Question is ⇒ If a zero is added to a second order underdamped system, Options are ⇒ (A) the peak overshoot is increased, (B) the peak overshoot is decreased, (C) the peak overshoot remains unchanged, (D) either (a) or (b), (E) , Leave your comments or Download question paper.

Question is ⇒ If a zero is added to a second order underdamped system, Options are ⇒ (A) the peak overshoot is increased, (B) the peak overshoot is decreased, (C) the peak overshoot remains unchanged, (D) either (a) or (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If a zero is added to a second order underdamped system
A.	the peak overshoot is increased [Correct Answer]
B.	the peak overshoot is decreased [Wrong Answer]
C.	the peak overshoot remains unchanged [Wrong Answer]
D.	either (a) or (b) [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which is not a valid dimension statement?
DIMENSION KAT(10, 20)
DIMENSION BAT (30, 20)
DIMENSION KAT(K, 10)
DIMENSION BAT (10, 5)

⇒ Refer to the NAND and NOR latches shown in the figure. The inputs (P₁, P₂) for both the latches are first made (0, 1) and then, after a few seconds, made (1, 1). The corresponding stable outputs (Q₁, Q₂)
NAND: first (0, 1) then (0, 1) NOR: first (1, 0) then (0, 0)
NAND: first (1, 0) then (1, 0) NOR: first (1, 0) then (1, 0)
NAND: first (1, 0) then (1, 0) NOR: first (1, 0) then (0, 0)
NAND: first (1, 0) then (1, 1) NOR: first (0, 1) then (0, 1)

⇒

Assertion (A): The function δ'(t - b) is equal to 0 for t ≠ b

Reason (R): A number of impulses spaced from one another form an impulse train.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒

Assertion (A): In Figure, the intercept of the line on y-axis is equal to N (a_e + a_i), where N is number of atoms/m³, a_e is electronic polarizability and a_i is ionic polarizability.

Reason (R): a_e and a_i are independent of temperatu
Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Microwaves are used for
telephony
radio broadcast
TV systems
all of the above

⇒ Which type of gate is in the given fig
NOR
OR
NAND
EX-OR

⇒ A full adder has two outputs SUM and CARRY.
TRUE
FALSE

⇒ The rms value of wave in figur
about 95 V
about 80 V
about 50 V
about 25 V

⇒ Public address systems generally use electret microphones.
TRUE
FALSE

⇒ The MOSFET is almost ideal as a switching device because
it has linear characteristics
it works progressively
it consumes low power
it has longer life

⇒ Which of the following is not an integer constant?
2.3
156231
10
-256

⇒ The scale of moving iron instrument is linear.
TRUE
FALSE

⇒ For a transfer function the coefficients of the numerator and denominator polynomials in s must be real.
TRUE
FALSE

⇒ A periodic rectangular signal, x(t) has the waveform shown in the given figure. Frequency of the fifth harmonic of its spectrum is _______
200 Hz
250 Hz
400 Hz
1250 Hz

⇒ In the given circuit, the switch is open for a long time. At time t = 0, the switch is closed. What are the initial and final values of voltages across the induc
0 V and 0 V
0 V and 80 V
80 V and 0 V
80 V and 80 V

⇒ Using 4-bit numbers (n = 4) if k = 0011₂, how is k expressed in 2's complement?
1011₂
1101₂
1100₂
0101₂

⇒ In the given figure x_{6de(ax₁ + bx₂ + cx₃)
(a + b + c) (x₁ + x₂ + x₃) (d + e)
(ax₁ + bx₂ + cx₃) (d + e)
a b c d e (x₁ + x₂ + x₃)}

⇒ To determine the polarity of voltage drop across a resistor, it is sufficient to know
direction of current through the resistor
direction and magnitude of current through the resistor
direction and magnitude of current and value of resistance
magnitude of current through the resistance

⇒ An instruction used to set cany flag in a computer is classified as
data transfer
arithmetic
logical
program control

⇒ Nichrome is used in
heater coils
underground cables
overheated wires
lamp filament

⇒ A three stage telephone switching structure is to have 128 input and 128 output terminals. It has been found that at peak time the utilization probability is 0.1. The number of intermediate links required for non-blocking configuration is 15. If the actual number of intermediate links is 5, the probability of blocking of call is
0.01
0.005
0.002
0.001

⇒ Which of the following 8085 instructions does not belong to arithmetic group?
SHLD addr
SUI data
ADCM
INR r

⇒ Human ear can detect sound intensities of the order of
10^-4 W/m²
10^-8 W/m²
10^-13 W/m²
10^-18 W/m²

⇒ An ammeter of 0-25 A range has a guaranteed accuracy of 1% of full scale reading. The current measured is 5 A. The limiting error is
0.02
0.025
0.04
0.05

⇒ In PAL system weighting of R - Y and B - Y signals is done to
prevent over modulation on saturated colours
prevent under modulation of saturated colours
allow over modulation of saturated colours
allow under modulation on saturated colours

⇒ PCM employing 4 bit code is used to send data having frequency range from 0 to 2 kHz. The minimum required bandwidth of carrier channel is
2 kHz
4 kHz
8 kHz
16 kHz

⇒ The voltage across the secondary of the transformer in a half wave rectifier (without any filter circuit) is 25 volts. The maximum voltage on the reverse biased diode will be
100 V
50 V
25 V
12.5 V

⇒ Which of the following is wrong for a magic used to tee?
E and H arms are decoupled
coplanar arms are coupled
all ports are perfectly matched
A signal into coplanar arm splits equally between E and H arms

⇒

Match the following:

	List I		List II
A.	Firm ware	1.	Converts program in high level language to machine language
B.	Compiler	2.	Converts assembly language program into machine language
C.	Assembler	3.	Software embedded in hardware
D.	Virtual addressing	4.	Grouping information between various memories

A-1, B-2, C-3, D-4
A-2, B-3, C-4, D-1
A-3, B-4, C-1, D-2
A-3, B-1, C-2, D-4

⇒ The storage capacity of audio CD is 540 Mb per side.
TRUE
FALSE