Question is ⇒ Hollow waveguides are used as transmission lines at frequencies, Options are ⇒ (A) above 1 GHz, (B) above 5 GHz, (C) above 10 MHz, (D) above 1 MHz, (E) , Leave your comments or Download question paper.

Question is ⇒ Hollow waveguides are used as transmission lines at frequencies, Options are ⇒ (A) above 1 GHz, (B) above 5 GHz, (C) above 10 MHz, (D) above 1 MHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Hollow waveguides are used as transmission lines at frequencies
A.	above 1 GHz [Wrong Answer]
B.	above 5 GHz [Correct Answer]
C.	above 10 MHz [Wrong Answer]
D.	above 1 MHz [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The circuit in the given figur
half adder
full adder
half subtractor
full subtractor

⇒ Internet is a worldwide network of computers where most of the information is freely available.
TRUE
FALSE

⇒ In the circuit of figure, the waveshape of load current when thyristor conducting
constant
increasing exponentially
decreasing exponentially
either (b) or (c)

⇒ Electric breakdown strength of a material depends on its
composition
moisture content
thickness
all of the above

⇒ In a transistor β_dc is likely to vary between 100 and 400. The proper value of β_dc to be used to located Q point is
100
400
250
200

⇒ The gauge factor of a semiconductor strain gauge is about
2
10
100
1000

⇒ If air pressure in a rectangular waveguide is increased the maximum power handling capacity
is decreased
is increased
remains the same
may increase or decrease depending on pressure

⇒ Generally op amp is used in
open loop
closed loop
cascaded loop
either (a) or (c)

⇒ Which one of the following can be used for amplification of microwave energy?
TWT
Magnetron
Reflex klystron
Gunn diode

⇒ Bellows converts
pressure difference into displacement
pressure difference into voltage
displacement into pressure difference
either (a) or (c)

⇒ For most static RAM the write pulse width should be at least
10 ns
60 ns
300 ns
1 μs

⇒ In a series regulated power supply circuit, the voltage gain A_v, of the 'pass' transistor satisfies the condition
A_v → ∞
1 << A_v < ∞
A_v ≈ 1
A_v << 1

⇒ The Laplace transform of a unit step function is
1
1 / s
s
1 / s²

⇒ An antenna couple is used due to all of the following reasons except
to prevent reradiation of the local oscillator
to discriminate against harmonics
to make the antenna look resistive
to provide the output amplifier with the correct load impedance

⇒ Which of the following flip-flop do not have race problem?
T flip-flop
D flip-flop
JK flip-flop
Master-slave flip-flop

⇒ Which of the following can provide a digital signal?
Slow change in the value of a resister
Sine wave
Square wave
Gradual turning of a potentiometer

⇒ The skin depth at 1000 MHz as compared to that at 500 MHz is
2
12
0.707
0.5

⇒ For type 2 system, the magnitude and phase angle of the term (jω)² in the denominator, at ω = 0, are respectively
0 and - 90°
0 and + 90°
infinity and - 180°
infinity and + 180°

⇒ The leads in a TRIAC are denoted by
anode cathode, gate
T₁ T₂, gate
T₁, T₂, anode
T₁, T₂, T₃

⇒ If there are no permanent dipoles in a dielectric material, the dielectric constant is independent of temperature.
TRUE
FALSE

⇒ Slotted line can be used for measurement of high frequencies
TRUE
FALSE

⇒ In figure gain bandwidth produc
200 Hz
200 MHz
200 kHz
2 MHz

⇒ Which of the following is best suited for parity checking and parity generation?
AND, OR, NOT gates
XOR, Exclusive NOR gate
NAND gates
NOR gates

⇒ A current increasing at the rate of 1 A/s is passed through 1 F capacitor. At t = 0, i = 0. The charge stored after 1 second is
0.5 C
1 C
2 C
4 C

⇒ In a half bridge inverter each thyristor is gated at a frequency f. The output frequency is
2 f
f
0.5 f
0.25 f

⇒ Consider the differential amplifier shown in figure. (Assume β is very hi
2 mA
1 mA
0.5 mA
3 mA

⇒ At very high temperatures the extrinsic semi conductors become intrinsic because
drive in diffusion of dopants and carriers
band to band transition dominants over impurity ionization
impurity ionization dominants over band to band transition
band to band transition is balanced by impurity ionization

⇒ A synchro transmitter receiver unit is a
two phase ac device
3 phase ac device
dc device
1 phase ac device

⇒ Dynamic memory cells are constructed using
FETs
MOSFETs
Transistors
Flip flops

⇒ The breakdown voltage in a zener diode
is almost constant
is very small
may destroy the diode
decreases with increase in current