Question is ⇒ If a transistor is operating with both of its Junctions forward biased, but with the collector base forward biased, but with the collector base forward bias greater than the emitter-base forward bias, then it is operating in the, Options are ⇒ (A) forward active mode, (B) reverse saturation mode, (C) reverse active mode, (D) forward saturation mode, (E) , Leave your comments or Download question paper.

Question is ⇒ If a transistor is operating with both of its Junctions forward biased, but with the collector base forward biased, but with the collector base forward bias greater than the emitter-base forward bias, then it is operating in the, Options are ⇒ (A) forward active mode, (B) reverse saturation mode, (C) reverse active mode, (D) forward saturation mode, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If a transistor is operating with both of its Junctions forward biased, but with the collector base forward biased, but with the collector base forward bias greater than the emitter-base forward bias, then it is operating in the
A.	forward active mode [Wrong Answer]
B.	reverse saturation mode [Wrong Answer]
C.	reverse active mode [Correct Answer]
D.	forward saturation mode [Wrong Answer]
View Answer 3 -5 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following h parameters is an admittance?
h_ie
h_re
h_fe
h_oe

⇒ The resonant frequency of an R_F amplifier is 1 MHz and its bandwidth is 10 kHz. The Q factor will be
10
100
0.01
0.1

⇒ Magnitude Plot of a Composite signal x(t) = e^2jt + e^3jt is
half wave rectified sinusoidal
full wave rectified sinusoidal
exponentially increasing sinusoidal
exponentially decreasing sinusoidal

⇒ In a colour TV receiver, the sound intercarrier IF is generated in
video detector
video IF amplifier
tuner mixer stage
limiter stage

⇒

Assertion (A): In an intrinsic semiconductor J = (μ_n x μ_p)en_i.

Reason (R): Intrinsic charge concentration n_i at temperature T is given by n_i² = A₀ T³ e^-E_G0/kT.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The current in a circuit is measured using a 150 : 1 CT If the ammeter reads 0.6 A, the circuit current is
250 A
90 A
156 A
144 A

⇒ To ensure that only dominant mode TE₁₀ is allowed to propagate in an air filled rectangular waveguide, the lower frequency limit and upper frequency limit are
about 25% above f_c for TE₁₀ and 5% below f_c for TE₂₀ mode respectively
about 50% above f_c for TE₁₀ and 25% below f_c for TE₂₀ mode respectively
about 25% above f_c for TE₁₀ and 25% below f_c for TE₂₀ mode respectively
none of the above

⇒ Schering bridge is used to measure
capacitance and dielectric loss
inductance
resistance
mutual inductance

⇒ In a network
Number of links = Number of branches - number of nodes + 1
Number of links = Number of branches - number of nodes
Number of links = Number of branches - number of nodes - 1
Number of links = Number of branches - number of nodes - 2

⇒ The bunching action which occurs in multicavity klystron amplifier can be represented by Applegate diagram
TRUE
FALSE

⇒ In 8085 microprocessor, what is the length of status Word?
6 bits
8 bits
12 bits
16 bits

⇒ In the BJT amplifier shown in the figure is the transistor is biased in the forward active region. Putting a capacitor across R_E
decrease the voltage gain and decrease the I/P impedance
increase the voltage gain and decrease the I/P Impedance
decrease the voltage gain and Increase the I/P impedance
none of the above

⇒ In an LC filter, the ripple factor,
increases with load current
increases with load resistance
remains constant with the load current
has the lowest value

⇒ An RC impadence function has a pole at s = 0. The first element in the Foster form of synthesis
is R
may be R and C
is C
is R and C in parallel

⇒ If F = 95.0 what will be the result of following FORTRAN 77 program? 35
35
25
25

⇒ For a semiconductor, the conductivity is a function of the products of the number of charge carriers and their mobilites. As result, if the temperature of a slab of intrinsic silicon increases, how does its conductivity vary?
Decreases
Increases
Remains unaffected
Increases or decreases depending upon the rise in temperature

⇒ A modem is classified as low speed if data rate handled is
upto 100 bps
upto 250 bps
upto 400 bps
upto 600 bps

⇒ In CE amplifier circuit, voltage gain is directly proportional to
β
collector supply voltage
base resistance
none of the above

⇒ The current in a circuit with 10 Ω resistance is i = 3 + 4 sin (100 t + 45°) + 4 sin (300 t + 60°) A. The rms current and power dissipated are
41 A and 410 W
35 A and 350 W
5 A and 250 W
11 A and 1210 W

⇒ If the differential voltage gain and the common mode voltage gain of a differential amplifier are 48 dB and 2 dB respectively, then its common mode rejection ratio is
23 dB
25 dB
46 dB
50 dB

⇒ If memory chip size is 256 x 1 bits, the number of chips required to make 1 k byte memory is
8
12
24
32

⇒ For a good public address system the sound intensity at the farthest point should be at least
20 dB over threshold of hearing
40 dB over threshold of hearing
80 dB over threshold of hearing
120 dB over threshold of hearing

⇒ In a communication system, noise is most likely to affect the signal
at the receiver
at the transmitter
at the information source
in the channel

⇒ The application of gate signal decreases the break over voltage of on SCR.
TRUE
FALSE

⇒ The magnetic field due to current I equals
I/2 pr
I/4 pr
I²/2 pr
I²/4 pr

⇒ Overall efficiency of class B amplifier is
0.72
0.75
0.785
0.7

⇒

Match the following:

	List I (Application of circuit)		List II (Circuit Name)
A.	Divider	1.	Astable multivibrator
B.	Clips input voltage at two predetermined levels	2.	Schmitt trigger
C.	Square wave generator	3.	Bistable multivibrator
D.	Narrow current pulse generator

A-4, B-2, C-1, D-3
A-3, B-2, C-1, D-4
A-4, B-1, C-2, D-3
A-3, B-1, C-2, D-4

⇒ Minimum number of J-K flip-flop needed to construct a BCD counter is
2
3
4
5

⇒

Assertion (A): An impulse has very high magnitude but very small duration.

Reason (R): A pulse function is always rectangular.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ A class E chopper
can operate in second quadrant only
can operate in first or third quadrant
can operate in all the four quadrants
can operate in either second or third quadrant