Question is ⇒ High frequency oscillations can be caused by, Options are ⇒ (A) electric coupling, (B) magnetic coupling, (C) ground loop, (D) all of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ High frequency oscillations can be caused by, Options are ⇒ (A) electric coupling, (B) magnetic coupling, (C) ground loop, (D) all of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	High frequency oscillations can be caused by
A.	electric coupling [Wrong Answer]
B.	magnetic coupling [Wrong Answer]
C.	ground loop [Wrong Answer]
D.	all of the above [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following statement in Fortran 77 3 values would be read and stored in X (0), X (1), X (2)
4 values would be read and stored in X (0), X (1), X (2), X (3)
5 values would be read and stored in X (0), X (1), X (2), (3)(4)
5 values would be read and stored in X (I), X (2), X (3), X (4), X (5)

⇒ In a full bridge circuit supplying an RLC under damped circuit
the waveshapes of output voltage and load current are square
the waveshapes of output voltage and load current are sinusoidal
the waveshapes of output voltage is square but the waveshape of load current is nearly sinusoidal
none of the above

⇒ For the circuit of figure the input and output Miller resistances
5 kΩ each
1 ohm and 5 kΩ respectively
5 kΩ and 1 ohm respectively
1 ohm each

⇒ The SCR would be turned OFF by voltage reversal of applied anode-cathode ac supply of frequency of
30 kHz
15 kHz
5 kHz
20 kHz

⇒ Out of multiplexer and demultiplexer, which can be used as a logic function generator?
Multiplexer only
Demultiplexer only
Both
None

⇒ When an electron rises through a potential of 100 V it will acquired an energy of
100 eV
100 Joules
100 ergs
100 x 10^-6 Newtons

⇒ The density of dynamic RAM is
the same as static RAM
less than that of static RAM
more than that of static RAM
either equal or less than that of static RAM

⇒ Which of the following is equivalent to AND-OR realization?
NAND-NOR
NOR-NOR
NOR-NAND
NAND-NAND

⇒ The number of possible colours with a 4 line digital input monitor are
4
16
64
2

⇒ Equation x_l0 = 11001001₂ when solved for x gives the value of x as
8
111
152
201

⇒

Assertion (A): The maximum range of a radar is proportional to fourth root of the peak transmitted pulse power.

Reason (R): Radar signals are subjected twice to inverse square law.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A flip flop is a
combinational circuit
memory element
arithmetic element
memory or arithmetic element

⇒ In a turnstile antenna two-half wave resonant wire radiators are placed at 90° to each other in the same plane and are excited
in phase
in phase opposition
90° out of phase with each other
45° out of phase with each other

⇒ An electron for which l = 0 has zero orbital magnetic dipole moment.
TRUE
FALSE

⇒ A class D chopper
can operate in first quadrant only
can operate in second quadrant only
can operate in either first or fourth quadrant
can operate in all the quadrants

⇒ Out of modes TE₂₀ and TE₃₀ of propagation of electromagnetic engery
both have the same cutoff frequency
TE₂₀ has lower cut off frequency as compared to TE₃₀
TE₃₀ has lower cutoff frequency as compared to TE₂₀
either (a) or (c)

⇒ An op-amp has
low input and output impedance
low input impedance and high output impedance
low output impedance and high input impedance
high output impedance and high input impedance

⇒ If the sign bit of mantissa is 0 and the exponent is increased from a positive to a more negative number the result is
a larger floating point number
a smaller floating point number
either (a) or (b) depending on the actual number
a negative floating point number

⇒ In practical commercial AM system channel bandwidth is
150 kHz
100 kHz
15 kHz
200 kHz

⇒ In the graphical analysis of CE amplifier circuit, the upper end of load line is called
saturation point
cut off point
Q point
none of the above

⇒ Which of the following is not considered as a useful quantity in comparing noise performance of receivers?
Noise temperature
Noise figure
Noise resistance
Input noise voltage

⇒ In case of frequency modulation, modulating voltage remains constant if the modulating frequency is lowered, then
amplitude of distant sidebands decreases
amplitude of distant sidebands increases
amplitude of distant sidebands remains constant
amplitude of distant sidebands first increases, then decreases

⇒

Match the following:

	List I		List II
A.	Ring modulator	1.	Clock recovery
B.	VCO	2.	Demodulation of FM
C.	Foster Seeley discriminator	3.	Frequency conversion
D.	Mixer	4.	Summing of two points
		5.	Generation of FM
		6.	Generation of DSB-SC

A-1, B-3, C-2, D-4
A-6, B-5, C-2, D-3
A-6, B-1, C-3, D-2
A-5, B-6, C-1, D-3

⇒ If the average power of radar transmitters is 2 kW and the peak power of the transmitter is 1000 kW, what will be the duty cycle?
0.002
0.02
0.001
0.01

⇒ An electric heater is controlled by thyristors through on-off control. If a = 0.4, the heating is
16% maximum
40% of maximum
60% of maximum
84% of maximum

⇒ Which pair is correctly matched?
Symmetrical two port AD - BC = 1
Reciprocal two port z₁₁ = z₁₂
Inverse hybrid parameter A, B, C, D
hybrid parameter (V₁, I₂) = f(I₁, V₂)

⇒ In figure the cut in voltage of diode is 0.7 V and its bulk resistance is 20 Ω. The peak value of circuit current of during positive and negative half cycles
10 mA and zero
9.12 mA and zero
9.3 mA and zero
zero and 9.12 mA

⇒ Which of the following are difficult to be fabricated in a monolithic IC?
Inductors
Large capacitors
Small capacitors
Both (a) and (b)

⇒ If N bits are lumped together to get an N-bit symbol, the possible number of symbols is
2^N
2^{N - 1}
2^{N - 2}
2^{N - 4}

⇒ In a television camera tube, scanning of a picture is done
line by line from left to right
line by line from right to left
line by line from top to bottom
line by line from bottom to top