Question is ⇒ If absolute potential of A is - 8 V and that of B is - 16 V, V<sub>AB</sub> is equal to, Options are ⇒ (A) 24 V, (B) 8 V, (C) - 8 V, (D) - 24 V, (E) , Leave your comments or Download question paper.

Question is ⇒ If absolute potential of A is - 8 V and that of B is - 16 V, V<sub>AB</sub> is equal to, Options are ⇒ (A) 24 V, (B) 8 V, (C) - 8 V, (D) - 24 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If absolute potential of A is - 8 V and that of B is - 16 V, V_AB is equal to
A.	24 V [Wrong Answer]
B.	8 V [Correct Answer]
C.	- 8 V [Wrong Answer]
D.	- 24 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A voltage v = 5 + 50 sin ωt/ + 5 sin 5 &omegat is applied to a pure capacitor of capacitance 1 ωF. If f/= 314 rad/sec, current is
1 + 0.0157 cos 314 t + 0.00785 cos 1570 t
0.0157 cos 314 t + 0.00785 cos 1570 t
0.0157 sin 314 t + 0.00785 sin 1570 t
0.0157 sin (314 t / + 45°) + 0.00785 sin (1570 t + 45°)

⇒ The circuit shown in figure will ac
differentiator
adder
clipper
clamper

⇒ The frequency response of a microphone means
bandwidth of frequencies having output with in ± 1 dB of the output at 1000 Hz
bandwidth of frequencies having output with in ± 3 dB of the output at 1000 Hz
bandwidth of frequencies having output with in ± 1 dB of the output at 500 Hz
bandwidth of frequencies having output with in ± 3 dB of the output at 500 Hz

⇒ The work done in moving a charge Q on an equipotential line for a distance d will be
V/d
QV/d
Q.d
zero

⇒ The oscillator shown in figure
Clapp oscillator
R-C Phase shift oscillator
Hartley oscillator
Colpitt's oscillator

⇒ In a transistor E mode the collector current with the transistor in cut off region is
zero
high
equal to saturated value
none of the above

⇒ If the height of transmitting and receiving antenna in a LOS system are 49 meter and a 9 meter respectively then the distance up to which communication may be possible is about
40 km
110 km
400 km
1100 km

⇒ A microprocessor with a 16 bit address bus is used in a linear memory selection configuration. Address bus lines are directly uses as chip selects of memory chips with 4 memory chips the maximum addressable memory space is
64 k
16 k
8 k
4 k

⇒ Audio-signal modulates a 125 MHz carrier, causing a frequency deviation of 5 kHz. The bandwidth of the narrowband FM signal is __________ kHz.
10
8
9
20

⇒ The SID data received is
LSB first
LSB last
1
none of these

⇒ A steel bar needs 1200 AT to magnetise it. The voltage that must be applied to the magnetising coil of 100 turns and 10 Ω resistance is __________ volt.
120
12
1200
10

⇒ If CS = A₁₅ A₁₄ A₁₃ is used as chip select logic of a 4 K RAM in 8085 system, its memory range is
3000 H - 3 FFF H
7000 H - 7 FFFH
5000 H - 5 FFF H and 6000 H - 6 FFF H
6000 H - 6 FFF H and 7000 H - 7 FFF H

⇒ For most static RAM the maximum access time is about
1 ns
10 ns
100 ns
1 μs

⇒ Microwave signals follow the curvature of the earth and the phenomenon
tropospheric scatter
faraday effect
duct propagation
none

⇒ An electron in a homogeneous magnetic field and having velocity perpendicular to the direction of field moves
perpendicular to the field
along the field
along a straight line inclined at 45° to field
in a circular path

⇒ The frequency range for satellite communication is
3 to 30 kHz
300 to 3000 kHz
3000 to 30000 MHz
30000 to 300000 MHz

⇒ In fi
Wave A is lagging wave B by ∠θ
Wave A is leading wave B by ∠θ
Wave A is lagging wave B by ∠θ and the two waves have same rms values
Wave A is lagging wave B by ∠θ and the two waves have different rms values

⇒ In end fire array the principle direction of radiation
is perpendicular to the array axis
is perpendicular to the array axis and also to the plane containing the array elements
coincides with the direction of the array
is at 45° to the direction of array axis

⇒ A tie set schedule shows
incidence of branches to nodes
incidence of branches to loops
incidence of nodes to loops
none of the above

⇒ A system is said to be marginal stable if
poles lies on Real axis
zero lies on Real axis
poles lies on Imaginary axis
zeros lies on origin

⇒ A series resonant circuit is fed by a voltage having rms value V. At resonance, the voltage across inductance V_L and voltage across capacitance V_C are related as
V_L > V_C
V_L < V_C
V_L = V_C
V_L = 0.5 V_C

⇒ The slope of log magnitude curve changes by - 40 dB/decade at a certain frequency and the error between asymptote and actual curve is positive. This means that
a double pole is present
a pair of complex conjugate poles is present
either (a) or (b)
neither (a) nor (b)

⇒ In an insulated gate FET, the polarity of inversion layer is the same as that of
minority carriers in source
majority carriers in source
charge on gate electrode
minority carriers in drain

⇒ A balun should have
low SWR at both ports
high SWR at both ports
high SWR at input port and low SWR at output port
low SWR at input port and high SWR at output

⇒ The advantage of using crystal oscillator is that it
requires low d.c. supply voltage
works at high frequency
gives high output voltage
gives constant frequency of oscillations

⇒ Which of the following is true?
During addition if the carry into and carry out of the sign bit do not match then an overflow has occurred
During addition if the carry into and carry out of the sign bit don't match then an overflow or underflow has occurred
During addition if the carry into and carry out of the sign bit match then an overflow or underflow has occurred
During addition if the carry into and carry out of the sign bit match then an overflow has occurred

⇒ In figure V_CE (sat) = 0.1 V. Then I_C (sa
10 mA
20 mA
30 mA
40 mA

⇒ A piece of copper and another piece of Germanium are cooled from 30°C to 80 K. The resistance of
copper decreases and germanium increases
both decreases
both increases
copper increases and germanium decreases

⇒ HVDC transmission systems generally use
12 pulse converters
6 pulse converters
3 pulse converters
either 12 or 6 pulse converters

⇒ For exponential function e^-at the Laplace transform 1/(s - a)
TRUE
FALSE