Question is ⇒ If A = 3 + j1 and B = 4 + j3, A + B =, Options are ⇒ (A) 7 ∠45°, (B) 10 ∠45°, (C) 8.062 ∠29.7°, (D) 8.062 ∠73°, (E) , Leave your comments or Download question paper.

Question is ⇒ If A = 3 + j1 and B = 4 + j3, A + B =, Options are ⇒ (A) 7 ∠45°, (B) 10 ∠45°, (C) 8.062 ∠29.7°, (D) 8.062 ∠73°, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If A = 3 + j1 and B = 4 + j3, A + B =
A.	7 ∠45° [Wrong Answer]
B.	10 ∠45° [Wrong Answer]
C.	8.062 ∠29.7° [Correct Answer]
D.	8.062 ∠73° [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A voltage wave is i = 100 sin (ωt). Its average value calculated over one half cycle is
zero
70.72 V
63.70 V
none of the above

⇒ Ultra high frequency oscillators work in the range
20 Hz to 20 kHz
1 kHz to 30 kHz
30 kHz to 30 MHz
above 30 MHz

⇒ A semi converter operates in two quadrants.
TRUE
FALSE

⇒ To ensure that only dominant TE₁₀ mode propagates in a rectangular waveguide, the operating frequency
must be more than cutoff frequency of TE₁₀ mode
must be less than cutoff frequency of TE₂₀ mode
must be more than cutoff frequency of TE₁₀ mode and less than cutoff frequency of TE₂₀ mode
must be less than cutoff frequency of TE₁₀ mode

⇒ Consider the following statements regarding negative feedback

It increases system gain
It improves sensitivity
It improves system stability

Which of these are not correct?
all
1, 2
1, 3
1 only

⇒

Match the following:

	List I (Location of characteristics roots)		List II (System characteristic)
A.	(- 1 + j), (- 1 - j)	1.	Marginally stable
B.	(- 2 + j), (- 2 - j), (2, j) (- 2, j)	2.	Unstable
C.	- j, j - 1, 1	3.	Stable

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-1, C-2
A-1, B-3, C-2

⇒ Fourier transform and F(jω) of a signal f(t) has the property
F(jω) = F(-jω)
F(jω) = -F(-jω)
F(jω) = F^*(jω)
F(jω) = -F^*(-jω)

⇒

Match the following:

	List I		List II
A.	Wein bridge oscillator	1.	Low output impedance
B.	Voltage shunt feedback amplifier	2.	RF frequency range
C.	Crystal oscillator	3.	Audio frequency range
D.	Current shunt feedback amplifier	4.	High input impedance
		5.	High output impedance

A-3, B-1, C-2, D-5
A-3, B-5, C-1, D-2
A-4, B-3, C-1, D-2
A-5, B-1, C-2, D-1

⇒ The output impedance of an ideal op-amp is
zero
low
high
infinite

⇒ An increase in junction temperature of a semiconductor diode
causes a small increase in reverse saturation current
causes a large increase in reverse saturation current
does not affect reverse saturation current
may cause an increase or decrease in reverse saturation current depending on rating of diode

⇒ The input and output signals for CE amplifier are always
equal
in phase
out of phase
complementary to each other

⇒ A meter with a resistance of 100 Ω and a full scale deflection of current of 1 mA is to be converted into voltmeter of 0 - 5 V range. The multiplier resistance should be
490 Ω
5000 Ω
4900 Ω
5100 Ω

⇒ The fuse material used in electrical lines must have which one of the following properties?
High resistivity
Low conductivity
High melting point
Low melting point

⇒ A three-section RC phase shift oscillator has R = 10K ohms and C = 0.001 μF. The frequency of oscillations is
1.1 kHz
2.5 kHz
3.3 kHz
6.5 kHz

⇒ A series resonant circuit is capacitive at f = 150 Hz. The circuit will be inductive somewhere at
f greater than 150 Hz
f less than 150 Hz
f equal to 150 Hz by increasing the value of the resistance
none of the above

⇒ For what positive value of K does the polynomial s⁴ + 8s³ + 24s² + 32s + K have roots with zero real parts?
10
20
40
80

⇒ A voltage of about 200 V dc can be measured
directly by dc potentiometer
by dc potentiometer in conjunction with a volt ratio box
a dc potentiometer in conjunction with a known resistance
both (b) and (c)

⇒ The reactance of bypass capacitor in a CE amplifier circuit should be
equal to the resistance in parallel with it
equal to 10% or less of the resistance in parallel with it
equal to 50% of the resistance in parallel with it
independent of the resistance in parallel with it

⇒ An amplitude modulated wave
0.5
0.3
0.7
0.4

⇒ A thyristor has a maximum allowable junction temperature of 120°C and the ambient temperature is 40°C. If thermal resistance is 1.6° C/W, the maximum allowable internal power dissipation is
20 W
50 W
92 W
128 W

⇒ (100101)₂ is
(37)₁₀
(69)₁₀
(41)₁₀
(5)₁₀

⇒ In a satellite system circular polarization is to be obtained. The antenna used is
parabolic
horn
log periodic
helical

⇒ A cavity resonator is
a hollow metallic enclosure
a hollow enclosure having magnetic material as its walls
a hollow enclosure having dielectric material as its walls
either (b) or (c)

⇒

Match the following:

	List I (Component)		List II (Dominant TE mode)
A.	Rectangular wave guide	1.	TE₁₀₁
B.	Circular waveguide	2.	TE₁₀
C.	Rectangular cavity	3.	TE₁₁₁
		4.	TE₁₁

A-4, B-2, C-1
A-2, B-1, C-3
A-3, B-4, C-1
A-2, B-3, C-1

⇒ If the characteristic equation is (λ + 1) (λ + 2) (λ + 3) = 0, the eigen values are
-1, -2, -3
1, 2, 3
0, 1, 2
0, 2, 3

⇒ Radar is essentially an echo ranging system
TRUE
FALSE

⇒ Current density has the dimensions
IL
IL^-2
IL^-3
I²L^-2

⇒ In bridge circuit of figure, equivalent resistance between A and B
1 Ω
0.5 Ω
2 Ω
1.5 Ω

⇒ Percentage increase in the reverse saturation current of a diode if the temperature is increased from 25°C to 50°C
0.5
5
5.657
5.756

⇒ Given figure shows a 90° sector of spherical reflector with vertex 'V', centre of curvature 'C' and equal distances VD, DF, FE and EC. When a beam of EM wave is incident parallel to the axis, all the energy will pass through the reg
VD
DF
EF
EC