Question is ⇒ If Ey is the voltage applied to Y plates, the vertical deflection of beam is proportional to, Options are ⇒ (A) Ey, (B) Ey, (C) Ey1.5, (D) Ey2, (E) , Leave your comments or Download question paper.

Question is ⇒ If Ey is the voltage applied to Y plates, the vertical deflection of beam is proportional to, Options are ⇒ (A) Ey, (B) Ey, (C) Ey1.5, (D) Ey2, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If E_y is the voltage applied to Y plates, the vertical deflection of beam is proportional to
A.	E_y [Correct Answer]
B.	E_y [Wrong Answer]
C.	E_y^1.5 [Wrong Answer]
D.	E_y² [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Bridge circuits using RTD in temperature measurement usually employ 3 lead system so as to obtain
higher sensitivity
better impedance matching
compensation for signal wire resistance
reduction in power consumption

⇒ The slope of log magnitude asymptote changes by - 40 dB/ decade at a certain frequency and the error between asymptote and actual curve is - 6 dB. This means that
a double pole is present
a pair of complex conjugate poles is present
either a double pole or a pair of complex conjugate poles is present
either a pole or zero at that frequency is present

⇒ Denominator polynomial of a transfer function of certain network
stable
oscillatory
unstable
depends on numerator polynomial

⇒

Assertion (A): The reverse current in a p-n junction is nearly constant.

Reason (R): The reverse breakdown voltage of a p-n diode depends on the extent of doping.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The slope of the transfer characteristics of an N-channel JFET is
positive
negative
constantly varying
zero

⇒ For the power amplifier circuit shown below, the maximum power dissipated by both output transisto
9.66 W
30.11 W
31.66 W
33.66 W

⇒ In 8085 microprocessor, what is the length of SP (stack) pointer?
6 bits
8 bits
12 bits
16 bits

⇒ The total field developed by an antenna array at a distant point is
phasor sum of fields produced by individual antennas of the array
algebraic sum of fields produced by individual antennas of the array
either (a) or (b) depending on type of array
neither (a) nor (b)

⇒ In an electrochemical process the mass of material deposited at an electrode is proportional to
time for which current is passed
magnitude of current
electric charge through the electrolyte
none of the above

⇒ A series circuit has fixed resistance and variable reactance. The impedance locus will be a straight line parallel to Y-axis.
TRUE
FALSE

⇒

Assertion (A): In an R-L circuit having low resistance, current lags the voltage by nearly 90°.

Reason (R): Power factor of a series RL circuit is R/Z.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The action of bellows is similar to that of
mass
viscous friction
spring
none of the above

⇒

Assertion (A): The amount of photoelectric emission depends on the intensity of incident light.

Reason (R): Photo electric emission can occur only if frequency of incident light is less than threshold frequency.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Solution of Laplace equations, which are continuous through the second derivative, are called
bessel functions
odd functions
harmonic functions
fundamental functions

⇒ Load Z_L for maximum power transfe
R
R + jωL
R - jωL
none

⇒ An MTI compares a set of received echos with those received during the previous sweep.
TRUE
FALSE

⇒ In a simple on-off controller with differential gap, the magnitude of differential gap determines
the level of accuracy
the life of controller
both (a) and (b)
neither (a) nor (b)

⇒ For the logic circuit shown in figure, the simplified Boolean expression for the output
A + B + C
AB
B
C

⇒ The filter circuit for feeding a wooffer has
an inductance in series and capacitance in parallel
a capacitance in series and an inductance in parallel
a resistance in series and an inductance in parallel
an inductance in series and a resistance in parallel

⇒ The block diagram of the given figure
On-off controller
On-off controller with differential gap
On-off controller with integral gap
Three position controller

⇒

Assertion (A): A complicated waveform can be replaced by sum or difference of two or more waveforms.

Reason (R): The method of superposition is applicable only to linear systems.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): Negative feedback reduces the gain of an amplifier

Reason (R): Negative feedback is very commonly used in amplifier circuits

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ With regard to a transmission line, which of the following statements is correct?
Any impedance repeats itself every 1/4 on the Smith chart.
The S.W.R. = 2 circle and the magnitude of reflection coefficient = 0.5 circle coincide on the Smith chart.
At any point on a transmission line, the current reflection coefficient is the reciprocal of the voltage reflection coefficient.
Matching eliminates the reflected wave between the source and the matching device location.

⇒ A cycloconverter for single phase operation has
one positive group and one negative group converters
two positive group and two negative group converters
three positive group and three negative group converters
any of the above

⇒ A capacitor having capacitance C is raised to voltage V. The energy stored will be
CV²
V²/C
0.5 V²C
0.5 C²V

⇒ The output V₀ in figur
-100 V
-100 mV
10 V
10 mV

⇒ A Yagi antenna has a driven antenna
only
with a reflector
with one or more directors
with a reflector and one or more directors

⇒ The circuit in figur
CE amplifier
CB amplifier
Constant voltage source
Constant current source

⇒ What is the purpose of using ALE signal high?
To latch low order address from bus to separate A₀ - A₇ lines
To latch data D₀ - D₇ from bus to separate data bus
To disable data bus latch
All of the above

⇒ Which of the following is not an omnidirectional antenna?
Log periodic
Half-wave dipole
Discone
Marconi