Question is ⇒ Holes act like, Options are ⇒ (A) positive charges, (B) neutral atoms, (C) negative charges, (D) crystals, (E) , Leave your comments or Download question paper.

Question is ⇒ Holes act like, Options are ⇒ (A) positive charges, (B) neutral atoms, (C) negative charges, (D) crystals, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Holes act like
A.	positive charges [Correct Answer]
B.	neutral atoms [Wrong Answer]
C.	negative charges [Wrong Answer]
D.	crystals [Wrong Answer]
View Answer 2 -4 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The normalised form of 1.81 x 10^-11 is
18.1 x 10^-12
18.1 x 10^-13
0.181 x 10^-10
0.0181 x 10^-9

⇒ In figure, the switch is closed at t = 0. After some time i = 6A and rate of change of current was 4A/s. The value of inducto
1 H
1.5 H
indeterminate
0.5 H

⇒ In figure, the function of resistor
to reduce ripples in the output
to improve voltage regulation
to limit the surge current
either (a) or (c)

⇒ For a high pass filter attenuation = 0 at f = 0.
TRUE
FALSE

⇒ The inputs to a 4 channel MUX have the following bandwidths. Channel 1-50 Hz, channel 2-200 Hz. Channel 3-75 Hz. Channel 4-90 Hz. The theoretical minimum sampling rate of the MUX is
200 Hz
400 Hz
415 Hz
1600 Hz

⇒ A direct current can be measured
directly by dc potentiometer
by dc potentiometer in conjunction with a standard resistance
by dc potentiometer in conjunction with volt ratio box
none of the above

⇒ A fully controlled bridge converter can operate in quadrants
1
1 and 2
1 and 3
1 and 4

⇒ Which of the following is a digital modulation technique?
PCM
PSK
DM
All

⇒ In a resistive ac circuit, the current __________ the voltage by __________ .
lags, 90°
lags, 45°
lags, 0°
leads 90°

⇒ For maximum transfer of power, internal resistance of the source should be
equal to load resistance
less than the load resistance
greater than the load resistance
none of the above

⇒ As temperature increases
the forbidden energy gap in silicon and germanium increase
the forbidden energy gap in silicon and germanium decrease
the forbidden energy gap in silicon decreases while that in germanium decreases
the forbidden energy gap in silicon increases while that in germanium decreases

⇒ In a DM system, the granular noise occurs when modulating signal
decrease Rapidly
increase
has high frequency component
change within step size

⇒

Assertion (A): The impedance of a series resonant circuit is minimum at resonance.

Reason (R): Resonance condition implies unity power factor condition.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ For matrix A, A^-1 A = 1
TRUE
FALSE

⇒ In a waveguide if TE mode exist for z direction propagation, then
E_z = 0, H_z ≠ 0
E_z = 0, H_z = 0
E_z ≠ 0, H_z = 0
E_z ≠ 0, H_z ≠ 0

⇒ It is desired to display the digit 7 using a seven segment display. The LEDs to be turned on are
a, b, c
b, c, d
c, d, e
a, b, d

⇒ The effective refraction index of the ionosphere for radio wave is
more than unity
less than unity
equal to unity
either more or less than unity depending on the electron concentration

⇒ The circuit of figur
Precision integrator
Hartley oscillator
Butterworth high pass filter
Wien bridge oscillator

⇒ If the valence electron is separated from a copper atom, the remaining part of atom has a net charge of
1
-1
0
3

⇒

Assertion (A): The regular or irregular stacking of atoms has importanteffect on properties of materials.

Reason (R): The arrangement of atoms in a given material can be studied using X-rays.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A 10 bit D/A converter gives a maximum output of 10.23 V. The resolution is
10 mV
20 mV
15 mV
25 mV

⇒ Gain stability in an oscillator can bs achieved by
providing negative feedback
providing positive feedback
using low Q circuits
controlling the gain

⇒ A Karnaugh map with 4 variables has
2 cells
4 cells
8 cells
16 cells

⇒ The input gate current of a FET is
a few amperes
a few milli amperes
a few micro amperes
negligible

⇒ For pole-zero plot shown, the system is ________
minimum phase
maximum phase
mixed phase
none of these

⇒ In a NAND SR latch S = 0, R = 1 then
Q = 0
Q = 1, Q = 0
it is race condition
none of the above

⇒ The resistance of the aluminium conductor (r = 2.83 x 10^-8 Ωm) in figur
0.001 Ω
less than 0.001 Ω
more than 0.001 Ω
more than 0.002 Ω

⇒ The effective length of an 1/2 antenna (Given R_r = 73 Ω and (A_e)_max = 0.34λ² and η = 120p) is __________ .
0.6348 λ
0.5133 λ
0.1587 λ
0.3714 λ

⇒ State transition table and state transition diagram form part of design steps for
combinational circuits
sequential circuits
delay circuits
all of the above

⇒ In a practical current source, the load current
is always equal to source current
is always less than source current
is always equal to or less than source current
cannot be higher than source current