Question is ⇒ If (225)Y = (165)8 find value of Y, Options are ⇒ (A) 7, (B) 8, (C) 9, (D) 11, (E) , Leave your comments or Download question paper.

Question is ⇒ If (225)Y = (165)8 find value of Y, Options are ⇒ (A) 7, (B) 8, (C) 9, (D) 11, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If (225)_Y = (165)₈ find value of Y
A.	7 [Correct Answer]
B.	8 [Wrong Answer]
C.	9 [Wrong Answer]
D.	11 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An ac network has a power factor of 0.8 lagging for fundamental frequency. If the applied voltage contains thrid and fifth harmonics, the overall power factor will be
more than 0.8 lagging
0.8 lagging
less than 0.8 lagging
0.8 lagging or less

⇒

Assertion (A): Field emission is substantially independent of temperature.

Reason (R): When a high electric field is created at metal surface field emission may occur.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In FM and AM the ratio of signal to noise ratio at the detector output least depends upon
bandwidth
transmission
carrier frequency
modulating frequency

⇒ In the wheatstone bridge in figure, each resistance is increased by 0.05%. The value of v₀ will
50 mV
5 mV
0.1 mV
zero

⇒ The main systems used for generation of SSB are
filter method
phase cancellation method
third method
all of the above

⇒ In the human eye, an image persists for a time of about
1 second
0.1 second
0.05 second
0.02 second

⇒ In dc tacho generators used for measurement of speed of shaft, frequent calibration is necessary because
contacts wear off
strength of permanent magnet decreases with age
armature current produces heating effect
there is back emf

⇒ V MOS have the advantage of
faster switching
no thermal run away
both (a) and (b)
none of the above

⇒ In which of the following 8085 instructions no condition flags are affected?
INX rp
INR r
SBI data
INR M

⇒ In a positive edge triggered JK flip flop
High J and High K produce inactive state
Low J and High K produce inactive state
Low J and Low K produce inactive state
High J and Low K produce inactive state

⇒ The most commonly used devices for differencing and amplification, in control systems, are
BJT amplifiers
FET amplifiers
operational amplifiers
either (a) or (b)

⇒ The term VLSI generally refers to a digital IC having
more than 1000 gates
more than 100 gates
more than 1000 but less than 9999 gates
more than 100 but less than 999 gates

⇒ The Z inverse of the given Z transform i
unit step
unit impulse
unit ramp
unit parabola

⇒ Electric dipole moment is usually expressed in debye units. Here, 1 debye unit equals
3.33 x 10^-30 C-m
3.33 x 10^-30 C-m²
3.30 x 10^-10 C-m
3.33 x 10^-10 C-m²

⇒ How much is contributed by each bit in the code word of a PCM system under uniform and symmetric quantization to the signal to noise ratio?
3 dB
4 dB
5 dB
6 dB

⇒ The skin depth at 1000 MHz as compared to that at 500 MHz is
2
12
0.707
0.5

⇒ The discone antenna is
used in UHF range
circularly polarized
used in radar
used as a direction finding antenna

⇒ The log magnitude curve for a constant gain K is a
horizontal straight line
horizontal straight line of magnitude 20 log K decibels
an inclined line having slope K
an inclined line having slope -K

⇒ A radio frequency choke permits an easy flow of __________ current and at the same time it offers a very impedance to __________ currents.
A.C., low frequency
A.C., high frequency
D.C., low frequency
D.C. high frequency

⇒ The carrier mobility in a semiconductor is 0.4 m²/Vs. Its diffusion constant at 300 K will be (in m²/s)
0.4
0.16
0.04
0.01

⇒ Pressing a key on telephone set generates two frequencies. The basis for selection of these frequencies is
the harmonics of one frequency should not be mistaken for the other frequency
the audio input to the handset transmitter should not be mistaken for a key pressing
both (a) and (b)
neither (a) nor (b)

⇒ During forward blocking state of SCR, the voltage and current respectively are
high and high
low and low
high and low
low and high

⇒ In which of these is reverse recovery time nearly zero?
Zener diode
Tunnel diode
Schottky diode
PIN diode

⇒ The number of free electrons in acceptor atom is
1
2
3
4

⇒ At 0 K the forbidden energy gap in intrinsic semi conductor is about
10 eV
6 eV
1 eV
0.2 eV

⇒ If D is diagonal and F is focal length, lens angle θ is
θ = tan^-1 (D/F)
θ = 2 tan^-1 (D/F)
θ = tan^-1 (D/2F)
θ = 2 tan^-1 (D/2F)

⇒ The maximum power dissipation capacity of a transistor is 50 mW. If the collector emitter voltage is 10 V, what is the safe collector current that can be allowed through the transistor?
5 mA
2.5 mA
10 mA
25 mA

⇒ A sinusoidal signal is measured by CRO. The scale is set at 4 mV/cm. If vertical distance between positive and negative peaks is 6 cm, the peak value of ac signal is
6 mV
12 mV
24 mV
3 mV

⇒ A Karnaugh map with 4 variables has
2 cells
4 cells
8 cells
16 cells

⇒ Which of the following is a digital modulation technique?
PCM
PSK
DM
All