Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
If a driving point function N(s) = p(s)/q(s), then  
A.  the terms of lowest degree in p(s) and q(s) may differ in degree by zero only [Wrong Answer] 
B.  the terms of lowest degree in p(s) and q(s) may differ by one at the most [Wrong Answer] 
C.  the terms of lowest degree in p(s) and q(s) may differ in degree by two at the most [Wrong Answer] 
D.  the terms of lowest degree in p(s) and q(s) may differ in degree by three at the most [Correct Answer] 
View Answer
Explanation:
Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result 
Also Read Similar Questions Below :
⇒ Which of the following real variable names is not valid in Fortran?
BETA
ALPHA
A
AB * 2
⇒ In n channel JFET
I_{D} and V_{DS} are positive but V_{GS} is negative
I_{D} and V_{GS} are positive but V_{DS} is negative
V_{DS} and V_{GS} are positive but I_{D} is negative
I_{D}, V_{DS} and V_{GS} are all positive
⇒ In PCM, if the number of quantization levels is increased from 4 to 64, then the bandwidth requirement will approximately be increased __________ times.
8
16
3
32
⇒ Which of the following can be used to isolate a low impedance from a high impedance source?
Emitter follower
p filter
Darlington pair
Any of the above
⇒ Out of latch and flip flop, which has clock input?
Latch only
Flip flop only
Both latch and flip flop
None
⇒ Given figure shows the magnitude plot for a system. The steady state error for unit step inpu
1/101
1/100
14977
14611
⇒ In a circuit the value of resistor is made four times. The noise voltage generated by this resistance will
be doubled
be increased four times
remain the same
become half
⇒ In figure, the voltage V_{1} = 4∠0 V. The source voltage V_{28  j8 volts4  j4 volts8  j4 volts8  j16 volts}
⇒
A4, B3, C1, D2
A3, B4, C2, D1
A4, B3, C2, D1
A3, B4, C1, D2
⇒ In drawing phasor diagrams, RMS values are used.
TRUE
FALSE
⇒ In a series circuit with fixed R and variable X_{L}, the current locus lies in the fourth quadrant.
TRUE
FALSE
⇒ The geostationary communication satellite APPLE is parked in the equatorial orbit at
102° E longitude over Sumatra
90° E longitude over Bangladesh
74° E longitude over India
67° E longitude over Pakistan
⇒ Schottky clamping is resorted to in TTL gates
to reduce propagation delay
to increase noise margin
to increase packing density
to increase fan out
⇒ Which of the following impedance inversion is obtained?
Shortcircuited stub
A quarter wave line
Balun transformer
A half wave line
⇒ If quadratic equation x^{2}  1000x + 25 = 0 is solved using floating point arithmetic with 4 digit mantissa, the roots are
.1000 E 4 and .1000 E 4 respectively
.0000 E 4 and .0000 E 4 respectively
.1000 E 4 and .0000 E 4 respectively
None of the above
⇒ In Java which operator can be used even if there is a single operand
+

*
%
⇒ In monostable multivibrator
has no stable state
has one stable state
has two stable states
switches automatically from one state to other state
⇒ A transconductance amplifier has
high input impedance and low output impedance
low input impedance and high output impedance
high input and output impedance
low input and output impedance
⇒ The total number of leads in MOS controlled thyristor is
2
3
4
2 or 3
⇒ The electric intensity for free space is given by
ε_{0}d
σ/ε_{0}
σ.ε_{0}
d/ε_{0}
⇒ In equally tampered musical scale, an octave is divided into
12 intervals
10 intervals
7 intervals
5 intervals
⇒ A two branch tuned circuit has a coil of resistance R and inductance L in one branch and capacitance C in the second branch. If R is increased, the dynamic resistance
decreases
increases
remains constant
may increases or decreases
⇒ The circuit of figure is ca
diode bias
current mirror
complementary mirror
none of the above
⇒
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true
⇒ A rectifier circuit has load resistance R. It uses a capacitance filter having capacitance C. For low ripple in the output
RC should be 1
RC should be low
RC should be high
RC should be neither low nor high
⇒ The resistance values of a PIN diode under positive bias and negative bias respectively are about
a few ohms and a kilo ohms
about 100 ohms and 1000 ohms
about 0.1 ohm and 100 ohms
about 1000 ohms and 10000 ohms
⇒ Consider a multiplexer with X and Y as data inputs and Z as control input. Z = 0 selects input X and Z = 1 selects input Y. What are the connections required to realize the 2variable Boolean function f = T + R, without using any additional hardware?
R to X, 1 to Y, T to Z
T to X, R to Y, T to Z
T to X, R to Y, 0 to Z
R to X, 0 to Y, T to Z
⇒ A periodic voltage has following values for equal time intervals changing suddenly from one value to next, 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, 5, 10 etc. then rms value of the waveform is
31 volt
32 volt
insufficient data
none
⇒ A conductor in xy plane and having length 1 m is moving with a velocity V = (2i + 3j + k) m/sec. A magnetic induction field B = (i + 2j) Wb/m^{2} is applied to the conductor. The potential difference between the ends of the conductor is
0
4.88 V
6 V
None of these
⇒
Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct
⇒ Which of the following real variable names is not valid in Fortran?
BETA
ALPHA
A
AB * 2
⇒ In n channel JFET
I_{D} and V_{DS} are positive but V_{GS} is negative
I_{D} and V_{GS} are positive but V_{DS} is negative
V_{DS} and V_{GS} are positive but I_{D} is negative
I_{D}, V_{DS} and V_{GS} are all positive
⇒ In PCM, if the number of quantization levels is increased from 4 to 64, then the bandwidth requirement will approximately be increased __________ times.
8
16
3
32
⇒ Which of the following can be used to isolate a low impedance from a high impedance source?
Emitter follower
p filter
Darlington pair
Any of the above
⇒ Out of latch and flip flop, which has clock input?
Latch only
Flip flop only
Both latch and flip flop
None
⇒ Given figure shows the magnitude plot for a system. The steady state error for unit step inpu
1/101
1/100
14977
14611
⇒ In a circuit the value of resistor is made four times. The noise voltage generated by this resistance will
be doubled
be increased four times
remain the same
become half
⇒ In figure, the voltage V_{1} = 4∠0 V. The source voltage V_{28  j8 volts4  j4 volts8  j4 volts8  j16 volts}
⇒
Match the following:
List I  List II  

A.  Laser  1.  Emits monochromatic light of low intensity 
B.  Solar cell  2.  Consumes electrical power due to incident light 
C.  Photodiode  3.  Delivers power to a load 
D.  LED  4.  Emits monochromatic light of high intensity 
A4, B3, C1, D2
A3, B4, C2, D1
A4, B3, C2, D1
A3, B4, C1, D2
⇒ In drawing phasor diagrams, RMS values are used.
TRUE
FALSE
⇒ In a series circuit with fixed R and variable X_{L}, the current locus lies in the fourth quadrant.
TRUE
FALSE
⇒ The geostationary communication satellite APPLE is parked in the equatorial orbit at
102° E longitude over Sumatra
90° E longitude over Bangladesh
74° E longitude over India
67° E longitude over Pakistan
⇒ Schottky clamping is resorted to in TTL gates
to reduce propagation delay
to increase noise margin
to increase packing density
to increase fan out
⇒ Which of the following impedance inversion is obtained?
Shortcircuited stub
A quarter wave line
Balun transformer
A half wave line
⇒ If quadratic equation x^{2}  1000x + 25 = 0 is solved using floating point arithmetic with 4 digit mantissa, the roots are
.1000 E 4 and .1000 E 4 respectively
.0000 E 4 and .0000 E 4 respectively
.1000 E 4 and .0000 E 4 respectively
None of the above
⇒ In Java which operator can be used even if there is a single operand
+

*
%
⇒ In monostable multivibrator
has no stable state
has one stable state
has two stable states
switches automatically from one state to other state
⇒ A transconductance amplifier has
high input impedance and low output impedance
low input impedance and high output impedance
high input and output impedance
low input and output impedance
⇒ The total number of leads in MOS controlled thyristor is
2
3
4
2 or 3
⇒ The electric intensity for free space is given by
ε_{0}d
σ/ε_{0}
σ.ε_{0}
d/ε_{0}
⇒ In equally tampered musical scale, an octave is divided into
12 intervals
10 intervals
7 intervals
5 intervals
⇒ A two branch tuned circuit has a coil of resistance R and inductance L in one branch and capacitance C in the second branch. If R is increased, the dynamic resistance
decreases
increases
remains constant
may increases or decreases
⇒ The circuit of figure is ca
diode bias
current mirror
complementary mirror
none of the above
⇒
Assertion (A): The TTL output acts as a current sink in low state
Reason (R): The TTL input current is largest in low state.
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true
⇒ A rectifier circuit has load resistance R. It uses a capacitance filter having capacitance C. For low ripple in the output
RC should be 1
RC should be low
RC should be high
RC should be neither low nor high
⇒ The resistance values of a PIN diode under positive bias and negative bias respectively are about
a few ohms and a kilo ohms
about 100 ohms and 1000 ohms
about 0.1 ohm and 100 ohms
about 1000 ohms and 10000 ohms
⇒ Consider a multiplexer with X and Y as data inputs and Z as control input. Z = 0 selects input X and Z = 1 selects input Y. What are the connections required to realize the 2variable Boolean function f = T + R, without using any additional hardware?
R to X, 1 to Y, T to Z
T to X, R to Y, T to Z
T to X, R to Y, 0 to Z
R to X, 0 to Y, T to Z
⇒ A periodic voltage has following values for equal time intervals changing suddenly from one value to next, 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, 5, 10 etc. then rms value of the waveform is
31 volt
32 volt
insufficient data
none
⇒ A conductor in xy plane and having length 1 m is moving with a velocity V = (2i + 3j + k) m/sec. A magnetic induction field B = (i + 2j) Wb/m^{2} is applied to the conductor. The potential difference between the ends of the conductor is
0
4.88 V
6 V
None of these
⇒
Assertion (A): In CC amplifier the collector is at ac ground
Reason (R): CC amplifier is also called emitter follower
Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct