Question is ⇒ If 1.5% of the output of an amplifier is feedback positively to the input, the minimum gain required of the amplifier for oscillations to occur, is, Options are ⇒ (A) 16.6, (B) 44.4, (C) 66.6, (D) 75, (E) , Leave your comments or Download question paper.

Question is ⇒ If 1.5% of the output of an amplifier is feedback positively to the input, the minimum gain required of the amplifier for oscillations to occur, is, Options are ⇒ (A) 16.6, (B) 44.4, (C) 66.6, (D) 75, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If 1.5% of the output of an amplifier is feedback positively to the input, the minimum gain required of the amplifier for oscillations to occur, is
A.	16.6 [Wrong Answer]
B.	44.4 [Wrong Answer]
C.	66.6 [Correct Answer]
D.	75 [Wrong Answer]
View Answer 1 -3 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The oscillator frequency is set for
best picture
max. sound
min. sound
sound in picture

⇒ Schering bridge is used to measure
capacitance and dielectric loss
inductance
resistance
mutual inductance

⇒ In 8086 the number of lines on which data and address is multiplexed is
8
16
20
32

⇒ In a transistor β_dc is likely to vary between 100 and 400. The proper value of β_dc to be used to located Q point is
100
400
250
200

⇒ The realization of the term Ks yields
a resistance of value K ohms
a capacitances of value K farads
an inductance of value k farads
either (b) or (c)

⇒

Assertion (A): Intrinsic semiconductor is an insulator at 0 K.

Reason (R): Fermi level in intrinsic semiconductor is in the centre of forbidden energy band.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Consider the following statements:

Race around condition can occur in JK flip flop when both inputs are 1
A flip flop is used to store one bit of information
A transparent latch is a D type flip flop
Master slave flip flop is used to store two bits of information

Which of the above are correct?
1, 2, 3
1, 3, 4
1, 2, 4
2, 3, 4

⇒ In an R-C series circuit excited by a voltage E, the charge across capacitor at t = 0⁺ is
0
CE
CE (1 - e^-t/RC)
none of the above

⇒ The correct sequence of subsystems in an FM receiver is
Mixer, RF amplifier, Limiter, IF amplifier. Discriminator, Audio amplifier
RF amplifier, Mixer, IF amplifier, Limiter, Discriminator, Audio amplifier
RF amplifier, Mixer, Limiter, Discriminator IF amplifier, Audio amplifier
Mixer, IF amplifier, RF amplifier, Audio amplifier, Discriminator

⇒ The analog signal m(t) is given below m(t) = 4 cos 100 pt + 8 sin 200 pt + cos 300 pt, the Nyquist sampling rate will be
1/100
1/200
1/300
1/600

⇒ Two sinusoidal signals of same amplitude and frequencies 10 kHz and 10.1 kHz are added together. The combined signal is given to an ideal frequency detector. The output of the detector is
0.1 kHz sinusoidal
10.1 kHz sinusoidal
a linear function
a constant

⇒ A FET is a better clapper than a BJT because it has
lower off-set voltage
higher series ON resistance
lower input current
higher input impedance

⇒ RTD is generally suitable for temperature up to
about 800°C
about 1500°C
about 200°C
about 50°C

⇒ In hexadecimal number system, A is equal to decimal number
10
11
17
18

⇒ To obtain very high input and O/P impedance in a feedback amplifier, the type of feedback utilized
voltage series
current series
voltage shunt
current shunt

⇒ The material used in RTD is
linear
aluminium
silver
platinum

⇒ An m derived low pass filter has f_c = 1000 Hz, f_∞ = 1250 Hz and m = 0.6. If m is increased, then
both f_c and f_∞ will increase
both f_c and f_∞ will decrease
f_c will remain constant but f_∞ will decrease
f_c will remain constant but f_∞ will increase

⇒ The correct relation between joules and calories is
calories = joules/4.156
joules = calories/4.156
calories = joules x 10⁷/4.156
joules = calories x 10⁷/4.156

⇒

Assertion (A): If frequency is high, the distance between transmitter and antenna may be an appreciable fraction of wavelength

Reason (R): Wavelength is inversely proportional to frequency.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Colour picture tube needs higher anode voltage and needs larger beam and cathode currents than monochrome tube because
it is bigger in size
it has higher level of illumination
the tube has to illuminate three phosphors simultaneously
the tube has lower efficiency because of aperture mask

⇒

Assertion (A): Transient analysis uses Laplace transformation.

Reason (R): Laplace transform method is suitable for solution of integro differential equations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The inputs to logic gate are 0. The output is 1. The gate is
NAND or XOR
OR or XOR
AND or XOR
NOR or Ex-NOR

⇒ One XOR gate can work as
one bit magnitude comparator
two bit magnitude comparator
either (a) or (b)
neither (a) nor (b)

⇒ Which of the following is not necessarily the advantages of a push pull amplifier?
It gives more output
It removes odd a well as even harmonics
There is no effect of ripple of the power supply
It consumes least power

⇒ A transmission line has characteristics impedance of (75 + j 0.01) Ω and is terminated in a load impedance of (70 + j 50) Ω. The transmission coefficient will be
1.70 - j 2.97
0.08 + j 0.32
1.32 + j 1.38
1.08 + j 0.32

⇒ Which of the following is the fastest switching device?
JFET
BJT
MOSFET
Triode

⇒ Which bridge can be used to measure frequency?
Maxwell
Kelvin
Schering
Wein

⇒ The maximum rectification efficiency in case of full wave rectifier is
1
0.812
0.666
0.406

⇒ The width of a radio beam from a 1 m diameter parabolic antenna at 10 GHz is about
100°
50°
5°
1°

⇒ Consider the following stateme
1, 2 and 3
1 and 2 only
2 and 3 only
3 and 4 only