Question is ⇒ If a sample of germanium and a sample of Si have the impurity density and are kept at room temperature then, Options are ⇒ (A) both will have equal value of resistivity, (B) both will have equal -ve resistivity, (C) resistivity of germanium will be higher than that of silicon, (D) resistivity of Si will be higher than of germanium, (E) , Leave your comments or Download question paper.

Question is ⇒ If a sample of germanium and a sample of Si have the impurity density and are kept at room temperature then, Options are ⇒ (A) both will have equal value of resistivity, (B) both will have equal -ve resistivity, (C) resistivity of germanium will be higher than that of silicon, (D) resistivity of Si will be higher than of germanium, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If a sample of germanium and a sample of Si have the impurity density and are kept at room temperature then
A.	both will have equal value of resistivity [Wrong Answer]
B.	both will have equal -ve resistivity [Wrong Answer]
C.	resistivity of germanium will be higher than that of silicon [Wrong Answer]
D.	resistivity of Si will be higher than of germanium [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A magnetic circuit has an iron length of 20 cm and air gap length 0.1 cm. If μ_r = 200 then
mmf for iron and air gap are equal
mmf for iron is much less than that for air gap
mmf for iron is much more than that for air gap
either (a) or (c)

⇒ The impedance parameter z₂₁ is
transfer impedance at port 1 with port 2 open circuited
transfer impedance at port 1 with port 2 short circuited
transfer impedance at port 2 with port 1 open circuited
transfer impedance at port 2 with port 1 short circuited

⇒ The first machine cycle of an instruction is always
a memory read cycle
a fetch cycle
a input/output read cycle
a memory write cycle

⇒ In a self bias circuit for CE amplifier, the emitter resistance is made three times the original value. The collector current will
remain the same
become three times
decrease
become one-third

⇒ Inverse Fourier transform of '1' is
U(t)
δ(t)
0'
infinite

⇒ The open loop gain of an ideal op-amp is
infinite
very high
neither high nor low
low

⇒ In an ac circuit, the maximum and minimum values of power factor can be
2 and 0
1 and 0
0 and -1
1 and -1

⇒ Parallel wire transmission line is an example of
lumped network
distributed
depend upon I/P signal strength
power I/P

⇒ Light dependent resistor is
photo resistive device
photo voltaic device
photo emissive device
either (a) or (c)

⇒ Auto correlation function
is an even function of t
is an odd function of t
may be an even or odd function of t
is both an odd and even function of t

⇒ The dynamic impedance of an R-L and C parallel circuit at resonance is __________ ohm.
R/LC
C/LR
LC/R
L/CR

⇒ A 555 timer can be used as
an astable multivibrator
monostable multivibrator
frequency Divider only
any of the above

⇒ The gain of a current element is
0 dB
1.67 dB
1.76 dB
3 dB

⇒ The fetching, decoding and executing of an instruction is broken down into several time intervals. Each of these intervals, involving one or more clock periods, is called a
instruction cycle
machine cycle
process cycle
none of the above

⇒ Plug and play is a hardware specification.
TRUE
FALSE

⇒ A buffer amplifier should have
high output impedance and high input impedance
high output impedance and low input impedance
low output impedance an low input impedance
low output impedance and high input impedance

⇒ Which binary addition is incorrect?
1001.1 + 1011.01 = 10100.11
100010 + 1000101 = 1001010
0.0011 + 0.1110 = 1.1
1011.01 + 1001.11 = 10111

⇒ A 10 μF capacitor is charged from a 5 volt source through a resistance of 10 kΩ. The charging current offer 35 m sec. If the initial voltage on C is - 3 V is
0.56 mA
5.6 mA
6 mA
5 μA

⇒ Strength of space wave is not dependent on distance.
TRUE
FALSE

⇒ In 8156, the lower times byte is addressed with 24 H, and the upper times byte with
20 H
23 H
24 H
25 H

⇒ The contents of the commands register are 23 H. Then port C
is an input port
is an output port
is both input as well as output port
none of the above

⇒ The standard deviation of a set of observations is the rms value of the deviation from the arithmetic mean.
TRUE
FALSE

⇒ When a large number of atoms are brought together to form a crystal
the energy levels of inner shell electrons are affected appreciably by the presence of other neighbouring atoms.
The energy levels of outer shell electrons are affected appreciably by the presence of other neighbouring atoms.
the energy levels of both inner and outer shell electrons are affected appreciably by the presence of other neighbouring atoms.
none of the above.

⇒ The percentage saving in power of 100% modulated suppressed carrier AM signal is
100
75
66.6
50

⇒ The current through the coil of an electromagnet is doubled. The magnetic field around the coil
is halved
is doubled
becomes four times
remains the same

⇒ In figure V_CEQ for each transisto
V_CC
0.5 V_CC
0.75 V_CC
0.25 V_CC

⇒ In a PCM system, if the code word length is increased from 6 to 8 bits, the signal to quantization noise ratio improves by the factor.
42953
12
16
8

⇒ Which of the following arithmetic operations requires only one operand in FORTRAN 77?
Addition
Multiplication
Negative
Substraction

⇒ The polynomial P (s) = (s - 1) (s² + 1) (s + 2) (s + 3) is
Hurwitz but not strictly Hurwitz
not Hurwitz
strictly Hurwitz
anti/Hurwitz

⇒ A major advantage of TWT over a Klystron lies in its
higher bandwidth
higher gain
higher frequency
higher output