Question is ⇒ If (10)x x (10)x = (100)x; (100)x x (100)x = (10000)x then x can take value :, Options are ⇒ (A) 2, (B) 5, (C) 10, (D) all of these , (E) , Leave your comments or Download question paper.

Question is ⇒ If (10)x x (10)x = (100)x; (100)x x (100)x = (10000)x then x can take value :, Options are ⇒ (A) 2, (B) 5, (C) 10, (D) all of these , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If (10)_x x (10)_x = (100)_x; (100)_x x (100)_x = (10000)_x then x can take value :
A.	2 [Wrong Answer]
B.	5 [Wrong Answer]
C.	10 [Wrong Answer]
D.	all of these [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In TE₁₀mode the largest electric field in a rectangular wave guide, occurs
along centre line of broad wall (i.e. x = a/2)
along the broad wall (i.e. x = 0 and x = a)
either (a) or (b)
neither (a) nor (b)

⇒ Consider the following statements:

Strictly speaking C supports 1-dimensional arrays only.
An array element may be an array by itself.
Array elements need not occupy contiguous memory locations.

Which of the above statements is/are correct?
1 only
2 only
1 and 2
2 and 3

⇒ The received signal frequency at any time of a super-heterodyne receiver having IF = 456 kHz is 1 MHz. The corresponding image signal is
within the medium band
outside the medium band
depend upon modulation index
depends on Modulating frequency

⇒

Assertion (A): If Z₁(s) and Z₂(s) are positive real then Z₁(s) + Z₂(s) as well as 1/Z₁(s) and 1/Z₂(s) are positive real.

Reason (R): The poles of a positive real function are real or occur in conjugate pairs.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): If we overdrive an amplifier the output signal may get clipped

Reason (R): To dissipate heat to atmosphere a heat sink is sometimes attached to the case of transistor

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Choose the function f(t), - ∞ < t < + ∞, for which a Fourier series cannot be defined
3 sin (25t)
4 cos (20t + 3) + 2 sin (10t)
exp - | t | sin 25 t
1

⇒ In figure, the switch is closed at t = 0. After some time i = 6A and rate of change of current was 4A/s. The value of inducto
1 H
1.5 H
indeterminate
0.5 H

⇒ In a N-P-N transistor, when emitter junction is forward biased and collector junction is reverse biased, the transistor will operate in
active region
saturation region
cut of region
inverted region

⇒ Consider the following statements a half adder.

As a half subtractor also
has two outputs C_H = x x y and S_n = x ⊕ y for two inputs x and y
has two outputs CH = x + y and SH = x ⊕ y for two inputs x and y
is a combinational circuit

Which of the statements given above is/are correct?
1, 3, 4
1, 2, 4
4 only
2 and 3

⇒

Assertion (A): For an underdamped system with damping ratio ξ, the maximum overshoot is e-ξp/(1-ξ²)^0.5

Reason (R): Peak time of a second order under damped system = p/ω_d where ω_d is frequency of damped oscillations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒

Match the following:

	List I		List II
A.	loop antenna	1.	flat line
B.	folded dipole	2.	300 W
C.	SWR of 1	3.	sharp broadside full
D.	VHF band	4.	30 to 300 MHz

A-1, B-4, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4
A-2, B-3, C-1, D-4

⇒ For the network shown below, determine f_Hi and f_HO, if, r₀ = ∞, C_be = 36 Pf, C_bc = 4 Pf, C_ce = 1 Pf, C_wo = 8 Pf, C_wi = 6 Pf<
738.24 KHz, 8.6 MHz
781.2 KHz, 10.6 MHz
838.32 KHz, 9.2 MHz
938.24 KHz, 8.2 MHz

⇒ Consider the following symbols
Letters A to Z and a to z
Digits 0 to 9
Logical operators and, or, not
Parenthesis ( )
Which of the above symbols are available in Pascal?
1 and 2 only
1, 2 and 3 only
1, 2 and 4 only
All

⇒ Pressing a key on telephone set generates two frequencies. The basis for selection of these frequencies is
the harmonics of one frequency should not be mistaken for the other frequency
the audio input to the handset transmitter should not be mistaken for a key pressing
both (a) and (b)
neither (a) nor (b)

⇒ If for a silicon n-p-n transistor, the base to emitter voltage (V_BE) is 0.7 V and the collector to base voltage V_CB is 0.2 Volt, then the transistor is operating in the
normal active mode
saturation mode
inverse active mode
cut off mode

⇒ An instruction using immediate addressing mode in 8085 is
2 bytes long
3 bytes long
2 or 3 bytes long
1 or 2 or 3 bytes long

⇒ The reverse voltage applied to a varactor diode
is less than avalanche breakdown voltage
is more than avalanche breakdown voltage
may be more or less than a avalanche breakdown voltage
is very high as compared to avalanche breakdown voltage

⇒ Three identical coils each having self inductance L are connected in series so that the fluxes of all the three are in the same direction. If mutual inductance between each pair of coils is M, the total inductance of the arrangement is
3 L + 9 M
1.5 L + 3 M
3 L + 3 M
3 L + 6 M

⇒ Mechanical impedance is the ratio of
rms force to rms velocity
rms force to rms displacement
rms velocity to rms displacement
none of the above

⇒ When the gate terminal of MOSFET is positive, it is said to operate in
depletion mode
conduction mode
enhancement mode
none of the above

⇒ Which of the following statements about the matched filter in a communication receiver are correct?
Its impulse response depends on the signed shape
It maximizes the SNR at the detection shape.
It produces ISI.
It may produce phase error if synchronization is improper.
Select the correct answer from the codes given below:
1 and 4 only
1 and 2 only
2, 3 and 4
1, 2 and 4

⇒ With on-chip decoding, n address lines can access
2n memory locations
2n² memory locations
2ⁿ memory locations
n² memory location

⇒ In figure, the power dissipated in 4 resistance is P₁ and power associated with 3 A source is P₂.
P₁ = P₂
P₁ < P₂
P₁ > P₂
P₁ may be equal or less than P₂

⇒ A material has conductivity of 10⁵ mho/m and permeability of 4p x 10^-7 H/m. The skin depth at 9 GHz is
1.678 μm
26 μm
17 μm
32.32 μm

⇒ In voltage amplifiers, the load resistance
should be a small as possible
should be as large as possible
must be equal to output impedance
must be half of output impedance

⇒ In standard TTL the totem pole stage refers to
multiemitter input stage
phase splitter
output buffer
open collector output stage

⇒ The units for apparent power are watts.
TRUE
FALSE

⇒ A MOSFET has a threshold voltage of 1 V and oxide thickness of 500 x 10^-8 [ε_r = 3.9; ε₀ = 8.85 x 10^-14 F/cm, q = 1.6 x 10^-19 c]. The region under the gate is ion implanted for threshold voltage tailoring. The base and type of impant required to shift threshold voltage to - 1 V are __________ .
8.6 x 10¹¹/cm², p-type
8.6 x 10¹¹/cm², n-type
0.86 x 10⁹/cm², p-type
1.02 x 10¹²/cm², n-type

⇒ In a normally biased N-P-N transistor the main current crossing the collector junction is
a drift current
a hole current
a diffusion current
same as the base current

⇒ In the balanced bridge shown in figure. X should
a self inductance having resistance
a capacitance
a non-inductive resistance
an inductance and capacitance in parallel

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math