Question is ⇒ If an additional two diodes were used to connect the 1 kW load across a bridge rectifier circuits, utilizing the full secondary of the transformer, how much d.c. power could be delivered using a transformer with the rating of 105 VA?, Options are ⇒ (A) 35 W, (B) 60 W, (C) 85 W, (D) 100 W, (E) , Leave your comments or Download question paper.

Question is ⇒ If an additional two diodes were used to connect the 1 kW load across a bridge rectifier circuits, utilizing the full secondary of the transformer, how much d.c. power could be delivered using a transformer with the rating of 105 VA?, Options are ⇒ (A) 35 W, (B) 60 W, (C) 85 W, (D) 100 W, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If an additional two diodes were used to connect the 1 kW load across a bridge rectifier circuits, utilizing the full secondary of the transformer, how much d.c. power could be delivered using a transformer with the rating of 105 VA?
A.	35 W [Wrong Answer]
B.	60 W [Wrong Answer]
C.	85 W [Correct Answer]
D.	100 W [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In figure, the transmission parameters are A = C = 1, B = 2 and D = 3. Then Z_{in12/13 Ω
13/12 Ω
3 Ω
4 Ω}

⇒ The advantage of modified series inverter with two inductors and two capacitors is
the intermittent operation of battery is avoided
efficiency of circuit is more
the output frequency is low
all of the above

⇒ For static electric and magnetic fields in an homogenous source-free medium, which of the following represents the correct form of Maxwell's equations?
Δ.E = 0
Δ.E = 0
Δ x E = 0
Δ x E = 0

⇒ IF V_CC = 15 V, V_CEQ = 5 V and I_CQ = 50 mA, the efficiency in class A operation is
1
0.5
0.25
0.167

⇒ CMRR of a difference amplifier is equal to
(A_v')/(A_com)
A_v/A_com
A_com/A_v'
(A_v)/(A_com)²

⇒ Binary number 11011.01 when converted to its 2's complement will become
101.11
1111.1
1100.1
100.11

⇒ 8255 A has three 8 bit ports A, B, C for peripheral data transfer. For programming 8255 A, these ports are grouped as
Port A with Port B
Port A with 4 most significant ports of C, port B with 4 least significant ports of C
Port A with Port C
none of the above

⇒ TTL circuit with active pull up is preferred because of its suitability for
wired AND operation
bus operated system
wired logic operation
reasonable dissipation and speed of operation

⇒ K maps can be drawn
only for 2 variables
only for 3 variables
only for 4 variables
for any number of variables

⇒ The intrinsic carrier concentration of silicon sample at 300 K is 1.5 x 10¹⁶/m³. If after doping, the number of majority carriers is 5 x 10²⁰/m³. The minority carrier density is
4.5 x 10¹¹/m³
3.33 x 10⁴/m³
5 x 10²⁰/m³
3 x 10^-5/m³

⇒ In figure, i(t) is a unit step current. The steady state value of v(t
2 V
3 V
6 V
9 V

⇒ AM transmitter employing low level modulation
uses class C amplifier for amplification
requires higher audio power
has a poor efficiency
has a higher efficiency

⇒ An one sided abrupt junction has 10²¹/m³ of dopants on the lightly doped side, zero bias voltage and a built-in potential of 0.2 V. The depletion width of abrupt junction.(q = 1.6 x 10^-19 C, ε_r =16, ε₀ = 8.87 x 10^-12 F/m) is
0.036 nm
0.6 μm
3 mm
1.5 mm

⇒ Transient current in a loss free LC circuit when excited from an ac source is an __________ sine wave.
undamped
over damped
under damped
critically damped

⇒ A direct radiating cone type loudspeaker attenuates :
medium range frequencies
very low frequencies
high frequencies
very low and high frequencies

⇒ In AM the amplitude of carrier components ... while in FM it
remains constant, does not remain constant
does not remain constant ... remains constant
remains constant... also remains constant
does not remain constant, also does not remain constant

⇒ In figure the input and output Miller capacitances
0.25 μF each
500 pF each
0.25 μF and 500 pF respectively
500 pF and 0.25 μF respectively

⇒ (100101)₂ is
(37)₁₀
(69)₁₀
(41)₁₀
(5)₁₀

⇒ In a 4 input OR gate, the total number of High outputs for the 16 input states are
16
15
14
13

⇒ With respect to the following 555 timer circuit what will be the value of R_A and R such that the LED turns on for a duration of 10 ms every time it receives negative trigger pulse. LED operating current = 20 mA, V_f = 1.4 V, Vo _on = 13.4 V and C = 0.22 nf
41.4 KΩ, 600 Ω
45 KΩ, 630 Ω
43.5 KΩ, 580 Ω
44.9 KΩ, 600 Ω

⇒ A loss less transmission line is terminated in a load which reflects a part of the incident power. The measured VSWR is 2. The percentage of the power that is reflected back is
57.73
33.33
0.11
11.11

⇒ Which of the following circuit cannot be used to demodulate SSB?
Phase discriminator
Produce detector
Balanced modulator
Beat frequency oscillator

⇒ Thin gate oxide in a CMOS process in preferably grown using
wet oxidation
dry oxidation
epitaxial deposition
ion implantation

⇒ If the memory chip size is 256 x 1 bits, then the number of chips required to make up 1 kB (1024) bytes of memory is
32
24
12
8

⇒ For very low frequencies, log magnitude for the given figur
0 dB
-3 dB
3 dB
10 dB

⇒ Which inductor is used at high frequencies?
Cast iron cored
Sheet steel cored
Iron alloy cored
Ceramic cored

⇒ A logical expression Y = A + AB is equal to
Y = AB
Y = AB
Y = A + B
Y = A + B

⇒
Assertion (A): A Smith chart can be used for a number of calculations of a transmission line
Reason (R): Smith chart is basically a polar impedance diagram.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ When temperature is more than ferromagnetic curie temperature, the behaviour of a ferromagnetic material is similar to that of paramagnetic material.
TRUE
FALSE

⇒ What is the purpose of a start in RS232 serial communication protocol?
To synchronise receiver for receiving every byte
To synchronise receiver for receiving a sequence of byte
Acts as a parity bit
To synchronise receiver for receiving the last byte

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math