Question is ⇒ Hystresis loss least depends on, Options are ⇒ (A) frequency, (B) magnetic field intensity, (C) volume of the material, (D) grain orientation of material, (E) , Leave your comments or Download question paper.

Question is ⇒ Hystresis loss least depends on, Options are ⇒ (A) frequency, (B) magnetic field intensity, (C) volume of the material, (D) grain orientation of material, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Hystresis loss least depends on
A.	frequency [Wrong Answer]
B.	magnetic field intensity [Wrong Answer]
C.	volume of the material [Wrong Answer]
D.	grain orientation of material [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The circuit show
voltage series feedback amplifier
transconductance amplifier
transresistance amplifier with open circuit mutual resistance R_F
transresistance amplifier with short circuit mutual resistance R_F

⇒ The early effect in BJT is caused by
fast turn on
fast turn off
large collector base reverse bias
large emitter base forward bias

⇒ For use at 50 Hz the range of scale of vibrating reed frequency meter is
25 - 75 Hz
40 - 60 Hz
47 - 53 Hz
42 - 58 Hz

⇒

Assertion (A): In FM the frequency of the carrier is varied by the modulating voltage

Reason (R): FM and PM are two forms of angle modulation.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The given figure shows a constant current source driving a parallel RC circuit. It is equivalen
a lag network
a lead network
a lag-lead network
either (a) or (b)

⇒ In a second order system, the time constant t of exponential envelopes depends
only on damping factor
only on natural frequency
both on damping factor and natural frequency
neither on damping factor nor on natural frequency

⇒ With on-chip decoding, n address lines can access
2n memory locations
2n² memory locations
2ⁿ memory locations
n² memory location

⇒ Which of these instruments has highest power consumption?
Dynamometer
Electrostatic
Moving coil
Hot wire

⇒ In a multiphase chopper, the different choppers operate in
series and all simultaneously
parallel and one at a time
parallel and simultaneously
either (b) or (c)

⇒ In a 3 phase semiconverter, the dc output voltage for a certain firing angle is 50% of the maximum possible value. The firing angle is
30°
60°
90°
120°

⇒ Mechanical impedance is the ratio of
rms force to rms velocity
rms force to rms displacement
rms velocity to rms displacement
none of the above

⇒ If the voltage across the last resistor is V, and all the resistor is unity. Then V_s is give
8 V
4 V
13 V
0

⇒ The series element in band pass filter is
capacitive
inductive
parallel combination of inductance and capacitance
series combination of inductance and capacitance

⇒

Assertion (A): A high dv/dt may cause triggering of a thyristor.

Reason (R): A high dv/dt results in charging current in the thyristor.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following can not be used as a variable name in C?
else
coal
ram
vendy

⇒ Which of the following frequencies has the greatest period?
20 Hz
200 Hz
20 kHz
200 kHz

⇒ The phenomenon of dielectric hysteresis occurs with
dc
ac
both ac and dc
none of the above

⇒ It has been found that in a rectifier circuit with RC filter one RC section reduces ripple by 15%. Two RC sections are used in cascade the reduction in ripple would be
0.15
0.3
1.5
2.25

⇒ The realization of the term Ks yields
a resistance of value K ohms
a capacitances of value K farads
an inductance of value k farads
either (b) or (c)

⇒ Holes and electrons move in opposite directions.
TRUE
FALSE

⇒ The system in the given figure
good gain and phase margins
good gain margin and poor phase margin
poor gain and phase margins
poor gain margin but good phase margin

⇒ Which of the following periodic waveforms will have only odd harmonics of sinusoidal wavef
1 and 2
1 and 3
1 and 4
2 and 4

⇒ Thermistor is used in
temperature measurement
temperature control
high temperature alarm circuits of devices
all of the above

⇒ UJT can be used for
firing an SCR
turning off an SCR
both firing and turning off an SCR
none of the above

⇒ Dielectric strength of which of the following material has the highest dielectric strength?
Porcelain
Soft rubber
Glass
Joule effect

⇒ If luminance signal Y = 0.3 R + 0.59 G + 0.11 B, the hue of R - Y colour is
0.7 R - 0.59 G - 0.11 B
- 0.7 R + 0.59 G + 0.11 B
1.3 R - 0.59 G - 0.11 B
none of the above

⇒ The circuit in figur
positive clamper
negative clamper
positive peak clipper
negative peak clipper

⇒ The value of the inductance of coil in which a current increases linearly from zero to 0.1A in 0.2 second producing a voltage of 5 volts is __________ .
2.5
5
10
20

⇒ For an N bit ADC, the percentage resolution is [1/2^N - 1)] 100.
TRUE
FALSE

⇒

Match the following:

	List I		List II
A.	IF amplifier	1.	Amplifier frequencies in the range of 100 kHz to 5 MHz.
B.	RF amplifier	2.	Current in the output flows only during a portion of the positive half of the input cycle
C.	AF amplifier	3.	Amplifier frequencies in the range of 0 Hz to 5 MHz
D.	Class operation	4.	Amplifier frequencies in the frequency range of 40 Hz to 15 kHz.

A-4, B-1, C-3, D-2
A-3, B-1, C-4, D-2
A-2, B-3, C-1, D-4
A-1, B-2, C-3, D-4