Question is ⇒ Hysteresis loss in a transformer working at 220 V and at a frequency of 50 Hz is 100 W. When the transformer is operated at 220 V and at a frequency of 100 Hz, what is the hysteresis loss?, Options are ⇒ (A) 50 W, (B) 100 W, (C) 200 W, (D) 400 W, (E) , Leave your comments or Download question paper.

Question is ⇒ Hysteresis loss in a transformer working at 220 V and at a frequency of 50 Hz is 100 W. When the transformer is operated at 220 V and at a frequency of 100 Hz, what is the hysteresis loss?, Options are ⇒ (A) 50 W, (B) 100 W, (C) 200 W, (D) 400 W, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Hysteresis loss in a transformer working at 220 V and at a frequency of 50 Hz is 100 W. When the transformer is operated at 220 V and at a frequency of 100 Hz, what is the hysteresis loss?
A.	50 W [Correct Answer]
B.	100 W [Wrong Answer]
C.	200 W [Wrong Answer]
D.	400 W [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ When a wave reaches the open circuited end of a line
all the forward energy is reflected by the open circuit
all the forward energy is absorbed by the open circuit
a small portion of energy is radiated into atmosphere and the remaining energy is reflected
either (a) or (b)

⇒ Find the output voltage for 011100 in a 6 bit R-2R ladder D/A converter has a reference voltage of 6.5 V.
6.4 V
2.84 V
0.1 V
8 V

⇒

Match the following:

	List I (Operator)		List II (Description)
A.	? :	1.	Modulus
B.	[ ]	2.	Array expression
C.	%	3.	Conditional

A-3, B-2, C-1
A-1, B-2, C-3
A-1, B-3, C-2
A-2, B-3, C-1

⇒ Following figure is a signal conditioning Amplifier, changes gain depending upon the polarity of V_s. What will be circuit voltage gain for + V_s and for - V_s if D₂ is id
A_V = -R₃/R₁
R₃/R₁
R₁/R₃
1 + R₃/R₁

⇒ The 6 V zener diode shown in figure has zero zener resistance and a knee current of 5 mA. The minimum value of R, so that the voltage across it does not fall below 6
1.2 kΩ
80 Ω
50 W
0

⇒ For the high-pass circuit to act as a differentiator, the time constant must be
small
very small in comparison to the time period of the input signal
very high in comparison to the time period of the input signal (that is low pass circuit)
moderate value

⇒ The initial contents of ACC and CY in 8085 are

CY = 1
ACC = 10000001

After instruction RAL is executed once the contents of CY and ACC respectively will be
1 and 00000011
0 and 00000011
1 and 00000001
0 and 00000001

⇒ If a fuse is higher than required current rating is employed in a circuit, it will
blow more frequently since it carries more current
afford better protection to the circuit
seriously overload the circuit
lead to larger maintenance cost

⇒ The discone antenna is
a useful direction finding antenna
used as a radar receiving antenna
useful as a UHF receiving antenna
circular polarized like other circularly antenna

⇒ The image frequency of a superheterodyne receiver is
created within the receiver itself
not rejected by IF tuned circuits
independent of the frequency of tuning
due to insufficient adjacent channel rejection

⇒ Consider the equation s² + 2s + 2 + K(s + 2) = 0. Where do the roots of this equation break on the root loci plot?
-3.414
-2.414
-1.414
-0.414

⇒ When the carrier is unmodulated, a certain transmitter radiates 9 kW when the carrier is sinusoidally modulated the transmitter radiates 10.125 kW. The modulation index will be
0.1
10.15
0.4
0.5

⇒ A transistor with a = 0.9 and I_CBO = 10 μA is biased so that I_BQ = 90 μA. Then I_CQ will be
910 mA
5 mA
5.25 mA
4.95 mA

⇒ Consider the following statements

A 33 MHz 486 has higher MIPS than 33 MHz 386.
A 33 MHz 486 has higher MFLOPS than 33 MHz 386 of these statements.

Both are true
Both are false
1 is true and 2 is false
1 is false and 2 is true

⇒ It is required to increase the maximum range of a radar by a factor of two. The peak power transmitted in the radar system has to be increased by a factor of
2
4
8
16

⇒ Calculate the directivity of an antenna for θ_E = 30°, θ_H = 60
46
23
50
100

⇒ Two sinusoidal signals of same amplitude and frequencies 10 kHz and 10.1 kHz are added together. The combined signal is given to an ideal frequency detector. The output of the detector is
0.1 kHz sinusoidal
10.1 kHz sinusoidal
a linear function
a constant

⇒ A digital voltmeter can count from 0 to 9999. If full scale reading is 9.999 V, the resolution of full scale reading is
0.001
1000
2 digit
1 mV

⇒ An increase of reverse voltage decreases the junction capacitance.
TRUE
FALSE

⇒

Assertion (A): TTL uses multiple emitter transistor.

Reason (R): Multiple emitter transistors with about 60 emitters have been developed.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Silicon and germanium atoms combine orderly into array of atoms located in repetitive geometric pattern. This pattern is called
crystal
covalent bond
molecule
valence bond

⇒ A NAND gate has 3 inputs and one output. The number of thyristors required for this gate are
1
2
3
3 or 4

⇒ A series RC circuit has fixed X_C, and variable R. The current locus is in the first quadrant.
TRUE
FALSE

⇒ A series resonant circuit is capacitive at f = 150 Hz. The circuit will be inductive somewhere at
f greater than 150 Hz
f less than 150 Hz
f equal to 150 Hz by increasing the value of the resistance
none of the above

⇒

Assertion (A): A rectifier with inductor filter is more efficient for high load current.

Reason (R): In rectifier with inductor filter we can use a larger choke to reduce ripple, larger choke will have higher dc resistance which will result in lower dc output voltage for higher load current.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following logic family is fastest of all?
TTL
RTL
DCTL
ECL

⇒

Assertion (A): The capacitance of a reverse biased pin diode is lower than that of reverse biased p-n diode.

Reason (R): A PIN diode has an intrinsic layer between p and n regions.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A unipole is also known as
omnidirectional radiator
unidirectional radiator
line radiator
none of the above

⇒ A power transistor dissipates 5 W. If ambient temperature is 30° and case to air thermal resistance is 10° C/W, the case temperature is
80°C
20°C
32°C
305°C

⇒ Dynamic range of hi-fi system is at least
150 dB
120 dB
80 dB
40 dB