Question is ⇒ If average correlation between v1(t) and v2(t) is R12(t) and average correlation between v2(t) and v1(t) is R21(t) then, Options are ⇒ (A) R12(t) = R21(t), (B) R21(t) = R12(t), (C) R12(t) = - R21(t), (D) none of these, (E) , Leave your comments or Download question paper.

Question is ⇒ If average correlation between v1(t) and v2(t) is R12(t) and average correlation between v2(t) and v1(t) is R21(t) then, Options are ⇒ (A) R12(t) = R21(t), (B) R21(t) = R12(t), (C) R12(t) = - R21(t), (D) none of these, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If average correlation between v₁(t) and v₂(t) is R₁₂(t) and average correlation between v₂(t) and v₁(t) is R₂₁(t) then
A.	R₁₂(t) = R₂₁(t) [Wrong Answer]
B.	R₂₁(t) = R₁₂(t) [Correct Answer]
C.	R₁₂(t) = - R₂₁(t) [Wrong Answer]
D.	none of these [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Good smoothing factor of a coil depends on
inductance of the coil
terminal voltage
cross-sectional area of the wire of the coil
property of the wire of the coil

⇒ Which is not a valid dimension statement?
DIMENSION KAT(10, 20)
DIMENSION BAT (30, 20)
DIMENSION KAT(K, 10)
DIMENSION BAT (10, 5)

⇒

Assertion (A): If a wave v = A₁ + A₂ sin ωt is applied to a pure capacitor the current wav
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The efficiency of using a binary system for selection of 1 out of 13 equally probable events is
1
about 92%
about 83%
about 71%

⇒ An 8156 has A₁₅ connected to its CE input. A₁₄ to A₈ are unconnected, and AD₇ to AC₀ are connected ignoring shadows, what are the RAM locations?
(4000)_H - (40FF)_H
(8000)_H - (80FF)_H
(8000)_H - (40FF)_H
Any of the above

⇒ Which of the following is a balanced line?
Coaxial line
Strip line
Microstrip line
TV twin lead

⇒ Antenna reciprocity is put to use in
radar system
commercial broadcast
TV broadcast system
none of the above

⇒ In a three phase to single phase full wave bridge cycloconverter, the number of thyristors is
36
18
12
8

⇒ Without any addition circuitry, an 8:1 MUX can be used to obtain.
some but not all Boolean functions of 3 variables
all functions of 3 variables but none of 4 variables
all functions of 3 variables and some but not all of 4 variables
all functions of 4 variables

⇒ If t is relaxation time and t_c is average time between collisions, then in an isotropic metal
t = t_c
t < t_c
t_c < t
T = 0.01 t_e

⇒ In equally tampered musical scale, an octave is divided into
12 intervals
10 intervals
7 intervals
5 intervals

⇒ In an end fire array, the radiation pattern
is in the plane of array
is at right angles to array
is at an angle to the plane of array
either (b) or (c)

⇒ In an R-S latch, race condition occurs when
R is low and S is high
R and S are high
R and S are low
R is high and S is low

⇒ A full wave diode rectifier using centre tapped transformer has diodes with forward resistance of 50 ohms each. The load resistance of 50 ohms each. The load resistance is also 50 ohms. The voltage regulation is
0.2
0.5
1
2

⇒ 8085 has 6 sign flags.
TRUE
FALSE

⇒ Mechanical impedance is the ratio of
rms force to rms velocity
rms force to rms displacement
rms velocity to rms displacement
none of the above

⇒ In the given figure the reflected voltage wave after first reflectio
18 V
-18 V
30 V
-30 V

⇒ PAL system was proposed first in
USA
Japan
England
Germany

⇒ An engineer designs an amplifier to have a voltage gain of 60, but when constructed it only had a gain of 50. How much feedback should be used to provide the desired level?
0.0003
0.0033
0.013
0.033

⇒ A microprocessor needs memory chips and input-output chip to form a microcomputer.
TRUE
FALSE

⇒ In a JFET, the drain current is maximum when
V_GS = V_DS
V_GS = pinch off voltage
V_GS = 0
V_GS is negative

⇒ In a 50 cm TV tube, a path difference of 2 km between direct wave and interfering wave would mean a displacement between main image and ghost image equal to
0.3 cm
3 cm
6 cm
9 cm

⇒

Assertion (A): Standard deviation is the abscissa of a point of inflection on the probability curve.

Reason (R): The equation for probability curv
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In the schematic representation of bipolar junction transistor, the direction of arrow shows the direction of flow of
holes
electrons
holes in pnp and electrons in npn
electrons in pnp and holes in npn

⇒ Two voltages are v₁= 100 sin (ωt + 15°) and v₂ = 60 cosωt, then
v₁ is leading v₂ by 15°
v₁ is leading v₂ by 75°
v₂ is leading v₁ by 75°
v₂ is lagging v₁ by 15°

⇒ Earth's curvature affects the effective height of antenna.
TRUE
FALSE

⇒ Which inductor is used at high frequencies?
Cast iron cored
Sheet steel cored
Iron alloy cored
Ceramic cored

⇒ Flow charts that contain decision sy
represent straight line programs
do not represent straight line programs
all of the above
none of the above

⇒ If operator 'a' = 1 ∠120° then (1 + a²) =
3
3 ∠30°
3 ∠ - 30°
3 ∠60°

⇒ A universal shift register can shift left or right.
TRUE
FALSE