Question is ⇒ How many different BCD number can be stored in a register containing 12 switches using an 8, 4, 2, 1 code?, Options are ⇒ (A) 99, (B) 100, (C) 999, (D) 1000, (E) , Leave your comments or Download question paper.

Question is ⇒ How many different BCD number can be stored in a register containing 12 switches using an 8, 4, 2, 1 code?, Options are ⇒ (A) 99, (B) 100, (C) 999, (D) 1000, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	How many different BCD number can be stored in a register containing 12 switches using an 8, 4, 2, 1 code?
A.	99 [Wrong Answer]
B.	100 [Wrong Answer]
C.	999 [Wrong Answer]
D.	1000 [Correct Answer]
View Answer 1 -5 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The dc load current in a bridge rectifier circuit is 10 mA. The dc load current through each diode is
40 mA
20 mA
10 mA
5 mA

⇒ If load impedance Z_L >> Z₀, then
Z₀ = Z_L (VSWR)
Z_L = Z₀ (VSWR)
Z_L = Z₀ (VSWR - 1)
Z_L = Z₀ VSWR

⇒ SSB can be generated by
filter method
phase cancellation method
good attenuation characteristics
all of the above

⇒ In its lowest state, the electron is bound to the field of proton by an energy equal to
100.5 eV
51.2 eV
13.6 eV
0.2 eV

⇒ The current wave of figure, is passed through a 3 H inductor during the period 0 to 2 sec
is 3 V
is 6 V
increases from 0 at t = 0 to 6 V at t = 2 seconds
increases from 0 at t = 0 to 6 V at t = 2 seconds and then decreases

⇒ Which of the following is the main difference between waveguide and transmission line?
Waveguides cannot be coupled to coaxial lines
Waveguides have no standing wave ratio
Transmission line does not suffer from the effect of low cut off frequency
Waveguides are not distributed like transmission lines

⇒ The number of select lines in a 16 : 1 multiplexer are
4
3
2
1

⇒ In a turnstile antenna two-half wave resonant wire radiators are placed at 90° to each other in the same plane and are excited
in phase
in phase opposition
90° out of phase with each other
45° out of phase with each other

⇒ In a three phase series inverter, the firing frequency is
three times output frequency
six times output frequency
twice the output frequency
equal to output frequency

⇒

Assertion (A): A dual converter may be circulating current type or non circulating current type.

Reason (R): In circulating current dual converter only one converter can be operated at one time.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): An electronic tuner uses varactor diode

Reason (R): The capacitance of a varactor diode depends on the magnitude of reverse bias.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ For F₁ layer the maximum ionic density is 2.3 x 10⁴ electrons per cc. The critical frequency for this layer will be
1.36 MHz
13.6 MHz
136 MHz
1360 MHz

⇒ Resistivity of metals is expressed in terms of
μ ohm
μ ohm/cm
μ ohm-cm
μ ohm-cm/°C

⇒ Which of the following circuit does not need a coupling capacitor?
Resistance loaded
Transformer coupled
Impedance coupled
Single tuned

⇒

Assertion (A): Silicon is less sensitive to changes in temperature than germanium.

Reason (R): Cut in voltage in silicon is less than that in germanium.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following statement is false?
The gate of DMOSFET may be biased positively, zero or negatively
N-channel enhancement-only MOSFET conducts only when its gate is highly positive
JFET has lower input impedance than MOSFET
The bipolar base is forward biased, JFET gate must also be forward biased

⇒ Bus bars are always meant for very heavy currents.
TRUE
FALSE

⇒ Electronic tubes used for transmitter differ from their counterparts in the receivers in respect that
they are large in size
they are capable of handling large powers
they generate large amount of heat when in operation
none of the above

⇒ As compared to the number of network elements in Brune synthesis, the number of network elements Bott-and Duffin in realization is
more
less
equal
any of the above

⇒ An one sided abrupt junction has 10²¹/m³ of dopants on the lightly doped side, zero bias voltage and a built-in potential of 0.2 V. The depletion width of abrupt junction.(q = 1.6 x 10^-19 C, ε_r =16, ε₀ = 8.87 x 10^-12 F/m) is
0.036 nm
0.6 μm
3 mm
1.5 mm

⇒ The system in the given figur
type 0 system
type 1 system
type 2 system
type 3 system

⇒ Find the maximum power that can be delivered to a
0.025 W
2.5 W
2.5 W
0.25 W

⇒ The diameter and thickness of CD are
6 cm and 1.2 mm
6 cm and 0.6 mm
12 cm and 0.6 mm
12 cm and 1.2 mm

⇒ An impulse train is
a number of pulses
a number of pulses spaced from each other
a number of pulses all originating together
none of the above

⇒ The important postulate arising out of Maxwell's modification of Ampere's law is
a changing magnetic field produces an electric field
a changing electric field produces a magnetic field
a motional e.m.f. is produced by a coil moving in a magnetic field
a steady current produce a magnetic field

⇒ The most serious problems in ac bridge measurement is
eddy currents
leakage current
residual magnetism
stray fields

⇒ A 20 m antenna gives a certain uplink gain at frequencies of 4/6 GHz. For getting same gain in the 20/30 GHz band, antenna size required is metre.
100
4
1
10

⇒ The trigonometric Fourier series for the waveform f(t) shown below con
only cosine terms and zero value for the dc component
only cosine terms and a positive value for the dc component
only cosine terms and a negative value for the dc component
only sine terms and a negative for the dc component

⇒ What is the purpose of a start in RS232 serial communication protocol?
To synchronise receiver for receiving every byte
To synchronise receiver for receiving a sequence of byte
Acts as a parity bit
To synchronise receiver for receiving the last byte

⇒ The number of possible colours with a 4 line digital input monitor are
4
16
64
2