Question is ⇒ If A = 10 + j then logeA is, Options are ⇒ (A) 14.14 ∠45°, (B) 200 ∠45°, (C) 2.65 + j45°, (D) 2.65 + j0.785, (E) , Leave your comments or Download question paper.

Question is ⇒ If A = 10 + j then logeA is, Options are ⇒ (A) 14.14 ∠45°, (B) 200 ∠45°, (C) 2.65 + j45°, (D) 2.65 + j0.785, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If A = 10 + j then log_eA is
A.	14.14 ∠45° [Wrong Answer]
B.	200 ∠45° [Wrong Answer]
C.	2.65 + j45° [Wrong Answer]
D.	2.65 + j0.785 [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A super heterodyne receiver has a IF of 465 kHz. It is tuned to a station broadcasting at 500 KHz and its oscillator is operating at 965 KHz, then the 1330 KHz frequency would be
adjacent channel frequency
image frequency
gyro frequency
maximum usable frequency

⇒ If f(t) is an even function, the coefficients F_n in the exponential form of Fourier series
are real
are imaginary
are complex
may be real or imaginary

⇒ In a CE amplifier, the collector resistance is 6 kΩ and load resistance is 3 kΩ. The ac load resistance is
9 kΩ
6 kΩ
3 kΩ
2 kΩ

⇒ In a transistor, current I_CBO flow when
some D.C. voltage is applied in the reverse direction to the emitter junction with the collector open circuit
some D.C. voltage is applied in the forward direction to the collector junction with the emitter open circuit
some D.C. voltage is applied in the reverse direction to the collector junction with the emitter open circuited
some D.C. voltage is applied in the forward direction to the emitter junction with the collector open circuited

⇒ Consider the following statements a half adder.

As a half subtractor also
has two outputs C_H = x x y and S_n = x ⊕ y for two inputs x and y
has two outputs CH = x + y and SH = x ⊕ y for two inputs x and y
is a combinational circuit

Which of the statements given above is/are correct?
1, 3, 4
1, 2, 4
4 only
2 and 3

⇒ Kirchoff's laws are applicable to
dc only
ac sinusoidal wave only
dc and ac sinusoidal waves
all wave shapes

⇒ An energy signal has G(f) = 10. Its energy density spectrum is
10
100
50
20

⇒ A 4 bit ripple counter uses flip flops with propagation delay of 50 ns each. The maximum clock frequency which can be used is
5 MHz
10 MHz
20 MHz
25 MHz

⇒ Double integration of unit step function leads to
an impulse
a parabola
a ramp
a doublet

⇒ A circuit is replaced by its Thevenin's equivalent to find current through a certain branch. If V_TH = 10 V and R_TH = 20 Ω, the current through the branch
will always be 0.5 A
will always be less than 0.5 A
will always be equal to or less than 0.5 A
may be 0.5 A or more or less

⇒

Match the following:

	List I (Command in WORD)		List II (Meaning)
A.	END	1.	The bar displays the current position of cursor
B.	HOME	2.	Moves cursor to the beginning of current line
C.	Status	3.	Moves cursor to end of document

A-1, B-2, C-3
A-3, B-1, C-2
A-2, B-3, C-1
A-3, B-2, C-1

⇒ A loss less line of characteristic impedance Z₀ is terminated in pure reactance of -jZ₀ value. VSWR is
10
2
1
infinity

⇒ For a second order instrument, the optimum range of ξ (damping ratio), which gives good frequency response over a wide range of frequencies is
0.5 to 0.6
0.6 to 0.7
0.7 to 0.8
0.8 to 1.0

⇒ When a wave reaches an open circuit
the voltage at termination is doubled the incident voltage
the current at termination is doubled the incident voltage
the voltage at termination is zero
both V and I at termination are doubled the incident voltage and current

⇒ If the peak value of output of a half wave rectifier is 100 V, the rms value is
100 V
50 V
70.7 V
35.35 V

⇒ A generated voltage is equally dependent on three resistances R₁, R₂, R₃ and its value is V = (R₁R₂)/R₃. If tolerance of each resistor is 0.1%, the maximum error in voltage is
0.003
± 0.3%
0.001
± 0.1%

⇒ A dc chopper V = 500 V feeds an electric fraction dc series motor. The chopping frequency is 400 Hz. The series inductance required to limit the maximum current swing to 10 A is
20 mH
about 31 mH
about 51 mH
about 92 mH

⇒ In a self bias circuit for CE amplifier, the emitter resistance is made three times the original value. The collector current will
remain the same
become three times
decrease
become one-third

⇒ Radiation pyrometer is used to measure temperature in the range of
-200 to 500° C
0 to 500° C
500 to 1200° C
1200 to 2500° C

⇒ The PCM signal shown below uses amplitude level of +1 volt and -1 volt to represent binary symbol 0 and 1 respectively. Each code word consists of 4 bits. The sampled version of analog signal from which this PCM signal is derived
EB596
CD231
DA495
25B6A

⇒ The programming language in which Excel records the macro code is
basic
visual basic
video basic
basic 2

⇒ When a potential is applied across an intrinsic semiconductor, holes flow
towards positive terminal
away from positive terminal
in the external circuit only
none of the above

⇒ The time base of a high frequency CRO whose screen diameter is 10 cm is set at 10 μ sec/cm. The lowest frequency which can be fully displayed on the screen is
more than 100 kHz
equal to 100 kHz
equal to 10 kHz
less than 10 kHz

⇒ Which multivibrator can be used as a clock timer?
Astable multivibrator
Bistable multivibrator
Any of the above
None of the above

⇒ An SBS can conduct is one direction only.
TRUE
FALSE

⇒ In figure V_BE = 0.7 V. If base current required to saturate the transistor is 0.1 mA, V_{i5 V
5.7 V
10 V
10.7 V}

⇒ If current is less than 20 mA and time of contact is very small, the effect of current on human body is likely to be temporary.
TRUE
FALSE

⇒ The total number of fundamental products of three variables is
3
5
8
16

⇒ Which wave is also called surface wave?
Ground wave
Sky wave
Space wave
Both (b) and (c)

⇒ Microwave link repeaters are typically 50 km apart in TV transmission due to
atmosphere attenuation
output power tube limitations
attenuation of surface wave
earth's curvature