Question is ⇒ If a sample of Ge and a sample of Si have the same impurity density are kept at room temperature, Options are ⇒ (A) both will have equal value of resistivity, (B) both will have equal - ve of resistivity, (C) resistivity of germanium will be higher than that of silicon, (D) resistivity of silicon will be higher than of Ge, (E) , Leave your comments or Download question paper.

Question is ⇒ If a sample of Ge and a sample of Si have the same impurity density are kept at room temperature, Options are ⇒ (A) both will have equal value of resistivity, (B) both will have equal - ve of resistivity, (C) resistivity of germanium will be higher than that of silicon, (D) resistivity of silicon will be higher than of Ge, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If a sample of Ge and a sample of Si have the same impurity density are kept at room temperature
A.	both will have equal value of resistivity [Wrong Answer]
B.	both will have equal - ve of resistivity [Wrong Answer]
C.	resistivity of germanium will be higher than that of silicon [Wrong Answer]
D.	resistivity of silicon will be higher than of Ge [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The phase angle characteristic in the given figure is
all pass function
transport lag
minimum phase function
none of the above

⇒ If v(t) = 0 for t < 0 and e^-at for t ≥ 0 V(jω) = 1/(a + jω).
TRUE
FALSE

⇒ In one of the codes for transfer of numbers the code for the succeeding number differs from that of the number only in the change of a single digit. The code is
ASCII
Excess 3 CODE
Gray CODE
none of these

⇒ A 256 x 4 EPROM has
8 address pins and 4 data pins
8 address pins and 8 data pins
4 address pins and 8 data pins
4 address pins and 4 data pins

⇒

Assertion (A): Gunn diode is a transferred electron device.

Reason (R): A Gunn oscillator uses the phenomenon of transferred electron effect.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The input to a coherent detector is DSB - SC signal plus noise. The noise at the detector output is
in phase component
quadrature component
zero
the envelope

⇒ The high voltage level of a digital signal in positive logic is
1
0
either 1 or 0
-1

⇒ LVDT is used to measure
displacement
pressure
temperature
any of the above

⇒ A battery charger can drive a current of 5A with 1Ω resistance connected at its output. If it can charge 2 V battery at 7 A rate, its Thevenin's equivalent circuit will be
7.5 in series with 0.5 Ω resistance
1.25 V in series with 1.5 Ω resistance
7.5 V in parallel with 0.5 Ω resistance
12.5 V in parallel with 1.5 Ω resistance

⇒ If x = 0.1396 radians, the values of 1 - cos x and 2 sin² (x / 2) using floating point arithmetic with a 4 digit mantissa are respectively
.1000 E - 1 each
.9727 E - 2 each
.1000 E - 1 and .9727 E - 2 respectively
.9727 E - 2 and .1000 E - 1 respectively

⇒ In end fire array the principle direction of radiation
is perpendicular to the array axis
is perpendicular to the array axis and also to the plane containing the array elements
coincides with the direction of the array
is at 45° to the direction of array axis

⇒

Match the following:

	List I (Types of N-bit ADC)		List II (Characteristics)
A.	Flash converter	1.	Integrating Type
B.	Successive	2.	Fastest converter approximation
C.	Counter ramp	3.	Maximum conversion time = N bits
D.	Dual slow	4.	Used a DAC in its feedback path

A-2, B-3, C-4, D-1
A-1, B-3, C-4, D-2
A-2, B-4, C-3, D-1
A-1, B-4, C-3, D-2

⇒ For checking the parity of a digital word, it is preferable to use
AND gates
NAND gates
EX-OR gates
NOR gates

⇒ Zero mean Gaussian noise of variance N is applied to a half wave rectifier. The mean squared value of the rectified output will be
0
N/2
N/2
N

⇒ A padder is basically a/an
insulator
variable resistor
capacitor
inductor

⇒ A duplexer is used to
couple two antennas to a transmitter
isolate the antenna from the local oscillator
prevent interference between two antennas connected to receiver
use an antenna for reception or transmission without interference

⇒ The element in the feedback circuit of a logarithmic amplifier using op-amp is
a resistor
a capacitor
an inductor
a diode

⇒ The current due to thermionic emission is given by Richardson Dushman equation.
TRUE
FALSE

⇒ An AC circuit has two branches in parallel. The current in one branch is 5 A. Then the current source
must be less than 5 A
must be more than 5 A
may be equal or more or less than 5 A
0.208333333333333

⇒ A radar receiver has a noise figure of 10 dB at 300 K having a bandwidth of 2.5 MHz. The minimum power it can receive is
3.45 x 10^-15 W
1.38 x 10^-15 W
7.5 x 10^-15 W
93.15 x 10^-15 W

⇒ In metals, the average drift velocity of electron per unit field is called mobility.
TRUE
FALSE

⇒ In an n type semiconductor
number of free electrons and holes are equal
number of free electrons is much greater than the number of holes
number of free electrons may be equal or less than the number of holes
number of holes is greater than the number of free electrons

⇒ The bandwidth of FM for Commercial Purpose is
88 - 108 MHz
85 - 110 MHz
90 - 110 MHz
infinite Range

⇒ In the circuit of figure, the load current when thyristor is
is constant
increases exponentially
decreases exponentially
zero

⇒

Assertion (A): The amount of photoelectric emission depends on the intensity of incident light.

Reason (R): Photo electric emission can occur only if frequency of incident light is less than threshold frequency.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In figure v₁ = 8 V and v₂ = 4 V. Which diode will cond
D₂ only
D₁ only
Both D₁ and D₂
Neither D₁ nor D₂

⇒ A separately excited dc motor is run from a dc source through a chopper. At 600 rpm and rated torque, the duty cycle of chopper is 0.8. At 600 rpm and half the rated torque, the duty cycle is likely to be
0.9
0.8
0.75
0.6

⇒ The ripple factor for a bridge rectifier is
0.406
1.21
1.11
2.22

⇒ For a wave propagating in air filled rectangular waveguide.
guide wavelength is never less than free space wavelength.
wave impedance is never less than the free space impedance
TEM mode is possible if the dimension of the waveguide are properly chosen.
propagation constant is a real quantity.

⇒ Which of the following is not advantage of FM over AM?
Noise immunity
Capture effect
Fidelity
Spluttering effect