒ A voltage V(t) which is a Gaussian ergodic random process with a mean of zero and a variance of 4 volt² is measured by a true rms meter. The reading will be
0
4
2
16

⇒ A boot strap generally incorporates
CB configuration
CE configuration
emitter follower
none of the above

⇒ In FORTRAN 77 FLOAT (-28) gives the value
28
-28
-28
none of the above

⇒ To produce p type semiconductor we add
acceptor atoms
donor atoms
pentavalent impurity
trivalent impurity

⇒ In the given figure the line voltage after a number of reflections wil
30 V
-30 V
10 V
-10 V

⇒ If N = 196, the result of the following program will be 196
16
16
196

⇒ Half wave sysmmetry means f(t) = - f(t ± T/2).
TRUE
FALSE

⇒ In cell phone antennas are
monopole
loops
helical
lens

⇒ As the firing of a thyristor is delayed, the output voltage of a controlled rectifier decreases.
TRUE
FALSE

⇒ A sinusoidal current having peak value of 7.07 A is superimposed on dc of 5A. If a hot-wire ammeter is used to measure the combined current in the circuit, it will indicate __________ ampere.
7.07
10
12.07
2.07

⇒ Ideally an attenuator pad should not change
voltage level
impedance level
power level
voltage, power or impedance level

⇒ Consider the instructions

MOV M, B
OUT 4
LDAX

Which of the above require memory write cycle?
1, 2, 3
1 and 2 only
1 and 3 only
2 and 3 only

⇒ Which of the following amplifiers has a voltage gain of less than 1?
CE
CC
CB
CE or CB

⇒ For the amplifier in figure, β = 800. The mid-band voltage gain V₀/V_{i0
< 1
≈ 1
800}

⇒ Consider the following in C

Arithmetic operations can be performed on ints.
Arithmetic operations can be performed on floats.
Arithmetic operation can be performed on chars

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ The type of feedback in the following circuit diag
Voltage shunt
Current-shunt
Voltage series
Current series

⇒ An R-L circuit has an initial current of 5 A. In the s-domain equivalent circuit, the voltage source to take into account the initial current has a strength of
5L volts
5/L volts
5L² volts
5/L² volts

⇒

Assertion (A): JFET is a voltage controlled device.

Reason (R): The drain current can be controlled by controlling V_GS.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In an R-L circuit, the impedance is 30 Ω at a frequency of 100 Hz. At 200 Hz, the impedance should be
30 Ω or more
60 Ω or more
15 Ω or less
more than 30 Ω but less than 60 Ω

⇒ Which of the following is equivalent to AND-OR realization?
NAND-NOR
NOR-NOR
NOR-NAND
NAND-NAND

⇒ In an LC immittance H (s)
the slope of dH (jω)/dω is always negative
the slope of dH (jω)/dω is always positive
the slope of dH (jω)/dω may be positive or negative
the slope of dH (jω)/dω is constant

⇒ A doped semi-conductor is called
impure semi-conductor
dipole semi-conductor
bipolar semi-conductor
extrinsic semi-conductor

⇒ A Varactor diode has
a fixed capacitance
a fixed inductance
a voltage variable capacitance
a current variable inductance

⇒ Some advantages of optical fibre cables are

small diameter
Immunity to cross talk and EM interference
Laser and LED modulation methods lend themselves ideally to digital operation

Which of the above are correct?
1 only
1 and 2
1, 2, 3
2, 3

⇒ For any test point s on the real axis, the sum of angular contributions of the complex conjugate poles is
90°
180°
270°
360°

⇒ The total bandwidth needed for an AM signal at 55.25 MHz with 0.5 MHz video modulation is
0.25 MHz
0.5 MHz
1 MHz
10 MHz

⇒

Match the following:

	List I		List II
A.	Resistance	1.	M^-1L^-2T⁴I²
B.	Inductance	2.	ML²T^-2I^-2
C.	Capacitance	3.	ML²T^-3I²

A-1, B-2, C-3
A-2, B-1, C-3
A-2, B-3, C-1
A-3, B-2, C-1