Question is ⇒ If all the LEDs in a seven segment display are turned on, the number displayed is, Options are ⇒ (A) 1, (B) 3, (C) 0, (D) 8, (E) , Leave your comments or Download question paper.

Question is ⇒ If all the LEDs in a seven segment display are turned on, the number displayed is, Options are ⇒ (A) 1, (B) 3, (C) 0, (D) 8, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If all the LEDs in a seven segment display are turned on, the number displayed is
A.	1 [Wrong Answer]
B.	3 [Wrong Answer]
C.	0 [Wrong Answer]
D.	8 [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Shift left and shift right operations occur in a calculator.
TRUE
FALSE

⇒ Programmable logic array uses
RAM matrices
ROMs matrices
PROM matrices
Silo memory

⇒ In which counter does the maximum frequency depend on the modulus?
Synchronous
Ripple
Both synchronous and ripple
Neither synchronous nor ripple

⇒ Thin gate oxide in a CMOS process in preferably grown using
wet oxidation
dry oxidation
epitaxial deposition
ion implantation

⇒ In a backward wave oscillator the efficiency
is much higher than in TWT
is much lower than in TWT
is almost the same as in TWT
either (a) or (b)

⇒ Surface waves can propagate on Piezoelectric substrates.
TRUE
FALSE

⇒ The circuit shown in the figure conv
BCD to Binary code
Binary to excess - 3 code
Excess - 3 to Gray
Gray to Binary

⇒ A sample of N type semiconductor has an electron density of 6.25 x 10¹⁸/cm³ at 300 K. If intrinsic concentration of carriers in this sample is 2.5 x 10¹³/cm³ at this temperature, the hole density is
10⁶ / cm³
10⁸ / cm³
10¹⁰ / cm³
10¹² / cm³

⇒

Assertion (A): A BJT can be used as a switch.

Reason (R): In forward active mode emitter base junction is forward biased and base collector junction is reverse biased.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A Varactor diode has
a fixed capacitance
a fixed inductance
a voltage variable capacitance
a current variable inductance

⇒ Which control action can never be used alone?
Proportional
Derivative
Integral
Both (b) and (c)

⇒ Gain stability in an oscillator can bs achieved by
providing negative feedback
providing positive feedback
using low Q circuits
controlling the gain

⇒ In a 3 phase full converter, the instantaneous output voltage can have negative part if
firing angle is less than 60°
firing angle is less than 90°
firing angle is more than 60°
firing angle is more than 90°

⇒ A sinusoidal signal is measured by CRO. The scale is set at 4 mV/cm. If vertical distance between positive and negative peaks is 6 cm, the peak value of ac signal is
6 mV
12 mV
24 mV
3 mV

⇒ Strip lines are used at
microwave frequency
low frequency
High frequency
at any frequency

⇒ The proper exponential form of - 0.0032 in FORTRAN 77 is
-3.2 E - 3
-0.0032
-0.00032 EI
-0.032 E - 1

⇒ In a P type silicon sample, the hole concentration is 2.25 x 10¹⁵ / cm³. If the intrinsic carrier concentration is 1.5 x 10¹⁰/ cm³ the electron concentration is
zero
10¹⁰/cm³
10⁵/cm³
1.5 x 10²⁵/cm³

⇒ Which of the following statement is correct for two wattmeters method of power measurement in 3 phase circuit?
Power can be measured by this method only for star connected loads
When two wattmeters have equal readings power factor is 0.5.
When power factor is 1, one of the wattmeters readings is zero
When the two wattmeter read equal and opposite, p.f. is zero.

⇒ The concentration of minority carriers in a semiconductor depends mainly on
the extent of doping
temperature
the applied bias
none of the above

⇒ In which condition does BJT behave like a closed switch?
Cut off
Saturation
Forward active
Reverse active

⇒ A voltage v = 100 sin (100 pt + 45°) V is applied to an impedance 10 + j10 ohm. The current is
10 ∠45° A
7.07 ∠45° A
5 ∠45° A
5 ∠0 A

⇒

Assertion (A): The gate current of an SCR is always in the form of pulses.

Reason (R): The gate losses, in pulse triggering, are low.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Magnetic effect of current is used in
ammeters
voltmeters
wattmeters
ammeters, voltmeters, wattmeters and energy meters

⇒

Assertion (A): In a power divider S_H = 0, S₂₁ = 0.707 = S₃,

Reason (R): In a power divider the input port (i.e., port 1) is matched and incident power is equally divided in output ports 2 and 3

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In Modulation, "carrier" is
resultant wave
speech voltage to be transmitted
voltage with constant frequency, phase or amplitude
voltage for which frequency, phase or amplitude is varied

⇒ The forbidden energy gap for germanium is
0.12 eV
0.32 eV
0.72 eV
0.92 eV

⇒ In rectangular waveguides the ratio of width to height is about
0.5
1
2
4

⇒ For an elliptically polarized wave incident on the interface of a dielectric at the Brewster angle the reflected wave will be
elliptically polarized
linearly polarized
right circularly polarized
left circularly polarized

⇒ For the compensator in the given figure the maximum phase lea
sin^-1 (1/3)
30°
45°
60°

⇒

Assertion (A): In 8085, the zero flag is set when ALU operation results in 0. If the result is not 0, this flag is reset.

Reason (R): In 8085 the S flag is set when the contents of accumulator become negative during execution of an instruction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct