Question is ⇒ Hydrogen is used in, Options are ⇒ (A) large size transformers, (B) MCB, (C) large size generators, (D) circuit breakers, (E) , Leave your comments or Download question paper.

Question is ⇒ Hydrogen is used in, Options are ⇒ (A) large size transformers, (B) MCB, (C) large size generators, (D) circuit breakers, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Hydrogen is used in
A.	large size transformers [Wrong Answer]
B.	MCB [Wrong Answer]
C.	large size generators [Correct Answer]
D.	circuit breakers [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The number of select lines in a 16 : 1 multiplexer are
4
3
2
1

⇒ In a TWT the phase velocity of the axial component of the field on the slow wave structure is kept
equal to velocity of electron
slightly less than velocity of electron
slightly more than velocity of electron
equal to velocity of light in free space

⇒

Assertion (A): The propagation delay in ECL is minimum

Reason (R): Transistors used in ECL switch between active and cutoff regions.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The circuit of figure is ca
diode bias
current mirror
complementary mirror
none of the above

⇒ Polystyrene has a relative permittivity of 2.7. If the wave is incident at an angle θ_i of 30° from air into polystyrene, the angle of transmission will be nearly
0.2°
2°
18°
48°

⇒ Consider z transform of a signal as given b
IIR
FIR
Depends on value of n
Cannot determined

⇒ It is required to study transients during switching process. Which CRO should be preferred?
Ordinary CRO
Dual beam CRO
Dual trace CRO
Storage oscilloscope

⇒ A fully controlled bridge converter is feeding an RLE load. For some circuit conditions firing angle is 47°. If connections of battery are reversed, the firing angle is likely to be
47°
less than 47°
more than 47°
either more or less than 47°

⇒ The log magnitude curve of factor jω is a straight line having a slope of 20 dB/decade.
TRUE
FALSE

⇒ Which of the following is not valid integer variable in FORTRAN 77?
MBR
LOTS
JAMMU
BRG

⇒ A series LCR circuit consisting of R = 20 Ω, | X_L | = 20 Ω and | X_C | = 20 Ω, connected across an A.C. supply of 200 V rms. The rms voltage across the capacitor is
100 ∠ 45
400 ∠ -90°
400 ∠ +90°
100 ∠ -45

⇒ For a core having a relative permeability μ_r, magnetic dipole moment per unit volume M and field strength H, the flux density B is
B = μ_r (H + M)
B = μ₀ (H + M)
B = μ₀μ_r (H + M)
B = μ₀μ_r (H - M)

⇒ Which of the following refers to SSB suppressed carrier amplitude modulated system?
A3E
H3E
J3E
C3F

⇒ The forbidden energy gap between the valence band and conduction band will be least in case of
metals
semiconductors
insulators
all of the above

⇒ A collector collects
electrons from the base in case of N-P-N transistor
electrons from the emitter in case P-N-P transistor
holes from the base in case of N-P-N transistor
holes from the base in case of P-N-P transistor

⇒ In a good voltage amplifier, its input impedance
must be high compared to the resistance of the source
must be low compared to the resistance of the source
must be equal to the resistance of the source
must be half the resistance of the source

⇒ The sensitivity curve of a standard receiver is represente
curve A
curve B
curve C
curve D

⇒ A rectangular waveguide measures 3 x 4.5 cm internally and has a 10 GHz signal propagated in it. Calculate the guide wavelength for dominant mode.
13.5 m
3 m
88/3 m
3/88 m

⇒ If the functions w, x, y, z are as foll
w = z x = z
w = z, x = y
w = y
w = y = z

⇒ The waveshape of output voltage of half bridge inverter is
sinusoidal
square
triangular
either (a) or (b)

⇒ An end fire array consisting of several half-wave lengths of directive gain 40, then Find width of major lobe for broadside
6°
5.73
51.25
0°

⇒ In a full wave voltage doubler circuit, the input frequency is 560 Hz. The ripple frequency is
25 Hz
50 Hz
100 Hz
200 Hz

⇒ Figure represen
NPN transistor
PNP transistor
Zener diode
Power diode

⇒ Antiferromagnetic materials do not have permanent dipoles.
TRUE
FALSE

⇒

Assertion (A): For same drain current rating N-channel MOSFET occupies more area than p-channel MOSFET.

Reason (R): Electron mobility is much higher than hole mobility.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Armstrong FM transmitter uses
LC oscillator
crystal oscillator
RC oscillator
either (a) or (c)

⇒ The gain of collinear arrays is maximum when the spacing between the elements is
0.1 λ to 0.3 λ
0.3 λ to 0.9 λ
0.5 λ to 0.7 λ
0.7 λ to 0.9 λ

⇒ The gain of a current element is
0 dB
1.67 dB
1.76 dB
3 dB

⇒

Assertion (A): SSB and ISB receivers have good S/N ratio

Reason (R): SSB and ISB receivers have good suppression of adjacent channels.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ When electronic emission occurs due to bombardment of high velocity electrons on a metal surface, it is called secondary emission.
TRUE
FALSE