Question is ⇒ If D, G and η denote the directly, power gain and efficiency of an antenna, then which of the following relation holds :, Options are ⇒ (A) DGη = 1, (B) η = DG, (C) D = ηG, (D) D = G/η, (E) , Leave your comments or Download question paper.

Question is ⇒ If D, G and η denote the directly, power gain and efficiency of an antenna, then which of the following relation holds :, Options are ⇒ (A) DGη = 1, (B) η = DG, (C) D = ηG, (D) D = G/η, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If D, G and η denote the directly, power gain and efficiency of an antenna, then which of the following relation holds :
A.	DGη = 1 [Wrong Answer]
B.	η = DG [Wrong Answer]
C.	D = ηG [Wrong Answer]
D.	D = G/η [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ "Micro-program" is
the name of the source program in microcomputer
the set of instructions indicating the primitive operations in 1 system
the general name of 'MACRO's' in assembly language programming
the name of programs of very small size

⇒ In a series R, L, C circuit the impedance triangle is the same when X_L < X_C and X_L > X_C .
TRUE
FALSE

⇒ State transition table and state transition diagram form part of design steps for
combinational circuits
sequential circuits
delay circuits
all of the above

⇒ Consider the following DO statement in FORTRAN 77 7
6
1
8

⇒ In a bipolar transistor at room temperature if the emitter current is doubled the voltage across its base emitter junction
doubles
halves
increase by about 20 mV
decrease by about 20 mV

⇒ A 4 bit shift register is initialized to value 1000 for (Q₃, Q₂, Q₁, Q₀). The D input is derived from Q₀, Q₂ and Q₃ through two XOR gates as shown in figure. The pattern 1000 will appea
3rd pulse
7th pulse
6th pulse
4th pulse

⇒ In the circuit of the given figure, V_{05 V
3.1 V
2.5 V
0}

⇒ If a sample of Ge and a sample of Si have the same impurity density are kept at room temperature
both will have equal value of resistivity
both will have equal - ve of resistivity
resistivity of germanium will be higher than that of silicon
resistivity of silicon will be higher than of Ge

⇒

Match the following:

	List I (BJT amplifier)		List II (Characteristics)
A.	CE	1.	good voltage gain, good current gain
B.	CC	2.	voltage gain less than 1, high current gain
C.	CB	3.	current gain less than 1, voltage gain high

A-1, B-2, C-3
A-1, B-2, C-3
A-3, B-1, C-2
A-3, B-2, C-1

⇒ For the K map of the given figure, the simplified Boolean expressio
A C + A D + ABC
A B D + BC
A C D + AC
A C D + AC + BC

⇒ A dielectric material must be
insulator
good conductor
resistor
semiconductor

⇒ The essential condition for antenna array to be linear is that
individual antennas of the array must be of equal size
individual antennas of the array must be equally spaced along a straight line
any two individual antennas of the array must not be in the same direction
none of the above

⇒ Complex pole in z-plane is as shown below. This is the pole diagram for ________
Decaying sinusoidal sequence
Growing sinusoidal sequence
Decaying non sinusoidal sequence
Growing non sinusoidal sequence

⇒ A rectangular waveguide is a
rectangular conducting wire to propagate electromagnetic waves
hollow rectangular walled room carrying electromagnetic wave
hollow rectangular conducting tube through which electromagnetic waves can be propagated
tube antenna to transmit and receive electromagnetic waves

⇒ Virtual height of an ionospheric layer is always greater than its actual height.
TRUE
FALSE

⇒ The equivalent T circuit of this coupled network is shown in figure. Find the values of Z_A, Z_B and Z_{C-j, 6j, 2j
-j, 2j, 6j
j, 2j, - 6j
j, 2j, 6j}

⇒ Two messages m₁, and m₂ have a probability of 0.5 each. The entropy is
0.25
0.5
0.75
1

⇒ In a line VSWR of a load is 6 dB. The reflection coefficient will be
0.033
0.33
0.66
3.3

⇒

Assertion (A): Energy meters use induction principle.

Reason (R): Induction wattmeter is less accurate than a dynamometer wattmeter.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ If sequence currents I_a1 = 2 ∠- 90°, I_a2 = 0.2 ∠ 90° and I_a3 = 1.8 ∠ 90°, I_a =
0
1
4
8

⇒ Brewster angle is the angle for which there is
no reflection and the incident wave is vertically polarized
reflection and the incident wave is horizontally polarized
no reflection and the incident wave is horizontally polarized
none of the above

⇒ Equal amplitude ac signals are given as inputs to both inverting and given as inputs to both inverting and non-inverting terminals of an op-amp. The output will be zero when the phase difference between inputs is
0°
90°
180°
270°

⇒ In an intrinsic semiconductor, at a given temperature T
the number of electrons-hole pairs generated per second due to thermal motion are equal to the number of electron-hole pairs lost per second due to recombination
the number of electron-hole pairs generated per second due to thermal motion is always less than the number of electron-hole pairs lost per second due to recombination
the number of electron hole pairs generated per second due to thermal motion is always more than the number of electron-hole pairs lost per second due to recombination
any of the above

⇒ An RLC series circuit is excited by a step voltage E. The units of roots of characteristic equation are
seconds
1/seconds
tesla
henry

⇒ Consider the following

Generation of SSB signals
Design of minimum phase type filters
Representation of band pass signals

Which of the above applications is Hilbert transform used?
1 only
1, 2 and 3
1, 2 only
1 and 3

⇒ The code used to reduce the error due to ambiguity in reading of a binary optical encoder is
Octal code
Excess-3 code
gray code
BCD code

⇒ Harmonic distortion in CB amplifier may be least when the load resistance is
negligible
very low
very high
infinite

⇒ The skip distance is
same for each layer
independent of frequency
independent of the state of ionisation
independent of transmitted power

⇒ To measure moisture in wood, the most suitable method is
electric conduction
electrical-capacitive
absorption of radiation
equilibrium-moisture Vs humidity

⇒ Antenna used for T.V. broadcasting is
long dipole
metal horn
crossed dipole
log periodic